Carcomm CHFS-33 User's Manual
Contents
1. Hands Free DSP PDA Carkit CHFS 33 HTC Sonata Qtek 8020 O2 XDA Phone Introduction This installation manual has been prepared to provide the basic information needed to install the Hands Free Carkit This manual is not intended to be definitive because there are different models and types of vehicles which will require different installation work The information given is for general guidance only The terms of warranty demand that this Hands Free Carkit set is installed by an experienced installer An end user should never attempt to install this Hands Free Carkit without professional assistance as the installation requires special tools and knowledge Note Thoroughly read the manual before beginning the installation procedure WARNINGS 1 Ensure that the vehicle s battery is disconnected before you start the installation procedure and that it remains disconnected during the procedure 2 Do not smoke or use open flames when working near the vehicle s fuel system 3 Ensure that the vehicle s electrical cables hydraulic lines fuel lines and safety equipment are not damaged during the installation 4 Ensure that normal control and operation of the vehicle is not impaired by the installation particularly the brakes and steering Ensure that airbag operation is not obstructed Compatible devices 5 Electronic and other sophisticated systems for example speed control ABS anti lock brake fuel injection navigation and ai2. cuting an auto power off after the ignition key has been turned off The blue wire of the power cable is used for the ignition sense feature The blue wire is connected via a 2A fuse to a 12 volt supply that is controlled by the ignition key Do not connect it directly to the high voltage sections of the ignition circuit When the PDA is taken from the cradle Figure 1 the carkit will go in standby mode after a few minutes Radio Muting The Hands Free PDA Carkit offers a feature which can mute the car radio automatically during a phone call when playing audio or when a voice command is given by for example navigation software which is installed on your PDA To avoid interference the yellow wire is switched to the GND max 50mA which mutes the radio When installed with the power cable it is possible to take over the front left or front right speaker The yellow wire in the power cable needs to be plugged in the correct position of the vehicle s radio ISO connector which is installed in the vehicle Please check your vehicle s radio manual for the correct position To play the audio over the right left front car speaker please check table 1 how to connect the wiring The carkit is not suitable to use to play music on the frequency range is optimized for voice frequencies and the signal is coming from the carkit is a mono signal CIPC 14 HF Carkit Power Cable Wiring colors_ Vehicle s connections Molex pin Red Wire The positive v
3. oltage on the vehicle s ee powersuppy tusea ateo Black Wire The negative GND connection to the 2 es chassisoftnecar at Blue Wire The 12V Voltage controlled by the 13 vehicle s ignition key fused 2A 15 Yellow Wire Used for car radio muting Switched to GND 14 during a phone call or when the PDA produces a sound Grey Speaker FrontRight Ss 8 Table 1 Connecting a Carcomm Euro Navigator GPS Receiver optional The phones supported by this cradle only support Bluetooth GPS Receivers When installing a Bluetooth GPS Receiver please follow the instructions supplied with the product phone and software to set it up Connecting the Carcomm CIGM 918 Quad Band Inside Glass Antenna Optional Connect the FME Female plug from the CIGM 918 to the FME Female connector of the Smartphone cradle The Antenna should be mounted onto the vehicle s windscreen with the VHB tape inside the vehicle Remarks In vehicle s with UV heat protected windows the GPS reception can be influenced and decreased Communication settings of the PDA should be set to Serial on COM1 The keypad sound should be disabled to avoid unnecessary muting of the vehicle s radio The Qvality Line www carcomm nl
4. or operating the vehicle in any way For easy installation there is a Carcomm car specific Safety Mount available separately This allows you to mount the cradle onto your dashboard without damaging it Some drilling can be neccessary to mount the cradle onto the Safety Mount You can use the pattern to the right to see hole positions The microphone should be installed as close to the driver s mouth as possible and attached to a surface that is mechanically quiet The microphone should be mounted at least 1 meter from the speaker to avoid acoustic feedback Safety Mount pattern Copyright Carcomm International BV 2006 Subject to change without previous notice All used brandnames are owned by their respective owners The Cvality Line www carcomm nl Hands Free DSP PDA Carkit CHFS 33 HTC Sonata Qtek 8020 O2 XDA Phone Se Oa IRS To position the microphone in an optimal position please check Figure 1 The carkit s main unit which contains the Digital Signal Processor should be mounted in a dry place away from the car s heating system Make sure that the cables are routed as far away as possible from the vehicle s electronic systems This is to prevent interference Also ensure that the cables are not subjected to undue mechanical stress for example under seats or against sharp edges This carkit includes a Power Cable The ignition sense feature prevents your Hands Free Carkit Set from draining the vehicle s battery by exe
5. rbag systems are relatively immune to malfunction HTC Feeler Amadeus caused by nearby radio transmissions Should you experience false operation of these systems HTC Sonata Tornado Tempo or are in any doubt whatsoever as to their functionality please consult the vehicle s dealer O2 Xphone II Xphone lim 6 The Hands Free Carkit set is suitable for use only in vehicles with a 12V negative grounding O2 XDA Phone Use on other supply voltages or alternative polarity will damage the equipment T Mobile SDA SDA Music 7 The PDA should not be left switched on for extended periods without running the vehicle s engine T Mobile SDA II Failure to comply could drain the vehicle s battery arate S SPS Qtek 8020 8100 8300 Contents of the Hands Free PDA Carkit set Vodafone VDA Handsfree DSP Unit PDA Cradle Rotating Swivel Microphone CHCM 14 Powercable CIPC 14 Screw Sets Optional Carcomm ENAV GPS Receiver Speaker CHCS 05 Gooseneck Microphone CHFM 14 ISO Power Cable CIPC 26 External Antenna Adaptor CPAA 03 Installation There are some important aspects that require special attention in positioning the carkits accessories The location of the PDA Cradle should be positioned so that the visibility of the PDA s display is good and the driver is not distracted The location of the PDA Cradle should allow the driver to easily reach the touchscreen Under no circumstances should the PDA Cradle prevent the driver from controlling
Download Pdf Manuals
Related Search