Sencor SFS 1001GR slicer
Contents
1. 2 Connect the power cord to an el power socket Attention Before connecting the power cord to an electrical power socket check that the cutting disc AG is properly attached to the drive unit AG 3 Place food on the sliding plate A so that it is located between the food pusher A and the plate for setting the slice thickness A 4 Use your left thumb to press the safety switch A and hold it pressed down Use your left index finger to press the power switch AG The drive unit AG will start and the cutting disc AO will start to rotate Rest your right thumb against the thumb guard AG and place the remaining fingers on the outer side of the food pusher AG Move the sliding plate AG back and forward and move the food using the food pusher AG to the cutting disc AG The cut slices will fall onto plate A Copyright O 2012 Fast CR a s Revision 10 2012 Electric Food Slicer SFS 1000WH SFS 1001GR SFS 1070WH SFS 1071GR Placement of the right thumb Placement of the remaining fingers on the right hand Note If you release switch A at any time while slicing the slicer shuts off If food gets stuck to the cutting disc AQ stop slicing and clean the cutting disc AG using a plastic spatula Before cleaning the food slicer turn it off and disconnect it from the power outlet We recommend that you wet the cutting disc AG before cutting cheese Some food may cause discolouration of plastics However th2. USED ELECTRICAL AND ELECTRONIC EQUIPMENT 00020002 eee 9 EN 2 Copyright 2012 Fast R a s Revision 10 2012 Electric Food Slicer SFS 1000W H SFS 1001GR SFS 1070WH SFS 1071GR IMPORTANT SAFETY INSTRUCTIONS READ CAREFULLY AND STORE IT FOR FUTURE USE Persons with diminished physical sensory or mental capacity can use this appliance or persons with limited experience and knowledge if they are under supervision or were instructed on use of the appliance in a safe manner and understand its potential dangers Children may not operate this appliance or play with it Keep the appliance and its power cord out of the reach of children Before connecting this appliance to the socket outlet make sure the voltage stated on the label of the product corresponds to the voltage in your wall socket Never use accessories which have not been supplied with this appliance or which have not been explicitly recommended by the manufacturer for this appliance This appliance is designed for household use Do not use the appliance in an industrial environment or outdoors Do not place the appliance on window sills or on unstable surfaces Only place the appliance on an even dry and stable surface Do not place the appliance in the vicinity of an open flame or appliances that are sources of heat Ensure that the power plug contacts do not come into contact with water or moisture Do not wash the drive unit under running wat
3. it replaced at a expert service centre It is forbidden to use the appliance if it has a damaged power cord or plug To avoid the danger of injury by electrical shock do not repair the appliance yourself or make any adjustments to it Have all repairs or adjustments of the appliance performed at an authorised service centre Tampering with the appliance during the warranty period may void the warranty policy EN 3 Copyright 2012 Fast R a s Revision 10 2012 Electric Food Slicer SFS 1000WH SFS 1001GR SFS 1070WH SFS 1071GR DESCRIPTION OF THE ELECTRIC FOOD SLICER Central fastener for the cutting disc Guiding groove Base tilting plate Plate for adjusting slice thickness adjustable range of 0 15 mm Slice thickness controller Food tray Drive unit Thumb guard Food pusher Slide plate Safety switch Switch for starting the appliance Cutting disc BE SS Copyright O 2012 Fast CR a s Revision 10 2012 Electric Food Slicer SFS 1000W H SFS 1001GR SFS 1070WH SFS 1071GR BEFORE FIRST USE 1 Take the appliance and its accessories out of the packaging materials 2 Wash accessories disassembled cutting disc AG sliding plate AU food pusher AG thumb guard A and food tray A 3 that come into contact with foodstuffs in hot water using kitchen detergent Then thoroughly rinse them under flowing water and dry thoroughly with a wiping cloth Wipe the s
4. Electric Food Slicer User s Manual SENCOR SFS 1000WH SFS 1001GR SFS 1070WH SFS 1071GR Prior to using this appliance please read the user s manual thoroughly even in cases when one has already familiarised themselves with previous use of similar types of appliances Only use the appliance in the manner described in this user s manual Keep the user s manual in a safe place where it can be easily retrieved for future use We recommend saving the original shipping cardboard box packaging material receipt and warranty card for the duration of warranty In the case of transportation pack the appliance using the original packaging materials only EN 1 Copyright 2012 Fast R a s Revision 10 2012 Electric Food Slicer SFS 1000WH SFS 1001GR SFS 1070WH SFS 1071GR CONTENTS IMPORTANT SAFETY INSTRUCTIONS ag a AR A L B A o ee evan A 3 DESCRIPTION OF THE ELECTRIC FOOD SLICER x ds RR d va O oa 64 OKA KA es 4 BEFORE FIRST USE camas EE E SAL NA DE EE ad 5 ASSEMBLING THE ELECTRIC FOOD SLICER 2 2 44 22d0ctenesduuneseeroodatei ener VARK kb aa bc 5 USING THE ELECTRIC FOOD SLICER cc n o o Sen eee Beda tus Kd b Mew ee ee 6 CLEANING AND MAINTENANCE 8 STORAGE 4 bs se nates ete a ns Cee KSK as eae cen eee eee ds ls ee 8 TECHNICAL SPECIFICATIONS 222cectysg44 s9ecseue betis sabe yea oe 8 INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS 9 DISPOSAL OF
