Coleman 9232-107 User's Manual
Contents
1. ie DUAL OVERFLY XL 10 x7 Instructions apply to Part Number 9232 107 When You Are Ready To Set Up Your Tent Select a level campsite clear of rocks branches and other hard or sharp objects Do not set up your tent under trees For best results in windy conditions position the end of tent into the wind Main Tent Poles for 10x7 Dome Tents Black Part No 9230 320 Rainfly Poles for 10x7 Dome Tents Black Part No 9232 322 Rainfly 10x7 Dome Tents Part No 9238 328 Center Ridge Pole Connecting Room Gray Part No 9232 324 Side Pole Connecting Room Black Part No 9232 326 Assembled black main tent poles inserted through pole sleeves 1 Layout amp Positioning of Tent Pole Assembly Layout and position tents where desired with doors facing each other Allow aproximately 6 between them illus 1 Unzip doors Partially stake down the tents using the rings of the pin amp ring system at the corners of the tent Keep the floor taut illus 2 Do not fully stake down you may need to make adjustment s later Assemble main tent poles black by interlocking shock corded poles This will make two long poles for each tent Insert the poles diagonally into pole sleeves The center of the poles should cross forming an X in the middle of tent illus 1 illus 2 Tent stake through ring on stake loop illus 1 Tents positioned with poles2. may render the flame resistant properties ineffective THE COLEMAN CO INC 3600 N Hydraulic Wichita Kansas 67219 1 800 835 3278 www coleman com MADE IN THAILAND
3. through poles sleeves Connect Frame to Tent Insert one end of main tent pole onto pin of pin amp ring system at tent corner illus 3 illus 4 Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole A Assembled Repeat for second pole illus 3 illus 4 tenits without Repeat for second tent illus 4 rainflys Attach Tent to Frame Using Frame Clips Attach frame clips along the edges of tent to illus 3 frame poles illus 3 illus 5 illus 4 illus 5 Make any adjustments to the tent corner Insert pin into Frame clips stakes that are needed pole end Attach Tent Rainflys Assemble tent rainfly poles by interlocking shock corded pole Insert rainfly pole into the pole pocket located at the center edges of the underside of rainfly illus 6 illus 7 Drape rainfly over tent frame pole side down Rainfly pole should be over door and rear window NOTE The toggles on the rainfly need to run from the front corners to the top of the tent Connect the four elastic loops with hooks found at the rainfly corners to the fabric loops on the bottom row of frame clips Secure rainfly with attachments located on underside of fly illus 7 Repeat for second tent Connecting Room Layout connecting room and assemble center ridge and side poles Insert the ce
4. conditions cold weather high humidity etc condensation will form on the inside surfaces of your tent Condensation is caused by water vapor from your breath perspiration or any wet clothing inside your tent It is NOT LEAKAGE through the tent fabric It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent e Never store tent even for a short period of time without drying it thoroughly and brushing off caked dirt Do not pack stakes or poles inside your tent Use a separate storage bag STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE Seam sealer has not been provided with your tent For additional protection we recommend seam sealing your tent prior to camping Seam sealer may be purchased through your local retailer or at your local sporting goods store PRINTED IN THAILAND rev 10 04 Do not leave your tent set up for weeks at a time be aware that expo sure to the ultraviolet rays of the sun can seriously damage material and or cause it to become discolored WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC This tent meets the flammability requirements of CPAI 84 The fabric will burn if left in continuous con tact with any flame source The application of any foreign substance to the tent fabric
5. nter ridge pole gray through ridge pole sleeves and insert the pole ends into the pole pockets illus 9 Insert the side poles through the pole sleeves on connecting room illus 9 Position connecting room between tents pole side up Insert one end of side pole onto pin of pin amp ring system on the stability strap illus 3 Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole Repeat for second pole illus 9 illus 10 Move tent as needed for better fit with connecting room Fully stake down tents Attach connecting room to the tents with toggles amp loops on rainfly and hooking the stake loop ring at the tent corners illus 10 Stake out the tents with 2 side guylines each and the connecting room with 4 guylines illus 8 illus 7 Both tents fully assembled wit illus 6 Insert rainfly pole piece into pockets on underside of rainfly Underside of rainfly attaches to tent frame illus 8 Hooks attaches to rainflys fabric loop Center ridge pole sleeves Pole pocket illus 9 Connecting room with center ridge pole and side poles in position Toggles amp Loops secure connecting room to tents Coleman Stability Guylines strap illus 10 Both tents and connecting room completed Things You Should Know Under certain
Download Pdf Manuals
Related Search