ATN NVG7 User's Manual
Contents
1. image intensifier tube assembly with an integrated high voltage power source and the battery housing Objective lens protective cover not shown is intended to protect the objective lens from dust and scratches It also will act as a daylight filter allowing you to test the scope in daylight or other bright light situations The pinhole in the center of the protective cover allows the user to check the operation ability of the device in daylight conditions NOTE Do not test the scope in daylight conditions even with the daylight filter lens cap on for more than ten 10 minutes OPERATION e Take the monocular out of the case e Install the battery into the housing with the polarity order as shown on the scope Battery Type 3 Volt Lithium CR123A e Press the button short press less than 1 5 sec to turn the unit on by the protective lens cover still attached to the lens Do not turn the unit on in the daytime without the protec tive lens cap on You should see green glow in the eyepiece e Observe the scene and adjust the diopter for optimal image clarity e You may now enter a dark environment or simply shut the lights off in order to darken the room e Next remove the lens cap daylight filter Adjust the front lens for the distance of the focus You should not have to readjust the diopter e To turn the unit off push the button again by short press less than 1 5 sec FOCUSING To focus the NVG 7 first you w2. foregoing warranty no other warranties written or oral statutory expressed or implied including any implied warranty of merchantability or fitness for a particular purpose shall apply to the product All such implied warranties are hereby and expressly disclaimed LIMITATION OF LIABILITY ATN will not be liable for any claims actions suits proceedings costs expenses damages or li abilities arising out of the use of this product Operation and use of the product are the sole respon sibility of the Customer ATN s sole undertaking is limited to providing the products and services outlined herein in accordance with the terms and conditions of this Agreement The provision of products sold and services performed by ATN to the Customer shall not be interpreted construed or regarded either expressly or implied as being for the benefit of or creating any obligation toward any third party of legal entity outside ATN and the Customer ATN s obligations under this Agree ment extend solely to the Customer ATN s liability hereunder for damages regardless of the form or action shall not exceed the fees or other charges paid to ATN by the customer or customer s dealer ATN shall not in any event be liable for special indirect incidental or consequential damages including but not limited to lost income lost revenue or lost profit whether such damages were foreseeable or not at the time of purchase and whether or not such damages
3. function by looking through it in a lit environment with the daylight filter lens cap on Never use in daylight without the daylight filter lens cap on e Never point the NVG 7 at a bright light source e Adverse atmospheric conditions such as fog smog or haze and a lack of ambient light moon or starlight may diminish the effective viewing distance TROUBLE SHOOTING Q Flashes flickers or clicking occur while operating S If it occurs within the first five minutes of inserting new batteries it is normal and the device will resume normal operation soon thereafter If it occurs for more than 10 minutes contact for service instructions Q Dark spots on screen S These are either cosmetic blemishes in the intensifier tube or dust particles Q Screen becomes darker than at previous use S Replace batteries If problem persists contact your dealer or other authorized service rep resentative for service instructions Q Image not clear S Adjust objective lens and or the eyepiece 2 YEAR PRODUCT WARRANTY This product is guaranteed to be free from manufacturing defects in material and workmanship under normal use for a period of 2 two years from the date of purchase In the event a defect that is covered by the foregoing warranty occurs during the applicable period stated above ATN at its option will either repair or replace the product and such action on the part of ATN shall be the full extent of ATN s liability an