5. er or submerge it in water or another liguid Only use the appliance for slicing food excluding hard baked goods frozen food food in plastic or aluminium foils meat with bones fruit with hard stones etc Before every use check that the slicing disc is properly attached to the appliance For pushing food against the cutting disc use only the food pusher supplied with this appliance Do not touch the rotating cutting disc If food gets stuck on the cutting disc clean it using a plastic spatula Before cleaning the appliance turn it off and disconnect it from the power outlet Do not insert your fingers or any other items such as knives forks etc between the slice thickness adjustment plate and the slicing blade Check that the cutting disc has come to a complete stop before taking away the food The maximum time of non stop operation is 5 minutes After 5 minutes of operation leave the appliance idle for 15 minutes Always disconnect the appliance from the power socket if you will not be using it and if you are leaving it without supervision before assembly disassembly or cleaning Do not disconnect the appliance from the power socket by pulling on the power cord This could damage the power cord or the power socket Disconnect the cord from the power socket by gently pulling out the plug of the power cord Pay increased attention when handling the cutting disc to prevent injury caused by the blade If the power cord is damaged have
6. is does not have any effect on the functionality of the food slicer 5 Turn off the food slicer by releasing switches AG and AG 6 Before taking away slices or remains of sliced food ensure that the cutting disc AG has come to a complete stop 7 After finishing using the appliance disconnect it from the power socket EN Copyright 2012 Fast R a s Revision 10 2012 Electric Food Slicer SFS 1000WH SFS 1001GR SFS 1070WH SFS 1071GR CLEANING AND MAINTENANCE e Before cleaning the appliance always turn it off and disconnect it from the power outlet Using the thickness adjustment dial A set the plate A to position 0 mm e After each use remove any food remains from the food slicer Clean parts that come into contact with food using a wiping cloth dipped in clean water and then dry with a wiping cloth e Fora more thorough clean disassemble the food pusher AG the sliding plate AU and the cutting disc AG Clean these parts using warm water and kitchen detergent Then thoroughly rinse under flowing water and dry them Note CA Disassemble the slicing blade A by turning the mounting centre A clockwise and removing it from the drive AG A Attention Pay extra attention when handling the cutting disc AG Do not touch the blade to avoid injury e Before using again assemble the appliance according to the instructions in chapter Assembling the electric food slicer e Wipe the outer surface of the dr
7. ive unit and the base plate using a dry wiping cloth e For cleaning do not use thinners solvents or cleaning agents that cause abrasion STORAGE e Ifyou will not be using the appliance store it in a dry place out of children s reach TECHNICAL SPECIFICATIONS Nominal voltage FANG Ounae 220 240 V Nominal fregqUenCy sauna REE aAA PE ea E a EAE E ARAE EENAA 50 Hz Rated power NP 100 W Safety class for electric shock protection rita II PTS AE EEEE A stig A 69 dB A The declared noise emission level for this appliance is 69 dB A which represents level A of the acoustic power relative to the reference acoustic power of 1 pW Glossary of technical terms Safety class for electric shock protection Class II Electric shock protection is provided by double or heavy duty insulation Changes to text and technical parameters are reserved Copyright 2012 Fast R a s Revision 10 2012 Electric Food Slicer SFS 1000W H SFS 1001GR SFS 1070WH SFS 1071GR INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS Dispose of packaging material at a public waste disposal site DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EOUIPMENT The meaning of the symbol on the product its accessory or packaging indicates that this product shall not be treated as household waste Please dispose of this product at your applicable collection point for the recycling of electrical amp electronic equipment waste A
8. lice thickness adjustment plate AG with a damp cloth and then dry using a kitchen town Attention Be careful when handling the cutting disc AG to prevent injury caused by the blade ASSEMBLING THE ELECTRIC FOOD SLICER 1 Place the food slicer on an even dry and stable surface e g on a kitchen workbench 2 Tilt the base plate A into the horizontal position take out the food tray A and place it next to the food slicer 3 Secure the cutting blade AO to the drive unit A by rotating the mounting centre AG counter clockwise until it stops Attention When handling the cutting disc use the central fastener AG Do not touch the blade to avoid injury 4 Using the thickness adjustment dial A set the plate A to position O mm Attach the thumb guard AQ to the sliding plate AG Set the sliding plate AG onto the hinged base plate AD according to image C so that the protrusions found on the bottom of the sliding plate AG slide into the guide groove of the hinged base plate AGD The sliding plate A is correctly seated when it can freely move back and forward From the side insert the food pusher A on to the thumb guard A EN 5 Copyright 2012 Fast R a s Revision 10 2012 Electric Food Slicer SFS 1000WH SFS 1001GR SFS 1070WH SFS 1071GR 5 Now the food slicer is ready for use USING THE ELECTRIC FOOD SLICER 1 Using the controller A 2 set the plate AQ to the required position
9. lternatively in some states of the European Union or other European states you may return your products to your local retailer when buying an eguivalent new product The correct disposal of this product will help save valuable natural resources and help in preventing the potential negative impact on the environment and human health which could be caused as a result of improper liguidation of waste Please ask your local authorities or the nearest waste collection centre for further details The improper disposal of this type of waste may fall subject to national regulations for fines For business entities in the European Union If you wish to dispose of an electrical or electronic device request the necessary information from your seller or supplier Disposal in other countries outside the European Union If you wish to dispose of this product request the necessary information about the correct disposal method from local government departments or from your seller This product meets all the basic EU regulation reguirements that relate to it Copyright 2012 Fast R a s Revision 10 2012 Electric Food Slicer SFS 1000WH SFS 1001GR SFS 1070WH SFS 1071GR EN 10 Copyright 2012 Fast R a s Revision 10 2012
Download Pdf Manuals
Related Search