ATD Tools ATD-500 User's Manual
Contents
1. ATD 500 500W Portable Quartz Halogen Flood Work Light Manufactured in China to ATD Tools Inc Specifications READ ALL INSTRUCTIONS BEFORE OPERATING Thank you for purchasing your ATD Halogen Light Before attempting to operate your new Halogen Light please read these instructions thoroughly You will need these instructions for the safety warnings precautions and assembly operation and maintenance procedures SAFETY e Before moving your halogen light or replacing a broken part always make sure that the cord is unplugged and that the light has cooled e This unit must not be immersed in water e Do not install this unit within six feet of combustible material The lamp housing can exceed temperatures of 230 F e Do not move your halogen light or replace bulbs or broken parts with wet hands or when standing on a wet or damp surface or in water Always make sure the power cord is unplugged before performing any maintenance e Do not use this lamp in hazardous locations such as flammable or explosive environments e Do not sit directly in front of this unit as the high operating temperatures can burn the skin e Do not look directly into the lamp when switched on as this can damage the eyes e f used with an extension cord always make sure that the extension cord is fully unwound e We recommend that a ground fault interrupter GFI is used with your ATD Halogen Light e Do not use this unit if it has a broken lens casin2. 8 PRT500 08 MOUNTING BRACKET
3. g or damaged power cord Bulb Replacement Adjusting your Lamp Unscrew the top screw in the lamp housing cover and install the halogen bulb as follows 1 Holding the bulb with a soft cloth carefully locate one end of the bulb into the ceramic mounting While pushing the end of the bulb against the metal pins gently slide the other end of the bulb into position in the other ceramic mounting until it is secure Do not use force when installing the bulb NOTE DO NOT TOUCH THE BULB WITH FINGERS this will cause damage If it has been touched wipe it carefully with a soft cloth dampened with methylated spirits 2 When the bulb is in position replace the lamp housing and firmly screw into place 3 To alter the angle of the lamp loosen the black knob on the front of the lamp move the lamp to the required angle then tighten the knob to hold the lamp securely Troubleshooting Symptom Possible Cause Corrective Action Lamp will not operate Bulb broken Replace bulb Poor contact between lamp and socket Check to see if lamp is securely installed into socket Improper wiring Have unit checked by a qualified electrician Incorrect voltage voltage at fixture too high low Have power supply checked by a qualified electrician ITEM ORDERING PART PART DESCRIPTION 1 PRT500 01 02 SWITCHWITHCOVER 4 PRT500 03 04 KNOB WITH ADJUSTING WASHER 6 PRT500 06 GUARD
Download Pdf Manuals
Related Search