Lindy 40877 flat panel wall mount
Contents
1. INSTRUCTION MANUAL SPECIFICATIONS Display Size up to 46 Maximum Load 35 kg Mounting Pattern 400 mm x 400mm max Profile 11 1cm 39cm Tilt 15 down Swivel up to 180 BOX CONTENTS O Wall bracket x1 O Mount arms x 2 C Instruction Manual x1 O Hardware Kit x1 WARNINGS 1 The wall or mounting surface must be capable of supporting the combined weight of the mount and the display if not the structure must be reinforced 2 Locate pipes wires or any other hazards in the wall where you wish to install the mount before drilling 3 Safety gear and proper tools must be used Failure to do so can result in injury or damage 4 Two people are recommended for installation Do not attempt to lift a heavy display without assistance 5 Follow all instructions and recommendations regarding adequate ventilation and suitable locations for mounting your display Consult the owner s manual for your particular display for more information CAUTION This wall mount is intended for use only with the maximum weight of 35 kg Use with heavier than the maximum weights indicated may result in instability causing possible injury TOOLS REQUIRED O Screwdriver O Electric or Portable Drill O Drill Bit and Stud Finder for Drywall Installation O Masonry Bit for Concrete Installation O Hammer CI Tape Measure HARDWARE KIT A M6 x 50 Lag Bolt x3 B Lag Bolt Washer x3 C Concrete Anchor x3 D M4 x 20Screw x4 E M6x 20 Screw x4 J M6 Was2. back of your display is curved or recessed display is curved or recessed bolts require washers bolts do not require washers Ss Carefully mount your display with the mount arms onto the mount Insert the safety screws to the bottom of the mount arms and tighten to prevent the display from being lifted
3. her x4 K Spacer x4 poo oO OOOO Drywall Installation me fat Use a stud finder to locate a stud where you wish to install your mount Use the wall plate as a template to mark three holes Drill a pilot hole at each marked location Fix the wall plate onto the wall using A B and C provided from the hardware kit Choose D F provided from the hardware kit to fix the mount arms to the back of your display Spacers and E G H should be used if the back of your display is curved or recessed display is curved or recessed bolts require washers bolts do not require washers Carefully mount your display with the mount arms onto the plate Insert the safety screws to the bottom of the mount arms and tighten to prevent the display from being lifted Concrete Installation eres Use the wall plate as atemplate to mark three holes Drilla hole at each marked location Insert a concrete anchor into each hole Fix the wall plate onto the wall using A B and C provided from the hardware kit Choose D F provided from the hardware kit to fix the mount arms to the back of your display Spacers and E G H should be used if the
Download Pdf Manuals
Related Search