Blade EFLH1527
Contents
1. E flite ADVANCING ELECTRIC FLIGHT e Locate the four training gear rod to landing skid attachments Snap the attachments to the landing skids as shown below Installing the Optional Training Gear If the Blade SR is your first single rotor and or collective pitch equipped helicopter model we suggest that you install the optional Training Gear Set EFLH1527 before making your first flight The training gear helps to further increase the stability of the model while also providing added support and cushioning to prevent tip overs and damage to the model from abrupt landings Installing the training gear takes only a few minutes following these steps e The training gear set includes four plastic balls four ball grommets four training gear rods four rod end caps four training gear rod to landing skid attachments and one training gear rod mounting base AnH rera e After installing all four attachments locate the four training gear rods and rod mounting base Note that the rod mounting base has a coned shape to it The pointed side of the base will face upward toward the bottom of the helicopter when properly installed The base also has two different angles where the gear rods attach It is important to orient the base so that the large angle is facing forward and backward e Carefully pass each of the rods through the holes in the attachments on the landing2. skids and into the channels on the base The rods will pass through the front holes of the forward attachments and the back holes of the rear attachments You may find it necessary to apply some light pressure to the rods base and landing skids when installing all four rods in the base This is typical however take care to not damage any of the parts Once all four rods are installed note that the landing skids may be pulled slightly inward under their pressure This is also typical as the pressure helps to keep the training gear in place e Check the fitment of the plastic balls on the training gear rod Adjust the position of the grommets that were factory installed on each rod until they are just touching each plastic ball The grommets should then be positioned so that the ball can spin freely on the rod without too much movement side to side between the keepers Your Blade SR is now ready for flight with the training gear installed 2010 Horizon Hobby Inc 4105 Fieldstone Road Champaign IL 61822 USA Horizon Hobby UK Units 1 4 Ployters Rd Staple Tye Harlow Essex CM18 7NS United Kingdom Horizon Hobby Deutschland GmbH Hamburger Strasse 10 25335 Elmshorn Germany Printed 11 09 17499
Download Pdf Manuals
Related Search