Philips M8881B
Contents
1. and range by approximately 60 gt Eco mode Eco mode Eliminates radiation in standby mode causes 2 seconds ring delay 50 shorter standby time gt ECO mode Call barring Prevents unwanted outgoing calls to selected numbers gt Call barring SW Technical data Battery e Philips 2 x AAA NiMH 1 2 V Rechargeable 550 mAh batteries Use only the supplied batteries Adapter e MEIC MN A075 U056 Input 100 240 V 50 60 Hz 200 mA Output i 6 5 V 300 mA 1i 7 5 V 200 mA Phonebook with 250 entries Call log with 50 entries Talk time 18 hours Standby time 250 hours e You can install a DSL digital subscriber line filter to prevent noise and caller ID problems caused by the Note DSL interference e You can find the Declaration of Conformity on www p4c philips com va Frequently asked questions No signal bar is displayed on the screen e The handset is out of range Move it closer to the base station e If the handset displays Register your Handset register your handset See the section on Register additional handsets If fail to pair register the additional handsets to the base station what do do A Your base memory is full Press Then press pa E to select 7 gt Unregister to unregister the v unused handsets and try again have chosen a wrong language which cannot read what do do 1 Press A to go back to the2. standby screen 2 Press to access the main menu screen 3 Press ga Ep to select 0 then you see one of the following texts appear on the screen Language Langue Sprache Lingua 4 Select it to access the language options 5 Select your own language My handset is in searching status what do do e Make sure that the base station has power supply e Register the handset to the base station e Move the handset closer to the base station cannot change the settings of my voice mail what do do The voice mail service is managed by your service provider but not the phone itself Contact your service provider to change the settings No display e Make sure the batteries are charged e Make sure there are power and phone connections The handset on the charger does not charge e Make sure the batteries are inserted correctly e Make sure the handset is placed properly on the charger The LED at the back of the handset flashes once e Make sure the docking tone setting is turned on When the handset is placed correctly on the charger you can hear a docking tone e The charging contacts are dirty Disconnect the power supply first and clean the contacts with a damp cloth e Batteries are defective Purchase new ones with the same specifications Bad audio crackles echo etc e The handset is nearly out of range Move it closer to the base station e The phone receives interference from the nearb
3. Register your product and get support at www philips com welcome M8388 Short user manual PHILIPS Important safety instructions Warning e Make sure the baby unit and the cord are always The Electrical network is classified as hazardous The out of reach of the baby at least 1 metre 3 feet only way to power down the charger is to unplug the power supply from the electrical outlet Ensure that the electrical outlet is always easily accessible Refer to safety information before using the product This product complies with European R amp T TE directive 1999 5 EC Use only the power supply listed in the user instructions Use only the batteries listed in the user instructions Do not allow the product to come into contact with liquids Risk of explosion if battery is replaced by an incorrect type Dispose of used batteries according to the instructions When the handset rings or when the handsfree is activated keep the handset away from your ear to avoid hearing damage When using the phone as a baby monitor e Children should be supervised to ensure that they do not play with the appliance away Keep the parent unit at least 1 5 metres 5 feet away from the baby unit to prevent acoustic feedback Never place the baby unit inside the baby s bed or playpen Never cover the parent unit and the baby unit with anything e g a towel or blanket Always make sure the cooling vents of the baby unit are fr
4. and hold o Enter a space 2a Switch upper lower case press and hold lt gt Left right Loudspeaker back side Display icons lt gt J a W ce fae Hint S 1 gt SI Microphone Find handset back side Main menu icons Alarm Phonebook Services K Sounds eyPhone setup e Baby monitor Display ke Answer machine Display icons at The number of bars indicates the connection status between the handset and base station The more bars are shown the better the signal strength is It remains steadily on beside the unread missed call record when browsing the call log C lt lt flashes when there is a new missed call It remains steadily on when browsing missed calls in call log O The alarm is activated o d The silent mode is set but is outside of active period ad he speaker is on d The ringer is off The silent mode is set and within active period the phone does not ring Answering machine it flashes when there is a new message It displays when the telephone answering machine is turned on Voice messages indicator flashes for new messages is steady for reviewed messages This is network dependent ECO The ECO mode is activated ECO The ECO mode is activated mm Connect em Get started Configure your phone 1 The batteries are pre installed in the handset Pull the battery tape off from the battery doo
