Chamberlain 373W User's Manual
Contents
1. the opener lights flash release all buttons Test by pressing the remote push button The opener lights should turn on or off but the door should not move FOR SERVICE DIAL OUR TOLL FREE NUMBER US 1 800 528 2817 CANADA 1 800 654 4736 4 amp WARNING To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door e ALWAYS keep remote controls out of reach of children NEVER permit children to operate or play with remote control transmitters e Activate gate or door ONLY when it can be seen clearly is properly adjusted and there are no obstructions to door travel e ALWAYS keep gate or garage door in sight until completely closed NEVER permit anyone to cross path of moving gate or door Open Close Stop Operation NOTE Not available with universal receiver Your 315 MHz Security remote control can be programmed to operate one door using all 3 buttons the large button will only open the door the middle button will close the door and the third button will stop the door s movement You may set up this feature as follows 1 With the door closed press and hold the large remote push button Open 2 Press and hold the Lock button on the Oe es door control 3 Press and hold the door control push bar When the opener lights flash release all buttons Test by pressing the large Open button on the remote The door should open Press it again while the door is open and nothing should happen2. CHAMBERLAIN LiftMaster Models 373W 315 MHz Security 3 Button Remote Control OWNER S MANUAL Only for use with 315 MHz Security garage door openers and universal receivers that have a purple learn button Instructions are Described and Illustrated Below 1 Press and release the learn button on the motor unit The learn indicator light will glow steadily for 30 seconds 2 Within 30 seconds press and hold the button on the hand held remote a po s To Erase All Codes From Motor Unit Memory 3 Release the button when the motor unit light blinks It has learned the code If light bulbs are not installed two clicks will be heard To deactivate any unwanted remote first erase all codes Press and hold the learn button on motor unit until the learn indicator light goes out approximately 6 seconds All previous codes are now erased Reprogram each remote or keyless entry you wish to use To Control the Opener Lights NOTE Not available with universal receiver With 315 MHz Security remote control a remote push button can be programmed to operate the opener lights without opening the door 1 With the door closed press and hold the remote button that you want to control the light 2 Press and hold the Light button on the door control 3 Press and hold the Lock button on the door control 4 After
3. Press the middle Close button while the door is moving and it should close Press the third Stop button and the door should stop immediately The Remote Control Batteries 4 amp WARNING To prevent possible SERIOUS INJURY or DEATH e NEVER allow small children near batteries e lf battery is swallowed immediately notify doctor The lithium batteries should produce power for up to 5 years To replace Battery pry open case with visor clip or Gp positive screwdriver as shown Insert side up batteries positive side up Dispose of old batteries properly NOTICE To comply with FCC and or Industry Canada IC rules adjustment or modifications of this receiver and or transmitter are prohibited except for changing the code setting or replacing the battery THERE ARE NO OTHER USER SERVICEABLE PARTS Tested to Comply with FCC Standards FOR HOME OR OFFICE USE Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation Replacement Parts Visor CIID sineret annene hed aye ae beta ceed 29B137 2006 Chamberlain Group Inc 114A3095B All Rights Reserved
Download Pdf Manuals
Related Search