BENDIX TCH-007-001 User's Manual
Contents
1. the sleeve in the fitting may result in the hose assembly not meeting the requirements of F M V S S 106 OLD SLEEVE DESIGN CORRECT ASSEMBLY Fig 4 Sleeve must be installed with short slots toward nut NEW DESIGN SLEEVE FIG 5 Must be installed with slots toward nut HOSE ASSEMBLY INSTRUCTIONS 1 Determine length of hose and cut to length 2 Place fitting body in soft jaw vice Install nut then sleeve on hose Refer to Fig 4 and 5 for correct position of sleeve 3 Slip hose on to barrel of fitting body and bottom 4 Run nut onto fitting body and tighten nut to 0 3 16 gap see Fig 6 Use wrench on body nut hex and hold hose when tightening being careful not to twist bend kink or collapse hose 0 3716 FIG 6 5 Repeat procedure on other end of hose HOSE ASSEMBLY WITHOUT SWIVEL END INSTALLATION INSTRUCTIONS NOTE It is recommended that in such installations where two 2 stationary components are to be connected by a hose assembly that a swivel type connector be used on one end However if a swivel connector is not available it is recommended that the following procedure be followed to eliminate twisting of hose 1 2 Install hose assembly into one component and tighten Use pipe sealer if desired Loosen hose nut on other end of hose assembly until hose is free to turn on barrel of fitting Install fitting body into component and tighten securely U2. TechnicalBulletin Bulletin No PRO 07 01 Effective Date 9 5 77 Cancels PRO 07 01 dated 11 10 76 Page 1 of 7 Subject OBSOLESCENCE 3 8 AND 7 16 1 D HOSE SHORT FITTINGS Effective October 1 1977 this will announce the obsolescence of the Short hose fitting Ref Fig 1 and nut Ref Fig 2 The Short sleeve will remain available under piece numbers 292615 for 3 8 I D hose and 292753 for 7 16 I D hose This will provide availability of the Short sleeves for use with the Short nuts in the field The Old design Long fitting body nut and sleeve again will be the standard H V S G hose fitting and will retain their previous piece numbers Old New reinstated obsolete effective effective 10 1 77 10 1 77 FIG 1 reinstated obsolete effective effective 10 1 77 10 1 77 FIG 2 OLD DESIGN Slots on both ends NEW DESIGN Slots on only one end Cc Dim n ola Reinstated effective Size 10 1 77 Obsolete available for service only after 10 1 77 INTERCHANGEABILITY Combinations of new and old design components can be intermixed except that the old design sleeve cannot be used with the new design nut FITTING ASSEMBLY INSTRUCTIONS It is important that both new and old design sleeve be assembled correctly While failure to install sleeves correctly does not present a safety problem incorrect installation of
3. se pipe sealer if desired To compensate for hose twist that will occur when hose nut is tightened twist the hose counterclockwise before tightening hose nut
Download Pdf Manuals
Related Search