Metra 95-7425 mounting kit
Contents
1. INSTALLATION INSTRUCTIONS FOR PART 95 7425 APPLICATIONS 95 7425 KIT FEATURES e Double DIN Radio Provision e Stacked ISO Mount Units Provision KIT COMPONENTS Harness amp Antenna Connections sold separatel e 70 7552 Nissan Harness 07 up e 40 NI12 Nissan Antenna Adapter 07 up TOOLS REQUIRED Small Flat Blade Screwdriver Panel Removal Tool e Phillips Screwdriver A 1 800 221 0932 www metraonline com COPYRIGHT 2008 10 METRA ELECTRONICS CORPORATION me 95 7425 TABLE OF CONTENTS Dash Disassembly Nissan Rogue 2008 11 0oococcocoooooooo oo 1 2 Kit Assembly Double DIN Stacked ISO Mount Units Provision 3 Final ASSEMDIV sarna DADA 4 Note Refer also to the instructions included with the aftermarket radio A Lez 23 7405 DASH DISASSEMBLY AM NISSAN Roque 2008 11 A 1 Disconnect the negative battery ter minal to prevent an accidental short circuit NO If equipped with center speaker Unclip and remove the grille Figure A Remove 4 Phillips screws securing the speaker Unplug and remove the speaker Figure B Unclip the panel above the radio including the a c vents then unplug hazard switch and remove Figure C Note If not equipped with center speaker skip step number 2 Continued on page 2 LE 25 7495 DASH DISASSEMBLY NISSAN Rogue 2008 11 os 3 Unclip the panel below t2. he radio including the climate controls Unplug climate controls and remove the panel Figure D 4 Remove 4 Phillips screws securing the radio unplug and remove radio Figure E Continue to kit assembly TE i WET TS To Ch NL a SI Y Mel 95 7425 KIT ASSEMBLY DOUBLE DIN STACKED 150 MOUNT UNITS PROVISION Note Refer also to the instructions included with the aftermarket radio 1 Snap the Double DIN brackets to the inside edge of the Double DIN radio housing Figure A 2 Slide the Double DIN or the stacked ISO mount unit s into the bracket radio housing assembly and secure the unit s to the assembly using the screws supplied with the unit s Figure B Continue to final assembly B SN Vmerss A EA A FINAL ASSEMBLY A Strip wire ends hack 1 2 B Twist ends together C Solder D Tape 1 Locate the factory wiring harness in the dash Metra recommends using the proper mating adapter and making connections as shown Isolate and individ ually tape off the ends of any unused wires to prevent electrical short circuit 2 Re connect the negative battery terminal and test the unit for proper operation 3 Reassemble in reverse order of disassembly FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit Metra recommends making connections as shown below Strip Splice Solder Tape Isolate a
3. nd individually tape off ends of any unused wires to prevent electrical short circuit METRA EIA WIRING CODE 12V Ignition Acc Red 12V Batt Memory Yellow GOWN erase Black Power Antenna Blue Amp Turn On Blue White Amp Ground Black White Illumination Orange Dimmer Orange White Right Front Gray Right Front Gray Black Left Front White Left Front White Black Right Rear Violet Right Rear Violet Black Left Rear Green Left Rear Green Black NOTE When a Black wire is not present ground radio to vehicle chassis All colors may not be present on all leads due to manufacturer s specifications 22 ss NOTES 95 7425 INSTRUCTIONS EEE BEE 1 800 221 0932 www metraonline com REV 11 18 10 O COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST95 7425
Download Pdf Manuals
Related Search