Metra AX-ADXSVI-MB2 car kit
Contents
1. INSTAX ADXSVI MB2 AX ADXSVI MBe2 Mercedes accessory and NAV output CAN Interface 2005 up e Provides accessory 12 volt 10 amp Retains R A P retained accessory power Used in non amplified systems or when replacing amplified system Provides NAV outputs parking brake reverse and V S S Prewired ASWC 1 harness included ASWC 1 sold separately High level speaker input USB updatable Note This harness must be used in conjunction with the AX ADXSVI APPLICATIONS MERCEDES C Class 2005 2011 E Class 2010 up CLK Class 2005 2009 GLK 2010 2012 SLK Class 2005 2001 R Class 2006 2011 G Class 2007 2012 WIRING THE AX ADXSVI MB2 Connect the Yellow wire to the radio s 12 volt battery or memory wire Connect the Black wire to the radio s ground wire Connect the Red wire to the ignition wire of the aftermarket radio Connect the Orange wire to the illumination wire of the aftermarket radio If the aftermarket radio has no illumination wire tape off the Orange wire Connect the Blue wire to the antenna turn on wire of the aftermarket radio Connect the White wire to the left front positive speaker output of the aftermarket radio Connect the White Black wire to the left front negative speaker output of the aftermarket radio 1 800 221 0932 m metraonline com REV 12 18 13 COPYRIGHT 2004 2013 METRA ELECTRONICS CORPORATION INSTAX ADXSVI MB2 Connect the Gray wire to the right front positive speaker output of the aftermarke2. luded with the aftermarket radio 1 800 221 0932 A metraonline com REV 12 18 13 COPYRIGHT 2004 2013 METRA ELECTRONICS CORPORATION
3. t radio Connect the Gray Black wire to the right front negative speaker output of the aftermarket radio Connect the Green wire to the radio s left rear positive speaker output Connect the Green Black wire to the radio s left rear negative speaker output Connect the Purple wire to the radio s right rear positive speaker output Connect the Purple Black wire to the radio s right rear negative speaker output The following wires are for the aftermarket radios that have navigation built in Connect the Light Green wire to the parking brake wire of the aftermarket navigation radio if applicable Connect the Blue Pink wire to the VSS or speed sense wire of the aftermarket navigation radio if applicable Connect the Green Purple wire to the reverse wire of the aftermarket navigation radio if applicable Cycle the key by turning the ignition on for 30 seconds Then off and on again to test the radio ASWC 1 if installing After the XSVI is initialized plug in the ASWC 1 into the 12 pin harness of the AX ADXSVI MB2 and refer to the ASWC 1 instructions ee ee Caution Metra recommends disconnecting the moe electronico school mau inde negative battery terminal before beginning any Bt 8762 for more iformatin anak tps installation All accessories switches and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition et aplasia MELE Note Refer to the instructions inc
Download Pdf Manuals
Related Search