Home

Infocus SC-PU-100 projection screen

1. INSTRUCTION BOOK FOR DELUXE PULL UP FLOOR SCREEN SC PU 100 SC PUW 73 SC PUW 90 InFocus Cor Gete 13190 SW 68th Parkway Suite 200 gida OR 97223 www nFocus com INTRODUCTION Thank you for purchasing this InFocus product Before attempting to use it make sure to carefully read the contents of these instructions CAUTION 1 Avoid touching the films during raising or lowering of unit 2 Do not set up the screen on an unstable or uneven surface This may cause the screen to fall or tip over re sulting In damage to the screen or personal injury Be especially careful when setting up at home where small children may be present 3 When screen is not in use and retracted use the built in feet to stabilize it on a flat surface Standing the screen on one of its ends creates the risk of falling over and should be avoided 4 Do not hang or attach items to the screen CARE OF SCREEN 1 Do not leave the screen in areas subject to direct sunlight 2 Keep the projection surface of the screen free from dirt and dust which can interfere with the quality of the projected image If the screen becomes dirty lightly wipe it off with soft cloth moistened in a weak 20 to 1 solution of a mild neutral detergent and water Benzine thinner and other volatile agents can cause permanent damage to the screen and should never be used for cleaning 3 Do not set up the screen in areas subjected to strong breeze This ma
2. odels only 7 Collapse the extending handle by pressing on the button as shown and sliding the two halves together Store extending handle in case A 8 Close the case cover and latch it It may be neces sary to press down on the case top to get the latches to engage properly Note Before carrying the case rotate the feet so they are out of the way WARNING VVhen storing the screen be sure that you protect it from falling Leaning the case against a wall or other sur face creates the danger of falling over Printed in U S A SPECIFICATIONS see drawing 60 73 and 80 Shipping dimensions 6 1 4 x 7 x 61 1 2 6 1 4 x 7 x 77 1 8 Dimensions Weight of unit 14 0 Lbs 16 4 Lbs shipping weight 17 3 Lbs 20 4 Lbs 90 and 100 Shipping dimensions 6 1 4 x 7 x 91 1 4 Weight of unit 19 8 Lbs Shipping weight 23 8 Lbs 60 79 1 4 73 80 1 4 A 71 1 4 A 4 1 2 80 81 1 2 4 1 2 90 88 100 96 Note Specifications are subject to change without notice WARRANTY For warranty support contact Da Lite Screen Company DA LITE SCREEN COMPANY INC 3100 North Detroit Street Post Office Box 137 Warsaw Indiana 46581 0137 Phone 574 267 8101 800 622 3737 Fax 574 267 7804 Toll Free Fax 877 325 4832 www da lite com e mail info da lite com 97191 Rev 5 11
3. y cause the screen to move and inter fere with the quality of the projected image PARTS IDENTIFICATION 1 Lifting Handle 11 Slat 2 Slat handle 12 Long arm 3 Screen film 13 Upper arm hinge 4 Skirt film 14 Short arm 5 Left end cap 15 Lower arm hinge 6 Rotating foot 16 Air shock 7 Bottom case 17 Case handle 8 Right end cap 18 Extending Handle 9 Case cover 90 and 100 only 10 Case latch SETTING UP THE SCREEN 1 Rotate feet until they are perpendicular with the case 2 Release the latches and open the case cover On the 90 and 100 models remove extending handle and extend it as shown Note Push lightly down on the center of the case to release the latches 3 Pull up the screen slowly at a certain height using the Lifting Handle then grasp the Slat handle and raise the screen slowly keeping the slat level as you raise the screen as I SS 4 Place the end of the extending handle under the slat handle as shown below and raise screen to desired height 100 model only STORING THE SCREEN 5 Grasp the Slat Handle and lower the screen slowly back into the case Make sure you hold onto the handle and keep the slat level as you lower the screen back into the case 6 Place the end of the extending handle under the slat handle as shown below and lower the screen until you can easily reach the slat handle 90 and 100 models only On 90 and 100 m

Infocus SC-PU-100 projection screen

Contents

Download Pdf Manuals

Related Search

Related Contents