American Standard One 2064.15X User's Manual
Contents
1. 2 MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning Connect FLEXIBLE SUPPLIES 1 2 directly to wall supplies Connection on fitting supplies are 3 8 compression Connect left supply to Hot and right supply to the Cold wall supply Use adjustable wrench to tighten connections Do not over tighten Faucet supplies are 10 long from faucet base Note If additional supply length is required installer must purchase additional parts separately Important If SUPPLY HOSES 1 2 are too long loop as illustrated to avoid kinking Figure A LOOP SUPPLIES IF REQUIRED Apply a bead of PUTTY to underside of DRAIN BODY FLANGE 1 Feed DRAIN BODY 1 down through lavatory Assembly GASKET 2 WASHER 3 and LOCKNUT 4 onto DRAIN BODY 1 Tighten LOCKNUT 4 firmly Assembly TAILPIECE 5 to DRAIN BODY 1 M968917 TEST INSTALLED FAUCET AND CHECK FOR LEAKS With HANDLE 1 in OFF position turn on WATER SUPPLIES 2 and check all connections for leaks Remove AERATOR 3 Operate HANDLE 1 to flush water lines thoroughly Replace AERATOR 3 Turn off hot and cold water 2 5mm HEX KEY Ls SERVICE CAUTION supplies before beginning lt E To remove or replace cartridge Turn valve to OFF position a Pull out PLUG BUTTON 1 and remove HANDLE SCREW 2 Pull off HANDLE 3 and CAP 4 a Unthread CARTRIDGE NUT 5 and remove a Pull out CARTRIDGE 6 a2. Inspect CARTRIDGE 6 and O RINGS 7 for debris and clean if necessary a Clean MANIFOLD 8 and rinse clean a Reinstall CARTRIDGE 6 and O RINGS 7 onto MANIFOLD 8 a Reinstall CARTRIDGE NUT 5 CAP and HANDLE ASSEMBLY If spout drips operate handle several times from OFF to ON and HOT to COLD position Do not force handles turn only 90 EverClean Finish Care Instructions American Standard s EverClean finish will wipe clean with a soft dry cloth A soft cloth with clean water may also be used if desired No additional cleaning products are required DO NOT USE Soaps acid polish abrasives harsh cleaners or a cloth with a coarse surface M968917
3. Installation ONE Instructions VESSEL LAVATORY FITTING 2064 15X with EverClean Finish Congratulations on purchasing your American Standard faucet with EverClean finish found only on American Standard faucets EverClean Finish e One wipe effortlessly removes spots e Eliminates the need for cleaners and scrubbing e Permanent surface protectant remains beautiful for the life of the faucet e EverClean available on Polished Chrome Satin Nickel Mea SY Stainless Steel Polished Brass or any combination of these finishes Certified to comply with ANSI A112 18 1M To ensure that your installation proceeds smoothly please read these instructions carefully before you begin Recommended Tools ea eae vO A es Adjustable Wrench Plumbers Putty or Caulking Phillips Screwdriver Channel Locks INSTALL LAVATORY FAUCET CAUTION Turn off hot and cold water supplies before beginning Seat SEAL 1 into under side of ESCUTCHEON RING 2 Seat ESCUTCHEON RING 2 with collar facing up into groove in faucet base Feed FAUCET SUPPLIES 3 and MOUNTING SHANK 4 through ESCUTCHEON RING 2 and hole in mounting surface From below install GASKET 5 and WASHER 6 onto SHANK 4 Secure Faucet with MOUNTING NUT 7 Before final ae ain adjust Faucet so that it is centered Tighten MOUNTING NUT 7 to complete mounting GROOVE MOUNTING SURFACE
Download Pdf Manuals
Related Search