Casio 5268 User's Manual
Contents
1. MA1111 EA Operation Guide 5268 CASIO e Your watch may differ somewhat from the one shown in the illustration Hour hand Minute hand First click Setting Day gt Second click Setting Time Crown Normal position Second hand To set the day 1 Pull the crown out to the first click 2 Set the day by rotating the crown 3 Push the crown back in to the normal position To set the time 1 When the second hand is at 12 o clock pull out the crown to the second click to stop it Set the hands by rotating the crown Rotate the crown to move the hands clockwise Move the minute hand four or five minutes past the time you want to set and then back it up to the proper setting Push the crown back in to the normal position to restart timekeeping e Avoid changing the date setting while the current time is between 9 00 p m and 3 00 a m Using the Stopwatch Stopwatch minute hand Stopwatch 1 20 second hand This hand rotates and indicates the second count during the first 30 seconds The stopwatch lets you measure elapsed time up to 59 minutes 59 95 seconds To measure elapsed time 1 Press to start the stopwatch 2 Press to stop the stopwatch e You can resume the measurement operation by pressing again e The 1 20 second hand stops moving after the first 30 seconds but timing continues internally The 1 20 second hand will move to the current timing value when the s2. ote that pulling the crown out also stops the timekeeping second hand After performing the above procedure you should also adjust the timekeeping setting E For a watch with an elapsed time bezel Rotate the elapsed time bezel to align the 7 mark with the minute hand After certain amount of time elapsed read the graduation on the elapsed time bezel which the minute hand points to The elapsed time is indicated lock crown e Some water resistant models are equipped with a screw e With such models you must unscrew the crown in the direction noted in the illustration to loosen it before you can pull it out Do not pull too forcibly on such crowns Also note that such watches are not water resistant while their crowns are loosened Be sure to screw the crowns back in as far as they will go after making any setting Specifications Accuracy at normal temperature 20 seconds a month Display 3 analog hands timekeeping hour and minutes stopwatch seconds 3 dials timekeeping seconds stopwatch minutes and 1 20 seconds day Stopwatch function Measuring capacity 59 59 95 Measuring unit 1 20 second Measuring mode Elapsed time Battery One silver oxide battery Type SR927W Approximately 3 years on type SR927W assuming one stopwatch operation 60 min day
3. topwatch is stopped 3 Check the elapsed time e The example below shows an elapsed time of two minutes 24 15 seconds Stopwatch minute hand 2 minutes Q e Press to reset the stopwatch This will enter the Timekeeping Mode Notes RE oprich second hand 4 24 seconds e Do not try to perform stopwatch operations while the crown is pulled out either to the first or second click If you try to press a button you might accidentally cause the crown to rotate and change the current time or day setting e If the starting positions of the stopwatch second hand and 1 20 second hand become misaligned use the following procedures to adjust the positions of the hands so they point to 12 o clock when the stopwatch is reset To adjust the positions of the stopwatch hands 1 Press 8 to reset the stopwatch and check the stopwatch second hand 1 20 second hand and minute hand They all should be at 12 o clock 2 To adjust the hands pull out the crown to the second click 3 Press to move the stopwatch second hand to 12 o clock e Holding down will move the second hand at high speed until you release the button 4 Press 8 to move the stopwatch 1 20 second hand to 12 o clock e Holding down will move the 1 20 second hand at high speed until you release the button 5 After making the adjustments you want push the crown back in to its normal position 6 Press to reset the stopwatch minute hand e N
Download Pdf Manuals
Related Search