BENDIX BW2777 User's Manual
Contents
1. Installation and Davee ao Users Guide BW2768 formerly VODR 0038 included in this kit for complete installation and operation instructions 4 AME Fis Ignition Power Switched Power Run to Main Power Lead that feeds the Ignition Bus All system kits except for pre wire kits are supplied with a wiring harness for both the forward radar and the driver interface unit Each wire harness is designed to connect Forvard Looking Radar to the vehicle s ignition power circuit 2 and to the J1939 data link The vehicle s J1939 data link is used to provide communications between the forward radar engine and driver display Ground Run to Cab Ground Stud Engine ECM SONE TS Ignition Power Switched Power RED I itior jer Switch o Run to Main Power Lead that feeds the Ignition Bus To view or obtain the complete Ground VS 400 Installation Guide BW2772 Tenninalg Run to Cab Ground Stud l which includes mounting and alignment ct rae Toa i Ct re instructions for the forward looking a cI ma co radar visit the Bendix Literature press Center at www bendix com 901 Cleveland Street Elyria Ohio 44035 1 800 AIR BRAKE 1 800 247 2725 www bendix com BW2777 2010 Bendix Commercial Vehicle Systems LLC a member of the Knorr Bremse Group 5 10 All Rights Reserved2. n forward collision warning system Bendix VORAD VS 400 Collision Warning System Installation Notes Formerly L 2007 18 Bendix This Bendix VORAD VS 400 System Kit is designed to be installed in any commercial vehicle that is equipped with a 12 volt DC grounded chassis electrical system and an engine that supports SAE J1939 data link communications Kits that are configured for SmartCruise adaptive cruise control require an engine that supports and is enabled for adaptive cruise control Contact the engine OEM for more information about adaptive cruise control compatibility and engine settings The VS 400 system is comprised of a forward looking radar unit mounted on the forward most position of the vehicle typically on the front bumper and a driver interface unit that is located inside the vehicle on or in the dash of the cab For proper operation the forward radar must be centered on the front of the vehicle and aligned true to the vehicle s forward thrust angle This drawing and or technical information is the property of Bendix Commercial Vehicle Systems LLC Bendix CVS Bendix CVS claims proprietary rights to the materials disclosed hereon This drawing and or technical information is issued in confidence for engineering information only and may not be reproduced or used to manufacture anything shown or referred to hereon without direct written consent from Bendix CVS to the user Refer to the Bendix BackSpotter
Download Pdf Manuals
Related Search