ATD Tools ATD-3630 User's Manual
Contents
1. REPAIRABLE PARTS BREAKDOWN ATD 3630 DESCRIPTION GM CLUTCH PLATE REMOVER DELUXE A C CLUTCH HUB PULLER amp INSTALLER SANKYO CLUTCH PLATE PULLER WITH 3 BOLTS AND WASHER CLUTCH PLATE REMOVER 91000A PARTS DELUXE A C CLUTCH HUB PULLER amp INSTALLER REMOVING PROCEDURE 1 Remove shaft nut or retaining ring 2 Thread removing tool onto hub Position center screw against the end of compressor shaft 3 Hold body of remover with wrench and turn center screw into remover body to remove clutch hub assembly INSTALLING PROCEDURE 1 Ensure frictional surface of clutch plate and rotor is clean 2 Align shaft key with shaft keyway and place clutch plate and hub assembly on compressor shaft Do not drive or pound on clutch hub or shaft as this may cause internal damage to compressor 3 Attach installing tool onto compressor shaft Body of installing tool should be backed off sufficiently to allow center screw to be threaded fully onto end of compressor shaft 4 Hold center screw with wrench and tighten hex portion of installer to press hub onto shaft 5 Tighten body several turns until the air gap between the friction surfaces is 020 030 6 Remove installer and check for proper positioning of shaft key 7 Install shaft nut or retaining ring Refer to manufacturer specification for correct torque 8 Spin pulley by hand to check for free operation WARNING Puller parts can break under2. stress Be aware of hand positions e Wear safety goggles user and bystanders Read and follow instructions e Do not heat pullers Broken parts can cause injury e Do not over stress pullers Avoid contact with refrigerant Installer Remover Installer
Download Pdf Manuals
Related Search