Datalogic 94A051966
Contents
1. ance degradation may occur2. t to lift the mobile computer by the Power Adapter Cable Powering the dock Memor using the Battery Female Adapter For connection to the vehicle power source through the Battery Female Adapter it is necessary to prepare the power cable termination to connect the dock to the vehicle power source Red wire connect to a V 10 to 32 Vdc vehicle power source Black wire connect to the vehicle ground wire or chassis ground In this case it is mandatory to use the slow blow 8A 250V with holder supplied 1 Verify that the fuse is contained within the holder then splice it to the end of the red wire of the cable Make the distance between fuse holder and power connection point as short as possible and apply a caution label on the fuse holder Once the power cable termination has been completed it is possible to connect the dock to the vehicle power Figure 4 Red Wire Figure 5 2 Plug in the cigarette lighter adapter into the Battery Female Adapter Figure 6 3 Insert the Power Adapter Cable output connector in the dock Memor power port see the previous section To avoid battery waste it is recommended to connect the dock to a power connection point switched by the ignition key NOTE When connecting the Battery Female Adapter cable to the power connection point ensure that it does not pass by sharp or very hot surfaces Battery Charging The Power Adapter Cable provides ba
3. ttery charging for the Datalogic Memor when powered The Datalogic Memor will charge its installed battery when power is applied to the Power Adapter Cable NOTE TECHNICAL FEATURES Datalogic Memor Power Adapter Cable Electrical Features Power Supply from 10 to 32 VDC Consumption with Max 1 15A mobile computer Quiescent Max 38 mA Consumption CLA Dock no load Quiescent Max 32 mA Consumption CLA only no load Indicators Power on LED green Charge Time Li lon Battery max 4 hours Environmental Features Working 0 to 50 C 32 to 140 F Temperature Storage 20 to 70 C 4 to 158 F Temperature Humidity Sinusoidal Vibration 90 non condensing 14mm 2 to 10Hz 1 5mm 13 to 55 Hz Resistance 2 gn 70 to 200 Hz 2 hours on EN 60068 2 6 each axis Random Vibration Frequency Range 5 1000 Hz Resistance acceleration RMS 3 1 g initial EN 60068 2 64 slope 26 dB octave 5 10 Hz final slope 3 dB octave 10 1000 Hz 1 hour on each axis EN 60068 2 29 bumps on each axis Shock Resistance 30 G 11ms 3 shocks on each axis EN6000B2 97 e Snooks on each axs Weight CLA 180 g 7 2 oz Adapter Battery must be charged at a temperature ranging from 0 to 40 C For the GSM models the maximum recommended temperature is 385 C At higher values the charging may slow down Close to the limits of the working temperature some display and or battery perform
4. wVJATALOCIC Datalogic Memor Power Adapter Cable The Datalogic Memor Power Adapter Cable allows powering the Datalogic Memor mobile computer either directly or through the Powered Vehicle Dock THE PACKAGE The Power Adapter Cable package includes the following items Figure 1 A Power Adapter Cable B CLA Battery Female Adapter C Fuse Holder 852000491 Rev A THE POWER ADAPTER CABLE Figure 2a Figure 2b A Green LED B Fuse 2 5A 250V When the Power Adapter Cable is powered the green LED lights up The Power Adapter Cable fuse can be easily replaced by unscrewing the ring nut and removing the cap see Figure 2a POWERING THE MEMOR POWERED VEHICLE DOCK Powering the dock Memor in your vehicle 1 Plug in the supplied Power Adapter Cable into your vehicle s cigarette lighter or 12V or 24V power source 2 insert the Power Adapter Cable output connector a in the power port at the right bottom of the dock see figure 3a When the dock is powered the green LED lights up in the port at the bottom of the mobile computer see figure 3b Figure 3a CAUTION CAUTION Figure 3b Make sure your vehicle s output voltage is between 10V to 32V and is capable of supporting a 2000mA current drain If you have any concerns regarding this refer to your vehicle owner s manual When the Power Adapter Cable is connected to the Memor it is recommended no
Download Pdf Manuals
Related Search