Alvin WorkMaster Jr. User's Manual
Contents
1. assembly to the upright position Adjust tabletop to desired height using height adjustment knobs IM You re finished and your table is ready to use see Figure 5 WORKMASTER WORKMASTER JR MODELS MODELS WM48 3 XB WM48 4 XB WM60 3 XB WM60 4 XB WM72 3 XB WM72 4 XB WMJ 3 XB WMJ 4 XB WMJ48 3 XB WMJ48 4 XB WMJ 3 WBR WMJ 4 WBR WMJ 3 XBR WMJ 4 XBR 2007 ALVIN amp COMPANY INC P O Box 188 Windsor CT 06095 0722 7 Phone 860 243 8991 e Toll Free 800 444 2584 e Fax 860 242 8037 e Toll Free Fax 800 777 2896 www alvinco com LIT A7010 5 072. WorkMaster amp WorkMaster Jr Assembly Instructions Tools required Phillips screwdriver and drill with 1 4 drill bit Parts Included C ipc D ipc Leg Frame Left amp Right Tabletop Back Panel Storage Shelf Rear Extension Tubes shipped in separate box Please Note Back Panel and Storage Shelf are identical and interchangeable F 2pcs J 1pc G 4pcs H 4pcs I 24pcs Cardboard g Template Front Extension Tubes Floor Glides Height Adjustment Knobs 10 x Wood Screws Tabletop Template To Assemble Unpack and inspect contents to confirm you have all parts listed above Fasten floor glides G into bottom of leg frames at each Figures end as shown in Figure 1 Place back panel on a bench or table at least 20 high with ends hanging over the edge Hang left leg frame A on top of back panel as shown in Figure 1 Make sure ends of back panel are snug against steel leg frames and holes are aligned in steel flange with pre drilled holes in back panel Attach using four 4 screws I supplied Repeat step for right leg frame Screws Figure 2 e Screws Carefully remove base assembly from table bench and place upright on floor Place shelf ID with predrilled holes facing up on the bench table with ends hanging over edge Lift base assembly carefully may require two people and set on top of shelf Balance with care Align holes in steel flange with predrilled holes in shelf and insert screw
3. s fl making sure ends of shelf are snug against steel frames see Figure 2 Tighten securely but use care not to overtighten and strip Remove base assembly carefully from table bench and place upright on floor Insert two rear extension tubes E at rear of frame as shown in Figure 3 Curved black caps on tubes should be set into frame so inclines face front and back of frame Carefully insert two front extension tubes F with attached brackets facing out All Rea ee four extension legs should be at their lowest position and locked with four height adjustment knobs M1 Set base aside Front extension tube Figure 4 Place tabletop B with preferred side facing down on carpeted or protected floor Place supplied cardboard template on board surface with edge of template at front edge of board Left and right edges of template should be an equal distance from each side of the tabletop Using a 1 4 drill bit gently drill 14 deep holes where marked on the template Remove template Wrap masking tape 1 4 from drill bit end to determine drilling depth Take care to drill only 4 deep to avoid drilling through and destroying tabletop surface Carefully turn table assembly upside down and place on top of tabletop Align holes in front leg extension brackets IF with holes in tabletop see Figure 4 Fasten all 4 screws I and tighten securely Use care not to overtighten and strip s Screws Carefully return table
Download Pdf Manuals
Related Search