4. ATN NVG 7 hn user s guide Export of night vision equip ment and optical sighting equip ment is controlled by the U S Department of State Office of Defense Trade Controls in accordance with International Traffic in Arms ITAR Title 22 Code of Federal Regulations Part 120 130and or the Export Admin AMERICAN istration Regulations EAR U S TECHNOLOGIES Department of Commerce Illegal NETWORK export of these commodities is strictly prohibited CORP One 1 5 volt 5 Diopter battery 1 to Infinity focus Single switch button operation Built in infra red illuminator 35mm F 1 1 2 lens for maximum clarity The information in this manual furnished for information use only is subject to change without notice is not to be construed as a commitment by ATN Corp ATN Corp assumes no responsibility or liability for any errors or inaccuracies that may appear in this book 2005 ATN Corp All right reserved FEATURES e High Quality 2 or 3 or 4 gen light intensifier tube e Super fast lens system provides the user with a clear and sharp image e Dual eye viewing system for long viewing sessions e Built in Infra Red illuminator lets you see even in total darkness e Interchangeble lenses for different magnification e Head or helmet mounted for hands free use e Rugged and versatile design e Easy to use digital controls e Two years warranty SPECIFICATIONS Ma
5. EAR 1 Fit the headgear to your head size Adjust the head gear fist before attaching the NVG 7 to it 2 Loosen all the straps and place the headgear onyour head 3 Tighten the straps until the headgear fits firmly GOOGLES INSTALLATION AND AJUSTMENT Now you are ready to mount the NVG 7 on to your headgear 1 Remove the already adjusted headgear from your head 2 Push button 1 and insert the bracket 2 of the NVG 7 to the rail of the headset 3 Place the headgear with NVG 7 onto your head 4 Loosen the screw 3 and move the unit along the rail for eye relief adjustment The NVG 7 headset has a flip up mechanism Push the button 4 on the side of mount and lift the unit up until the unit fixates in the top position Push same button to lower NVG 7 to viewing position If you need increase the eye relief of your goggles you can displace the bracket on the top of NVG 7 1 Unscrew the screw and detach the end cap from the bracket of NVG 7 2 Unscrew the 2 screws and detach the bracket from the NVG 7 body 3 Turn the bracket 180 degrees 4 Screw the 2 screws back into place HELMET MOUNT coptionat Helmet mount for attachment of ATN s NVG 7 to a standard PASGT helmet Helmet mount fits securely onto helmet via a rugged strapping device and grooved hooks With helmet mount NVG 7 can be positioned directly in front of user s eyes or flipped INSTALLATION 1 Install the mount onto helmet as shown
6. arise out of a breach of warranty a breach of agreement negligence Strict liability or any other theory of liability PRODUCT WARRANTY REGISTRATION In order to validate the warranty on your product ATN must receive a completed Product Warranty Registration Card for each unit Please complete the form below and immediately mail it to our Service Center ATN Corporation 20 South Linden Ave Suite 1B South San Francisco CA 94080 Products qualifying for warranty repair will be either repaired or replaced within 10 business days of receipt of merchandise unless the customer is notified otherwise OBTAINING WARRANTY SERVICE To obtain warranty service on your unit take or send the product postage paid with a copy of your sales receipt to our service center ATN Corporation at the address noted above All merchandise must be fully insured with the correct postage ATN will not be responsible for improper postage or missing or damaged merchandise during shipment For customer service and technical support please contact American Technologies Network Corp North American Office 20 S Linden Ave Suite 1B South San Francisco CA 94080 phone 800 910 2862 650 875 0130 fax 650 875 0129 European Office phone 44 0 870 0111286 fax 44 0 845 3349142 The following countries can use our toll free number 00 800 9102 8620 Austria France Germany Holland Italy Spain Sweden Switzerland www atncorp com 2005 ATN Corporation
7. d the Customer s sole and exclusive remedy This warranty does not cover a product a used in other than its normal and customary manner b subjected to misuse c subjected to alterations modifications or repairs by the Customer of by any party other than ATN without prior written consent of ATN d special order or close out merchandise or merchandise sold as is by either ATN or the ATN dealer or e merchandise that has been discontinued by the manufacturer and either parts or replacement units are not available due to reasons beyond the con trol of ATN ATN shall not be responsible for any defects or damage that in ATN s opinion is a result from the mishandling abuse misuse improper storage or improper operation including use in con junction with equipment which is electrically or mechanically incompatible with or of inferior quality to the product as well as failure to maintain the environmental conditions specified by the manufac turer CUSTOMER IS HEREBY NOTIFIED THAT OPERATION OF THE EQUIPMENT DURING DAYLIGHT HOURS OR UNDER ANY EXCESSIVE LIGHT CONDITIONS MAY PERMANENTLY DAMAGE THE INTERNAL COMPONENTS OF THE UNIT AND SAID DAMAGE WILL NOT BE COVERED UNDER THIS WARRANTY This warranty is extended only to the original purchaser Any breach of this warranty shall be waived unless the customer notifies ATN at the address noted below within the applicable warranty period The customer understands and agrees that except for the
