Scosche NN1646B car kit
Contents
1. SCOSCTCHE NN1646B IN DASH DOUBLE DIN INSTALLATION KIT FOR 2002 04 NISSAN ALTIMA 6612 LEFT BRACKET 6611 RIGHT BRACKET INTRODUCTION PRELIMINARY This premium installation kit is for 2002 04 Nissan Altima vehicles Included are all the parts you need to mount your car stereo or CD player into your vehicle s dash Refer to the individual instruction in this manual to remove your vehicle s factory radio and assemble the kit CAUTION DISCONNECT YOUR VEHICLE S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP PREVENT ELECTRICAL DAMAGE WE RECOMMEND THE USE OF A VOLT OHM METER OVER A TEST LIGHT TO CHECK WIRING A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE VEHICLE S COMPUTER AND OR DIAGNOSTIC SYSTEMS AVOID ALL FACTORY AIRBAG WIRING AIRBAGS CAN ACCIDENTALLY DEPLOY CAUSING SERIOUS INJURY OR DEATH NOTES e See your vehicle s instructions for any special tools your installation might require e Read all instructions accompanying your car stereo for proper wiring and mounting instructions FACTORY WIRING CODES For Factory Wiring Codes go to Www scosche cars com CAR STEREO CONNECTORS PROVIDE EASY CONNECTION OF YOUR CAR STEREO TO FACTORY WIRING HARNESS NNO3B NDAB 1995 Up Nissan Nissan Diversity Antenna Adapter LIABILITY DISCLAIMER This instruction booklet is based on carefully documented data and research of automobile dash disassembly wire harness codes and information pertain2. ing to installation of this kit NN1646B in 2002 04 Nissan Altima vehicles Scosche Industries Inc cannot be held responsible for discrepancies inconsistencies that may occur due to the automobile manufacturing changes or options or damage that may occur in the automobile during the installation of components while using this booklet If you have any further questions call our toll free technical help line at 1 800 621 3695x3 2008 SCOSCHE INDUSTRIES INC SI 4 08 NN1646B 3000003 FACTORY STEREO REMOVAL 2002 04 NISSAN ALTIMA 1 Remove climate control dash bezel 2 Extract 1 Phillips head screw on right side of stereo securing stereo bezel remove bezel 3 Extract 4 Phillips head screws securing stereo unplug and remove MOUNTING THE STEREO DOUBLE DIN ISO MOUNT 1 Mount 6611 right and 6612 left brackets to stereo using screws supplied with aftermarket stereo 2 Secure aftermarket stereo and 6611 6612 bracket assembly to dash using the 4 Phillips screws that were securing the factory stereo 3 Snap 6610 mounting panel to stereo dash bezel and finish reassembly 6612 LEFT BRACKET VARIOUS REAR SUPPORTS e ias S LOQ DOUBLE DIN SS S STEREO A X f A f Q S 6611 RIGHT BRACKET NOTE REAR SUPPORT AVAILABLE SEPARATELY REAR SUPPORTING THE STEREO ADDS TO THE INSTALLATION S STRUCTURAL INTEGRITY
Download Pdf Manuals
Related Search