Coleman 9161-121 User's Manual
Contents
1. Cn VELA 12 x11 Instructions apply to Part Number 9161 121 When You Are Ready To Set POLE ASSEMBLY PARTS Up Your Tent Select a level campsite clear of rocks branches and other hard or sharp objects Do not set up your tent under trees 1 Rainfly Part No 9161 1031 For best results in windy conditions Pole do not position the door of tent into the wind 2 Main Tent Part No 9161 1021 Poles Rainfly Part No 9161 1041 Layout amp Positioning Connect Frame to Tent of Tent Pole Assembly Insert one end of main tent pole onto pin of pin amp ring system at tent 7 reese a e ita ae P corner illus 3 B ei ee ed direction illus 1 Go to opposite end of pole and f gradually apply pressure to the pole 7 Sake down tent Using ane angs ot ne forming an arch until you are able to pin amp ring system at the corners of the insert the pin into the pole tent Keep the floor taut illus 2 Repeat for second pole illus 4 Assemble frame poles by interlocking shock corded poles This will make two long poles Insert the poles diagonally into pole sleeves The center of the poles should cross forming an X in the middle of tent illus 1 Assembled poles inserted through pole illus 4 sleeves Tent frame set up illus 3 Insert pole end onto pin amp ring illus 2 Tent stake through ring Attach Tent to Frame Using Frame2. NOT LEAKAGE through the tent fabric It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent Never store tent even for a short period of time without drying it thoroughly and brushing off caked dirt Do not pack stakes or poles inside your tent Use a separate storage bag STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE Do not leave your tent set up for weeks at a time be aware that exposure to the ultraviolet rays of the sun can seriously damage material and or cause it to become discolored PRINTED IN CHINA REV 10 06 AWAY FROM THIS TENT FABRIC This tent meets the flammability requirements of CPAI 84 The fabric will burn if left in continuous contact with any flame source The application of any foreign substance to the tent fabric may render the flame resistant properties ineffective THE COLEMAN CO INC 3600 N Hydraulic e Wichita Kansas 67219 1 800 835 3278 www coleman com MADE IN CHINA
3. Clips Attach frame clips along the edges of tent to frame poles illus 5 illus 6 Make any adjustments to the tent corner stakes that are needed Assembled tent without rainfly a a Frame clips illus 6 Attach Rainfly Assemble rainfly pole by interlocking shock corded pole Insert rainfly pole into reinforced pockets located at the center edges of the underside of rainfly illus 7 illus 8 Attach underside of rainfly to the rainfly pole illus 8 Drape rainfly over tent frame pole side down Rainfly pole should point out over door and rear window Connect the four elastic loops with S hooks found at the rainfly corners to the rings at the tent corners Secure rainfly with attachments located on underside of fly illus 9 Stake out the tent with 6 guylines 4 illus 7 Insert rainfly pole piece into pocket on underside of rainfly Pole attachments illus 8 Rainfly pole pockets Underside of rainfly attaches to frame poles illus 9 li illus 9 S Stake down doormat a Completed tent with rainfly Things You Should Know WARNING KEEP ALL FLAME AND HEAT SOURCES Under certain conditions cold weather high humidity etc condensation will form on the inside surfaces of your tent Condensation is caused by water vapor from your breath perspiration or any wet clothing inside your tent It is
Download Pdf Manuals
Related Search