Avaya 5W User's Manual
Contents
1. PEC Code 5328 005 COM Code 408186005 Model LUSWSAH 5W Self Amplified Horn Loudspeaker Lucent Technologies fe Labs Innowstior This horn loudspeaker is a one way Self contained amplified paging horn assembly that incorporates a 5 watt amplifier with a volume control This horn may be used to expand the capability of telephone systems in high noise areas and is suitable for interior as well as exterior paging applications Speaker Installation STEP 1 For easier installation remove the flange base from the speaker by unscrewing the wing nut while at the same time pressing inwardly on the wing nut see Figure 1 Place the flange flush with the mounting surface and mark the location of the three holes with either a marker or chisel It is important that the three holes be exact ly aligned with the flange otherwise you might stress the base or make the connection unsteady Insert 3 wall anchors see diagrams on backjfor drilling instructions and use of anchors Use appropriate hardware for your specific mounting surface STEP 2 After mounting the flange reattach the speaker to the flange and aim the speaker for the desired coverage A 450 downward angle is recommended but this may vary depending upon speaker layout Unless otherwise indicated do not aim speakers directly at each other or poor paging intelligibility may occur STEP 3 Remove the plastic cover to gain access to the volume control Using the table2. s 1 1 2 for each anchor and screw Fold and insert anchor in hole see Figure 1 Tap anchor until it is flush with the wall see Figure 2 Place speaker flange base over anchors Insert screws and tighten until flush with the mounting surface Do not over tighten Page 2 of 2
3. to the right and referring to Figure 2 below make the electrical connection The red and green wires are dry loop 600 ohm inputs Note Use 22 AWG shielded twisted pair on all wire runs COM Code 401882956 PEC Code 2734 SPK Use a separate cable for the power and signal connections Connect the shield of the signal cable to the ground of the audio source Do not connect the shield to the speaker the shield is only connected at one end STEP 4 Adjust the volume control to the desired setting Replace the plastic pro tective cover back over the exposed area Self Amolified Horn Loudspeaker CAUTION INDOOR USE ONLY A i lt Figure 2 Page 1 of 2 p LD W iring Chart Ground Telephone sale Rg 24V DC Power Supply use only terminals 1 amp 2 Issue 1 O ctober 1999 54 2002 01 Printed in USA 9910 1999 Bogen Communications Inc All rights reserved Specifications subject to change without notice Using Anchors with Hollow Walls Drill 5 16 diameter hole for each anchor and screw Fold and insert anchor in hole see Figure 1 Tap anchor until it is flush with the wall see Figure 2 Insert red key to pop anchor open behind wall see Figure 3 DO NOT HAMMER KEY Remove key Place speaker flange base over anchors Insert screws and tighten until flush with the mounting surface Do not over tighten Drill 5 16 diameter hole minimum hole depth for solid walls i
Download Pdf Manuals
Related Search