American Standard Heritage 7100 Series User's Manual
Contents
1. Atntrican Standard HERITAGE a AMARILIS HERITAGE SERIES Installation Instructions 7100 SERIES 7190 SERIES SINGLE HOLE BAR PANTRY FITTINGS WITH SWING SPOUT Certified to comply with ANSI A112 18 1M U S Patent No 5 819 789 Thank you for selecting American Standard the benchmark of fine quality for over 100 years To ensure that your installation proceeds smoothly please read these instructions carefully before you begin 7190 SERIES 2 HANDLE MODEL 7190 AERATOR SPOUT 7100 SERIES 1 HANDLE MODEL 7100 O RINGS BODY S A RUBBER RING RUBBER LOCKNUT Sees SUPPLY NUT SWING lt SPOUT CARTRIDGE MOUNTING SA CAUTION Turn off hot and cold water supplies before beginning SWING SPOUT ASSEMBLY Apply the grease provided liberally to the SPOUT FRING ar SNAP RING areas y Assemble the SPOUT and tighten the SPOUT NUT until snug on VALVE BODY FITTING INSTALLATION Remove LOCKNUT BRASS WASHER and RUBBER WASHER from fitting Place RUBBER RING in recess of fitting Insert inlet tubes on model 7190 only and THREADED SHANK through hole of sink making certain RUBBER RING is properly seated in the recess of the fitting base Assemble RUBBER WASHER BRASS WASHER and LOCKNUT onto the THREADED SHANK from underside of sink deck Tighten the LOCKNUT securely For Model 7190 Only Bend the inlet tube2. eplace AERATOR AERATOR may accumulate dirt causing distorted and reduced water flow Remove AERATOR and rinse clean If spout drips operate handles several times from OFF to ON position Do not force handles turn only 90 Plastic SCREEN in CARTRIDGE may accumulate dirt causing reduced water flow To clean first turn off hot and cold water supplies then Remove INSERT and HANDLE SCREW CARTRIDGE Slip HANDLE with ADAPTER off Unscrew CARTRIDGE with wrench Thoroughly rins ninge pases SCREEN at base of C Replace CARTRIDGE until flange is tight against valve body Turn valves OFF SCREEN Replace ADAPTER HANDLE SCREW and INSERT Product names listed herein are trademarks of American Standard Inc American Standard Inc 1999 34440N
3. s to meet the supply lines NOTE Use the palm of your hand to support the inlet tubes during bending to avoid kinking of the tubes Connect the hot water supply line to the left inlet tube and the cold water supply line to the right inlet tube using appropriate connectors For Model 7100 Only Connect hot or cold water supply lines to shank using sealant appropriate connectors and coupling nuts TEST INSTALLED FAUCET Remove AERATOR With handle in OFF position turn on water supplies and check all connections for leaks SERVICE To change direction of handle rotation proceed as follows Turn valve to OFF position SPRING m Remove INSERT and HANDLE SCREW CLIP Slip HANDLE with ADAPTER off m Remove SPRING CLIP a Lift STOP WASHER turn 90 and replace m Replace SPRING CLIP m Replace ADAPTER HANDLE SCREW and INSERT COPPER INLET TUBES HOTLINE FOR HELP For toll free information and answers to your questions call 1 800 223 0068 Weekdays 8 00 a m to 7 00 p m Eastern Time Saturdays 8 00 a m to 4 00 p m Eastern Time IN CANADA 1 800 387 0369 TORONTO 1 416 536 5609 MODEL 7190 RECESS Ng BuBa S RUBBER MOUNTING WASHER N BRASS ee ee WASHER _ a LOCKNUT SUPPLY __ 8 HOT i COLD Operate both handles to flush water lines thoroughly Check spout mounting and hose connections for leaks Turn handles into OFF position and r
Download Pdf Manuals
Related Search