Chauvet YA-145 User's Manual
Contents
1. the diagram fig 1 Only use the appropriately rated lamps as use of any other lamp type may cause the unit to be non operational Finally before switching on check that the lamp is housed correctly in the lamp holder and that the lamp replacement cover has been screwed back into place If after replacement of the lamp the unit is still not working then please contact CHAUVET for servicing Cleaning The most important part of your lighting effect to keep clean is the colored dome and the reflector dish as they allow the light output to transmit These should be cleaned with a soft damp cloth The body of the unit may also be cleaned in the same way We recommend internal cleaning be carried out by a fully qualified technician Maintenance amp Servicing Work on internal parts should be carried out by a qualified technician Removal of any covers other than the lamp replacement access is considered a breach of warranty and will not be covered under any such agreement unless authorized first by CHAUVET Troubleshooting e If the unit is not functional check main power supply is on e If the unit is functional but lamp does not light lamp may require replacing If after trying this solution you still have a problem contact CHAUVET Caution No user serviceable parts inside please refer to CHAUVET for service Power Connections The unit is supplied with a power plug appropriate to its voltage and destination Should an2. HAVET Police Beacon YA 145 B R G Y Users Guide Please read these instructions carefully before use Word wide Headquarters 3000 North 29 Ct Hollywood Horida USA FL 33020 Tel 1 954 929 1115 Fax 1 954 929 5560 www C hauvetlighting com Lamp Replacement Cover ____ Available in Red Yellow Blue amp Green Mounting Base gt Introduction Congratulations on the purchase of your new CHAUVET lighting effect We are confident you will enjoy many trouble free hours with this unit To assist with the care and use of the product we have prepared this short guide Operation This lighting effect has been designed to function on a mains power supply of either 120V 60Hz or 230V 50Hz and has been fitted with a suitable power plug for use with your local voltage Check the label on the unit and the power plug for the correct voltage When connected to the mains power supply the bulb should illuminate and the reflector dish should rotate The duty cycle for this effect should be no more than 15 minutes on then 15 minutes off Replacing Lamps 1 Disconnect from main power supply before attempting to replace_lamp 2 Ensure that the unit is sufficiently cool before removing blown lamp 3 Never touch new lamps with your fingers use a tissue or a Cloth In order to replace the lamp disconnect from main power supply first and unscrew the set screws to remove the lamp replacement cover which is highlighted on
3. y other connections be required they must be carried out with the following configuration Earth Green Yellow cable Neutral Blue cable Live Brown cable In the USA amp Europe it is required that all plugs are 3 pin type i e with Earth Ground connection In the UK it is required that all mains plugs are fitted with 5A fuses Technical Specifications Power 120V 60Hz AC 230V 50Hz AC P 1x 120V 25W pi 1 x 230V 25W Part No 83909 Part No 83909 Dimensions p 184 x 178mm 7 25in x 7in Weight 1 14kg 2 5lbs User Information Please complete for your records Date Purchased Serial No Dealer Stamp Model YA 145 POLICE BEACON
Download Pdf Manuals
Related Search