AllerAir 600 Series User's Manual
Contents
1. Gollewgir AllerAir Industries FILTER ASSEMBLY 600 D DX Turn Power Off and With a 2 Philips screw driver unplug receptacle remove the four screws from the Lay unit upside down bottom of the unit Step 4 Step 5 Remove only one of the white felt Insert the carbon filter either a donut shaped gaskets from the Model 600 D Carbon or a Model 600 inside of the purifier body DX Carbon into the unit Place lid back to its proper position by aligning the arrow with the rear Step 8 seam Replace the four screws Gently grasp wheels Remove base by gently pulling on the wheels Step 6 Replace the gasket that had been removed in STEP 4 Step 9 Turn the unit back onto its wheels It is now ready for immediate use 2 Ta AllerAir Industries llewir Model 600 Series aii Operation and Maintenance Manual AllerAir Industries Inc Toll free 1 888 852 8247 Fax 1 877 688 3939 www aallerair com 771 Ta AllerAir Industries AllerAir Industries Inc 600 Series July 23 2007 Congratulations you are moments away from fresher cleaner indoor air Your new AllerAir unit will combat many of the chemicals gases odors and particles responsible for poor indoor air quality and in turn health concerns such as allergies asthma sick building syndrome and multiple chemical sensitivity As with any air cleaner proper maintenance of your unit is a vital part of keeping it operating at peak e2. fficiency WARNING Before removing the top or bottom of the unit for any reason always unplug the cord from the power supply Operation Most 600 units are shipped fully assembled and ready for use with the exception of the D amp DX models which ship with their large carbon filters in a separate box This is done to safeguard your unit during shipping To insert the filter refer to the Filter Assembly 600 D DX diagram Please plug units into a 120V 15amp outlet For best results situate your unit close to your sitting sleeping or work area The units equiped with a variable speed control Turn knob to the right to adjust to your safistaction Note Please save your packaging Original packaging will be required for all Maintenance 600 Series HEPA Filter Model 600 HEPA 2 or HEPA 3 m Change the HEPA filter every 3 5 years or after a noticeable decrease in air quality Carbon Filter Model 600 Carbon Filter Change the carbon filter after 2 years or after a noticeable decrease in air quality Pre Filter model 600 Prefilter m Change or vacuum the pre filter every 2 4 months depending on the dust level in the area of use dlle AllerAir Industries REPLACING FILTER ASSEMBLY 600 Series Step 1 Turn Power Off and unplug receptacle Lay unit upside down Step 4 Remove base by gently pulling on the wheels Replace filters with new ones then reassemble by inserting the Carbon filter
3. first then the HEPA filter With a 2 Philips screw driver remove the four screws from the bottom of the unit Step 5 First remove the HEPA filter by placing thumbs on the inner side of the filter Then pull up gently until totally out Place lid back to its proper position by aligning the arrow with the rear seam Gently grasp wheels Step 6 Than remove the Carbon filter by placing thumbs on the inner side of the filter Then pull up gently until totally out Step 9 With a screw driver place 4 screws back into their positions Gently return the unit into upright position
Download Pdf Manuals
Related Search