Metra AX-ADXSVI-GM1 car kit
Contents
1. 12 volt battery or memory wire Connect the Black wire to the radio s ground wire Connect the Red wire to the ignition wire of the aftermarket radio Connect the Orange wire to the illumination wire of the aftermarket radio If the aftermarket radio has no illumination wire tape off the Orange wire Connect the Blue wire to the antenna turn on wire of the aftermarket radio Connect the White wire to the left front positive speaker output of the aftermarket radio Connect the White Black wire to the left front negative speaker output of the aftermarket radio continued on next page metraonline coOm COPYRIGHT 2004 2011 METRA ELECTRONICS CORPORATION AX ADXSVI GMi1 Connect the Gray wire to the right front positive speaker output of the aftermarket radio Connect the Gray Black wire to the right front negative speaker output of the aftermarket radio Connect the Green wire to the radio s left rear positive speaker output Connect the Green Black wire to the radio s left rear negative speaker output Connect the Purple wire to the radio s right rear positive speaker output Connect the Purple Black wire to the radio s right rear negative speaker output The following wires are for the aftermarket radios that have navigation built in Connect the Light Green wire to the parking brake wire of the aftermarket navigation radio if applicable Connect the Blue Pink wire to the VSS or speed sense wire of the aftermarket navigation2. radio if applicable Connect the Green Purple wire to the reverse wire of the aftermarket navigation radio if applicable Cycle the key by turning the ignition on for 30 seconds Then off and on again to test the radio ASWC 1 if installing After the XSVI is initialized plug in the ASWC 1 into the 12 pin harness of the AX ADXSVI GM1 and refer to the ASWC 1 instructions METRA The World s best kits 1 800 221 0932 IMPORTANT WARNING This product includes instructions for installation which must be carefully followed The instructions are worded in such a manner to assume that the installer is capable of completing these type of electronic installations If you are unclear as to what you are instructed to do or believe that you do not understand the instructions so as to properly and safely complete the installation you should consult a technician who does have this knowledge and understanding Failure to follow these instructions carefully and to install the interface as described could cause harm to the vehicle or to safety systems on the vehicle Interference with certain safety systems could cause harm to persons as well If you have any questions in this regard please call the Help line or Metra at 1 800 221 0932 for assistance KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry Log onto www installerinst
3. REV 12 19 2013 INSTAX ADXSVI GM1 Installation Instructions for AX ADXSVI GM1 AX ADXSVI GMI1 APPLICATIONS BUICK Tahoe 2007 2014 Enclave 2008 up Traverse 2009 up Lucerne 2006 2011 GMC CADILLAC Acadia 2007 up Escalade 2007 2011 Savanna 2008 up only to be used when replacing an Sierra new body 2007 13 amplified system Sierra 2500 3500 2014 DTS 2006 2011 Yukon XL 2007 201 4 only to be used when replacing an HUMMER amplified system o Y AT aT OT ATAT Y SRX 2007 2009 H 2008 2009 only to be used when replacing an PONTIAC amplified system Torrent 2007 2009 CHEVROLET SATURN Avalanche 2007 up Outlook 2007 2010 Captiva Sport 2012 up Vue 2008 2010 Cheyenne 2012 up Equinox 2007 2009 SUZUKI 30072005 Express 2008 u Impala 2006 2013 r ae Impala limited 2014 Non navigation models only Monte Carlo 2006 2007 Silverado new body 2007 13 Silverado 2500 3500 2014 Suburban 2007 201 4 METRA The World s best kits 1 800 221 0932 KIT FEATURES e Provides accessory 12 volt 10 amp Retains R A P retained accessory power Used in non amplified systems or when replacing amplified system Provides NAV outputs parking brake reverse and V S S Prewired ASWC 1 harness included ASWC 1 sold separately High level speaker input USB updatable Note 1 This harness must be used in conjunction with the AX ADXSVI 2 All chimes will be lost when using this harness WIRING THE AX ADXSVI GM1 Connect the Yellow wire to the radio s
4. itute com or call 800 354 6782 for more information and take steps toward a better tomorrow Metra recommends MECP certified technicians metraonline cOm COPYRIGHT 2004 2011 METRA ELECTRONICS CORPORATION
Download Pdf Manuals
Related Search