Audiovox EXPNAV2 Installation Manual
Contents
1. Vehicle Preparation and Protection CAUTION Do not touch the positive terminal with any tool when removing battery cables Be sure ignition key is in the OFF position during install Do not disconnect ANY airbag connectors or indicators Doing so may result in activating a diagnostic code These codes will require the dealer to perform the reset procedure and may be charged a dealer fee If you are unsure of any vehicle trim removal process consult the OEM service manual Removing vehicle trim panels in extreme hot and cold climate could result in some vehicle damage Use care when removing all vehicle trim Using tape on vehicle trim panels could help limit any scratches and or marring Use plastic trim panel removal tools whenever possible The instructions included in this kit are current at the time of printing It is designed as a guide to help make the installation of this product successful Always use caution and ask for assistance if you are not sure how to proceed Voxx International is not responsible for any damage that may occur during installation or any changes to the vehicle interior Components GPS Antenna HDMI DVI I a T harnesses USB AUX USB Ext Screws d IRA Interface Module Connection unit VHB Tape Installation Tools NOT INCLUDED I Screw driver components Pry Tool Towel Wiring diagram _ lt Install antenna in car GPS antenna installation 1 Fin2. MADN ENT EXPNAV2 Installation Instructions Ford Explorer Please read this manual thoroughly before installation This manual shows a typical installation Your vehicle may vary Use caution and if unsure seek proffesional assitance Warning Before head unit removing make sure ACC power is off Cover all surfaces with tape or plastic protection film to protect against scratching and damage Advent Voxx is in no way responsible for any damage incurred during installation This product has been validated in the vehicles listed on the application guide only Consult Technical support at 800 323 4815 if you have any questions Prior to Installation Care must be taken when installing this accessory to ensure damage does not occur to the vehicle The installation of this accessory should follow approved guidelines to ensure a quality installation Read entire instructions thoroughly before starting This document covers such items as e Vehicle Protection use of covers and blankets cleaning chemicals etc e Vehicle Disassembly Reassembly panel removal part storage etc e Electrical Component Disassembly Reassembly battery disconnection connector removal etc NOTES Removed Parts Inspect the vehicle for any damage Place all removed parts on a protected surface in an area where they will not be damaged Connectors When disconnecting connectors do not pull on the wires pull on the connectors
3. d a suitable mounting location Clean the area with alcohol and use a strong double sided tape to attache the antenna to the dash N 2 carefully route the antenna cable to the GPS Module Insure you do not interfere with any airbags or other saftey systems in the vehicle Do not pinch or pull on the antenna cable as this can damage it Installation of the GPS antenna inside the vehicle passenger compartment may interfere with reception If you must install it inside the vehicle insure it is not blocked by metal and has a clear view of the sky If reception is poor try another location Wiring diagram Map Not Used Card Not Used E O Rearview Camera Interface Module Audio Connection Connection GPS Antenna Vehicle harness from dash Audio Video Input Source Connect to vehicle dash controls Connect OEM SYNC Power Connect to Connection Sync Module 1 nn a CAUTIONI DO NOT TOUCH ON DISPLAY PANEL DUPUNO INSTALLATION TO BE AEMOVED UN CUSTOMER i C Y A 11 Remove the Sync Module from the rear of the panel 4 i Sor RIA io Use caut
4. ion Damaged or bent 12 Attach the connection unit connector pins will NOT be to the panel as shown covered under warranty 131 Secure with the screws provided in the kit A 141 Attach the Sync Module to the connection unit using the OEM screws 17 Find a suitable location for the HDMI and USB jacks These should be located together in order to use HDMI phone adapters Drill a 1 25 hole for each Insert from the front and route the usb cable to the Nav module location under the radio and Connect to the module Route the HDMI cable to the Sync Module location a 191 Connect all cables and 181 Attached the double attach to the underside of sided tape to the the radio chassis as module shown
Download Pdf Manuals
Related Search