Canon imagePROGRAF W8400D Owner's Manual
Contents
1. initial installation 4 Close the top cover T 6 Tape each printer cover in the reverse order of tape removal during Setup T To remove the stacker apply the attachment procedure in reverse T 8 Apply the printer mounting procedure in reverse to unmount the printer T 9 Apply the stand assembly procedure in reverse to disassemble and pack the stand 20 Reattach the tapes and shipping materials to the roll holder and printer then pack them in the original shipping box This completes the preparation for moving the printer2. OK Yes Open RightCover is displayed 6 Open the back right cover Remove Ink Tank is displayed on the operation panel Open the ink tank cover then remove all the ink tanks Place each ink tank in a plastic bag and seal the bag A Note store the removed tanks with the ink supply ports facing up a lf the ink tanks are stored with the ink supply ports a facing down ink may leak out 8 Lock all of the ink tank covers then close the right cover Please Wait appears followed by Ink Draining while the ink is sucked from inside the tubes This process requires about 4 minutes to complete The printer switches off automatically once the process is complete 9 Disconnect the power cord earth wire and interface cable T O Open the top cover and then open the paper tray Ff hy 5 h p FM r i i mi I L be al i os a Do not touch any areas other than as indicated Doing so may damage the printer T T Rewind the roll media back onto the roll and remove the roll holder and the four overwind prevention stays and then remove the paper tray yp E i 4 _ a 2 Lower the holder stopper lever remove the stopper remove the roll from the roll holder then store the roll holder and the holder stopper 3 Clamp the belt with the belt stopper then use the hex screws to fasten the belt stopper Attach the belt stopper that you removed and stored during the
3. Moving the Printer Follow this procedure before moving the printer to protect the internal parts during moving or shipping Omm If you cannot avoid tilting or standing the printer on end when you are moving it please contact the dealer where you purchased the printer or the nearest service center Before you move the printer always execute the Move Printer menu function and follow the directions given by the messages on the display The printer may be damaged if you attempt to move it after disconnecting the power cord before switching off the printer If you accidentally disconnect the power cord before switching the printer off reattach the power cord reinstall the ink tanks then start the procedure again from Step 1 You cannot execute Move Printer once the MTCart Full Soon or Replace MT Cart appears Replace the maintenance cartridge before executing Move Printer Never tilt the printer while you are moving it This could spill ink from the maintenance cartridge and cause ink stains in the surrounding area T lf the printer power is off press the Power button to switch the printer On After a few moments Online appears in the display 2 Press the Online button to display MAIN MENU 3 Press 4 or P to select Maintenance then press MAIN MENU Maintenance 4 Press 4 or gt to select Move Printer then press Y Maintenance Move Printer ae 5 Press 4 or P to select Yes then press
Download Pdf Manuals
Related Search