8. gnifiCati N cies teen ctexesceaxaecedenanctccxademeuamenessences 1X 3X 5X optional Intensifier tube sisirin ninini Gen 2 or Gen 3 or Gen 4 Detection range risa ie coseswcscsuneenaeercesucieneanenenscests 150 Gen 2 or 200 Gen 3 or 300 Gen 4 m y Recognition range wie cecewsdeseucensearccsteicaxenenieen tees 100 Gen 2 or 180 Gen 3 or 225 Gen 4 m y Lens System scsicctecsencatvenedusndedmeceapenducsdemesinet tess 35 mm F1 1 2 Field Ol VICW vascxesencnesctextersenmcnastenctceransqsusaensaedss 40 Range of OCS os eres aesnacevemesnextensnenieencgedeeas 0 25m to co Power SUD DIY shedinedtaruseicceiacshunsskveeansheleusiatentans 3 volt lithium Battery Life secssssssa esnean n Eara raai 10 hours Operating TEMP sssini 30 F to 110 F PWNS AS ONS ssc cseeasscteteaeemenacenseesuevcesueeeaccaceaenesed 172x62x102 mm 6 7 x 2 5 x 4 WS TO eros sie EE 0 45kg 0 9 Ib APPLICATION Compact and lightweight rugged metal not plastic and a top notch performer the NVG 7 is an exceptional choice for hands free usage The NVG 7 goggles have a built in IR for total darkness with indicator ON light within the FOV and a flip up headset The NVG 7 is available with a wide range of image intensifier options to meet a wide array of specification requirements The NVG 7 night vision goggles is a complex opticoelectronic system for individual use The device consists of the objective lens assembly eyepiece and the body The body contains a
9. ill need to adjust the Diopter adjasting diopter Simply turn the diopter clockwise until it stops Then while looking throught the diopter at an object slowly turn the diopter back counter clock wise until the grain in the image is sharp NOTE We suggest that you focus the diopter during daylight with the filter on Next focus the front lens until the image and the grain are both sharp When you are in low light con ditions and the daylight filter is off you may focus the front lens to receive sharp image the diopter Lens focus should not be adjusted adjusting NOTE The front lens should be readjusted as you view objects at different distances INFRA RED ILLUMINATOR Infra red illuminators or IR illuminators are common to night vision The IR light greatly enhances the performance of the NVG 7 while remaining almost totally invisible to the naked eye The NVG 7 goggles have a built in IR with indicator ON light within the FOV To turn the IR on push the button by long press more than 1 5 sec It is important to remember that the IR illuminator is simply an infra red light source and like any light source it may loose its effectiveness over a great distance To turn the IR off push the button again by long press more than 1 5 sec Built in Infra red illuminators NOTE The IR will automatically turn off when the unit s power is tumed off FLIP UP HEADSET FITTING THE HEADG
10. on the picture 2 Tighten and fixate the straps 1 3 Attach goggles to the rail Push button 2 and insert the bracket of the NVG 7 to the rail of the mount 4 Place the helmet on your head ADJUSTMENT 1 Loosen the screw 3 and move the unit along the rail for eye relief adjustment Tighten the screw 3 2 Loosen the top vertical fixation screw 4 Adjust gog gle vertical position Tighten vertical position screw 3 The NVG 7 helmet mount has a flip up mechanism Push a button 5 on the side of mount and lift the unit up till fixation in the top position 3X AFOCAL LENS coptionat The NVG 7 with 3X or 5X front lens can be used as a powerful night vision bi ocular To install 3X Afocal Lens screw it on the front lens of NVG 7 To install 5X lens unscrew the objective lens of NVG 7 and screw F112 Lens to the free place make sure that the unit is 5X Lens 3X Lens turned off STORAGE AND CARE e If the device is not to be used for extended period of time more than 10 days remove the battery e Avoid touching lenses If fingerprints or traces of dirt or dust appear clean their surface with a Photographic lens cleaning tissue e Keep lens cap daylight filter on when not in use e The NVG 7 is not harmful to the user or the environment e Do not disassemble except to clean the front lens and eyepiece it will void your warranty e Evaluate the scope
Download Pdf Manuals
Related Search