APC AR201 racks
Contents
1. r Hex Head Bolt Angle Repeat step 2 for one top angle at the top of each upright Again finger tighten only Turn the assembly over and repeat steps 2 4 with the remaining top and bottom angles Push the center of the uprights outward and using a 9 16 box end wrench tighten all screws Caution Do not exceed 20 ft lb of torque when tightening screws Stand the rack up and place it in the desired position and secure it to the floor hardware not provided Do not install equipment until the rack is secured to the floor 2 2 Upright Mounting Hole Dimension 18 5 16 gt y E Minimum Inside Dimension i 17 72 gt i Bottom Bolts Angles2. APC NetShelter 2 Post Rack AR200 amp AR201 Unpacking and Inspection Before unpacking 1 Inspect the carton for damage If you detect damage notify the carrier 2 Remove the components from the carton and inspect them for shipping damage Note The mounting hardware is enclosed in a separate plastic bag located inside one of the packaging inserts glued to the main carton Remove it before discarding the carton Inventory The following table lists the parts that are included with the NetShelter 2 Post Rack Inventory of the NetShelter 2 Post Rack Component Quantity Rack 3 Extruded Upright Rail 1 x 12 Extruded Top Angle 3 x 6 Extruded Bottom Angle Hardware 3 8 16 x 34 Hex Head Bolt 3 8 Split Lock Washer 12 24 Screw for installing equipment Tools Required You will need a 9 16 box end wrench to assemble the rack 990 6040A 1 2 6 00 Installation Refer to figures 1 and 2 1 Place the uprights on a flat surface approxi mately 20 apart with the larger face of each upright facing away from the other upright Place one bottom angle at the base of each upright aligning the four holes on the smaller face of the angle with the 3 8 tapped holes of each upright Loosely attach using the hex head bolts and split lock washers as shown in Figure 2 Finger tighten only Upright 3 8 Split Lock Washer ae 3 8 16 x 3 4
Download Pdf Manuals
Related Search