Audiovox 50-0311x-015 Series User's Manual
Contents
1. INSTALLATION INSTRUCTIONS FOR 50 0311x 015 SERIES 1181337 GRAND CARAVAN OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM These instructions are intended for use only by experienced professionals in the automotive customizing business Special tools and equipment as well as specialized handling and care of product during installation may be required Before beginning this installation carefully read through the following instructions Use extreme care when cutting headliner material Check for wiring or other componentry above headliner material Cut only where indicated Materials Tools required for this installation 1 2 Phillips screwdriver 2 Powered screwdriver or drill with adapter 3 Awl or similar tool 4 Razor knife or similar 5 18 GA wire 4 6 6 Test light 7 Audiovox Series 640 650 Video Module NOT FOR VEHICLES EQUIPPED WITH SUN ROOF Nov 8 1999 INSTALLATION INSTRUCTION 44 0047A Printed in the U S A MATERIALS PROVIDED FOR INSTALLATION ITEM Description QTY 1 SCREW 8 X 9 16 PWH 4 2 SCREW 6 32 X 3 4 PPH 6 pum 3 WASHER 3 5 mm 4 3 4 SCREW 8 X 1 1 2 PWH 1 5 SCREW 6 X 1 2 PFH 2 6 MOUNTING BRACKET 1 7 CONSOLE fl g SPEAKER GRILLE 1 9 COVER PLATE 1 10 COVER PLATE DECAL fl Nov 8 1999 INSTALLATION INSTRUCTION 44 0047A Printed in the U S A I PREPARATION OF VEHICLE INTERIOR 1 Remove and retain 3 three screws which secure dome light in place See Figure 1 2 D2. isconnect wiring and lay light in a safe place FIGURE 1 3 Using O E console as a reference carefully measure and trim headliner as shown Caution Before cutting headliner material check for wiring or other componentry above headliner Cut only where indicated DO NOT OVERCUT HEADLINER Make sure that the 7 1 2 cutis centered left to right in vehicle See Figure 2 4 If speaker upgrade kit was purchased trim these locations See Figure 2 FIGURE 2 5 Construct a jumper harness that will connect the vehicle s dome light wires to the lights in video system Connect the white wire from video system to the O E pink blue wire Connect the black wire from video system to the chassis ground See Figure 3 6 Using a test light check function of lights 7 Install O E dome light in original manner PINK BLUE j FIGURE 3 8 Install and route all video and audio cables and any other added component requirements to their respective places in the vehicle Refer to component installation instructions for wiring diagrams The suggested routing of the video system cable is as follows Above the headliner from video system rearward to the C pillar Down the C pillar to the floor Route the power lead to a fused accessory controlled source Connect the ground lead to the vehicle chassis Route the remaining wiring RCA plugs Remote Sensor extension etc to the VCP location See Figure 4 Connect per instruction
3. or video system operations check For further assistance refer to the video system manual for the technical support phone number listed for your area FIGURE 7 Insert video system into opening in console Note Make sure wires do not get pinched between video system and console Align holes in housing with clips in mounting bracket Secure using 4 four 6 32 x 3 4 screws item 2 pg 2 and 4 four 3 5 mm washers item 3 pg 2 See Figure 7 Caution Do not overtighten screws Tighten screw previously installed to secure rear of console to headliner Caution Do not overtighten screws or damage to vehicle roof may occur Raise video screen into locked position Install speaker grille item 8 pg 2 Align clips in grille with holes in console and press firmly See Figure 8 If speaker upgrade kit was not installed install cover plate item 9 pg 2 at front of console and secure using 2 two 6 X 1 2 screws item 5 pg 2 Install cover plate decal item 10 pg FIGURE 8
4. s included with the video system If video system if to be used as a television install an appropriate antenna per instructions included with the antenna FIGURE 4 9 Install console mounting bracket item 6 pg 2 over O E bracket on roof brace Align bend in bracket with edge of O E brace Secure bracket using 4 four 8 x 9 16 screws item 1 pg 2 See Figure 5 FIGURE 5 If INSTALLATION OF CONSOLE IF SPEAKER UPGRADE KIT WAS PURCHASED INSTALL PER INSTRUCTIONS PROVIDED 10 Raise console item 7 pg 2 into approximate position against headliner Loosely install using 2 two 6 32 X 3 4 screws item 2 pg 2 through the smaller holes in bracket on console into threaded clips on mounting bracket See Fig 6 11 Using a scribe or similar tool align hole in rear of console with slot in mounting bracket Loosely secure rear of console using 1 8 X 1 1 2 screw item 4 pg 2 Make sure console is straight then tighten 2 two 6 32 screws previously installed See Figure 6 15 16 17 18 19 20 12 Release video screen from locked position Lower video screen to viewing position for access to mounting locations in top of video system housing 13 Raise video system into approximate position and connect all wiring to components Connect wiring and cabling to video system per instructions included with video system 14 Check function of all components and lights See operating instructions f
Download Pdf Manuals
Related Search