BENDIX TCH-005-002 User's Manual
Contents
1. interference is in the adjusting arm area The ASA 1 and ASA 2 will fit on Mack single axles on trucks and truck tractors2. TechnicalBulletin Bulletin No PRO 05 02 Effective Date 7 20 77 Cancels N A Page 1 of 2 Subject ASA 1 AUTOMATIC SLACK ADJUSTER The ASA 1 Automatic Slack Adjuster continues to gain customer acceptance with sales maintaining a brisk pace With recent release of the 5 8 offset model for Wagner front brakes the ASA 2 will provide even more retrofit sales potential The primary purpose of this bulletin is to notify you of some important service information A Loose Linkage Nuts We have received some reports of loose linkage nuts where the linkage is fastened to the arm of the bell crank Because of the importance of this we request that you check all units in stock The procedure is short and simple and the procedure is as follows 1 2 A Ball Joint Stud Sox B 9 16 Nut 3 1 Place a 1 2 open end wrench or torque wrench with 12 crows foot on ball joint stud A 2 Place a 9 16 box or open end wrench on nut B 3 While holding the 9 16 nut B firmly tighten stud A 150 to 180 inch pounds torque Interference on Mack Tandem Axles The current ASA 1 and the forthcoming ASA 2 will not fit on Mack vehicles with the standard Mack 34 000 38 000 and 44 000 pound tandem axles because of interference It is important to note that the interference occurs only when the axles move through full travel and therefore the interference may not be obvious when the installation is made The
Download Pdf Manuals
Related Search