5. ee This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety If you place the parent unit next to a transmitter or other DECT appliance e g a DECT telephone or wireless router for the internet the connection with the baby unit may be lost Move the baby monitor further away from the other wireless appliances until the connection is restored This baby monitor is intended as an aid It is not a substitute for responsible and proper adult supervision and should not be used as such E Overview In call Enter the option menu K Change the sound profile gak Adjust the volume ws Recall network dependent End calls Turn the speaker on off amp Mute unmute the microphone a aEnter a pause press and hold In menu Confirm Select Enter the option menu OK Cancel mE Up down SS Bat menu Standby E Access the main menu Access the redial list Phonebook Ee Call log v a Make and receive calls nt Make intercom call press and hold Multi handset version only o Lock unlock the keypad press and hold Make and receive calls through the speaker In text input Delete a character Delete all characters press
6. r before charging 2 When using your phone for the first time you see a welcome message country dependent 3 Set the country and language if prompted 4 Set the date and time e If the time is in 12 hour format press p E to select am or pm country dependent Charge your phone Charge 8 hours Charge your handset by docking it in either direction The LED at the back of the handset flashes once m gt 84 E 68 84 Cm 52 68 Flashing low battery C 36 52 C B 18 36 C lt 18 7 Enjoy Phonebook Add record 1 Press gq gt Option gt Add new 2 Follow on screen instructions Call from the phonebook 1 Press ga 2 Select a record and press Py Direct access memory You have 9 direct access memories Keys 1 to 9 To dial the saved phone number automatically press and hold on the keys in standby mode Depending on your country keys 1 and 2 are preset to the voice mail number and information service number of your service provider respectively network dependent Call log Call from the call log 1 Press F gt Incoming calls 2 Select a record and press Ps View record 1 Press E gt Incoming calls 2 Select a record and select Option gt View Save record 1 Press gt Incoming calls 2 Select a record and select Option gt Save number 3 Follow on screen instructions Delete record Ee 1 Press F gt Incoming call
7. s 2 Select a record and select Option gt Delete 3 Follow on screen instructions Redial list Call from the redial list 1 Press Redial 2 Select a record and press Ry Save record 1 Press Redial 2 Select a record and select Option gt Save number 3 Follow on screen instructions Delete record 1 Press Redial 2 Select a record and select Option gt Delete 3 Follow on screen instructions Telephone answering machine Record an announcement 1 Press Menu A 2 Press pa jee to select ee gt Announcement 3 Follow on screen instructions Listen to the incoming messages Select Menu gt gt Play then press OK to confirm Delete an incoming message 1 When you listen to the message press Option to enter the options menu 2 Select Delete then press OK to confirm Register additional handsets You can register additional handsets to the base station 1 Select Menu 2 Press pa E to select F gt Register 3 Press and hold on the base station for 5 seconds 4 Enter the system PIN passcode 0000 5 Press OK to confirm the PIN passcode amp Registration is complete in less than 2 minutes ia earn more Silent mode Sets time during which the phone will not ring K gt Silent mode MySound Customizes the sound of voices to your liking K gt MySound Eco mode Reduces power consumption transmission power reduces radiation
8. y electrical appliances Move the base station away from them e The phone is at a location with thick walls Move the base away from them The handset does not ring Make sure the handset ringtone is turned on The caller ID does not display e The service is not activated Check with your service provider e The caller s information is withheld or unavailable www philips com support For information refer to the extended user documentation online PHILIPS CE 0168 When this crossed out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002 96 EC 2013 WOOX Innovations Limited All rights reserved Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N V and are used by WOOX Innovations Limited under license from Koninklijke Philips N V iy AO 05_EN_V2 0 WK13361
Download Pdf Manuals
Related Search