AMX RDM-INC50 User's Manual
Contents
1. Bui EX IT S FOUR WORLD TAKE CONTROL The RDM INC50 Incandescent Dimmer Module is a standard 6000 W incandescent dimmer It can dim incandescent lights cold cathode neon transformers and two wire dimmable ballasts It is designed for use with the RDA series of enclosures in a AMX Lighting modular digital dimming system The RDM INC50 module s 120 240 and 277 VAC ratings are CE UL and C UL approved Mounting points Line in hot 500uS choke 50 A Power Device Low voltage control wiring 4 pin connector to AMX Lighting master controller FIG 1 RDM INC50 RDM INC50 UL and C UL Ratings e 120 VAC 6000 W e 240 277 VAC 6000 W Suggested Dimmed Loads e Incandescent e Low voltage e Neon cold cathode e Two wire phase controlled ballast Specifications e Dimensions HW 10 0 x 5 50 25 4 cm x 13 97 cm e Phase dependant e Use wires rated at 75 C 167 F e Torque terminals to 16 in lbs 1 84 N M e Max wire size 8 AWG 10 mm e Wire stripping length 0 28 7 mm e Weight 7 0 Ibs 3 175 kg e BTU hr 750 e Control current 45 mA 12 VDC e Occupies two enclosure spaces Caution Pre Installation Notes e All Class 1 wiring must be connected to proper terminals e All control wiring must be connected to proper terminals e Disconnect power while installing or connecting the unit e Keep top and bottom air vents clear at all times e Test loads for shorts before connec2. ng application cold cathode on off AMX Corporation reserves the right to alter specifications without notice at any time For full warranty information refer to the AMX Instruction Manual s associated with your Product s 043 019 2247 8 01 2001 AMX Corporation All rights reserved The AMX logo is a trademark of AMX Corporation AMX Corporation reserves the right to alter specifications without notice at any time 3000 research drive richardson TX 75082 USA 469 624 8000 800 222 0193 fax 469 624 7153 technical support 800 932 6993
3. ting e Run all control and low voltage wires away from heat producing parts of the dimmer e Each dimming circuit must have a separate neutral connection e Use low voltage wires with a 300 volt rating or greater e Use field installed copper conductors Installation Sheet RDM INC50 Incandescent Dimmer Module 6000 W e All electrical ratings are for continuous duty e AC lighting loads only e For indoor use only e This module may require extra power from the AXlink connection or an external power supply connected to the control card Connecting the RDM INC50 to the AMX Lighting Master Pin 4 GND Pin 3 RLY Pin 2 DIM o Pin 1 12 V RDM INC50 4 pin module connector A 1 4 pin plug from a RDM series module Note The 4 pin plugs from the module connector to the 4 pin connector on the master black plug cover facing up FIG 2 RDM INC50 connections Lighting Application Drawing All neutrals are common to the _ Neutral block in the enclosure Provide a separate neutral for each load Neutral Line in HOT RDM INC50 EO EREDE F LOAD QO Neutral Neutral Load Load N CON Two wire Neon lights dimmable ballast G 3 RDM INC50 wiri
Download Pdf Manuals
Related Search