Ergotron DM10-1006-1
Contents
1. bl 888 61 092 G 00 rev A 12 13 6 of 13 CONCRETE gt 4 102mm c G E U L 60 66 1524 1676 mm 60 66 1524 1676 mm WARNING Mounting holes must be at least 3 1 8 80mm deep and must be located within solid concrete not mortar or covering material 60 66 If you drill into an area of concrete that is not solid reposition 1524 1676 mm mounting holes until both anchors can be fully inserted into solid concrete 5x 5X M6 x 70mm A WARNING Anchors that are not fully set in solid concrete will not support the applied load resulting in an unstable unsafe condition which could lead to personal injury and or property damage Consult a construction professional if you have any doubt about what this means in regard to your particular situation 888 61 092 G 00 rev A 12 13 7 of 13 ENGLISH Wn W au CJ le a ja e i NS 2x Om M4 x 8mm PENTA M Mo Place wrench in Cable Restraint and run power cable through as shown NOTE You can push up to 3 3 id feet 1 m of excess power cord up into the unit for storage Li g 888 61 092 G 00 rev A 12 13 8 of 13 hy NOTE To keep door unlocked pull key out while AA unlocked 888 61 092 G 00 rev A 12 13 NOTE Tablet screen should face the wall c G U L 10 Tablet Charging To begin charging the tablets plug in the powe2. 1 2 13 mm 888 61 092 G 00 rev A 12 13 2 of 13 1 Mounting Considerations Space Requirements Minimum space needed when removing front cover for service access only 24 If 24 610 mm is not available unit can be removed from When mounting to wood stud at least one screw in the upper mounting i i the wall for service if needed bracket must be installed in a stud preferably the center hole 610 mm 43 2 1098 mm 5 7 11 8 5 7 4 10 254mm 145 mm 300mm 145mm 10 254mm 102 mm 1 minimum space needed on both sides 3 6 for removing tablets 142 mm Mounting Holes uia 30 4 553 mm 772 mm 28 8 732 mm Recommended Minimum Mounting Mounting Height Above Work surface 76 am Y W 4 Recommended 102 mm Worksurface Maximum Tablet Size and Weight TS O 60 66 including case i 1524 1676 mm lt 10 2 259 mm Recommended Mounting Height p Above Floor a lt 7 9 A lt 2 4 Ibs 201 mm 1 1 kg Floor m K al lt 0 9 23 mm 2 WOOD AND HOLLOW WALL K CONCRETE gt 4 2102mm 888 61 092 G 00 rev A 12 13 3 of 13 c G E U L I 4 iU d LL 2 WOOD AND HOLLOW WALL 60 66 1524 1676 mm C hy NOTE The stud can be located at one of five mounting holes on the top bracket While the p first option center hole of bracket is recommended for most case
3. Tablet Management Wall Mount 10 ERGOTRON for iPad www ergotron com USA 1 800 888 8458 N Europe 31 0 33 45 45 600 amp China 86 769 86018920 Made for iPad Table of Contents Hazard Symbols Review amp Safety sss 2 Components 070 NER ER 2 Mounting Considerations eene 3 lr 9 3 8 Wood Stud AUT ACIINICH Doresensecere ruine ie reste 4 Concrete Attachment eere 6 Charging anid S BITTE eset ERI IE THER UERRRIQ 10 11 A lt 24lbs 11 kg Cleaning and Maintenance nnnnnn 12 CAUTION DO NOT EXCEED MAXIMUM LISTED SIDE CHIIC AION AE A A E E den 13 WEIGHT CAPACITY SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR Service and Warranty Information ss 13 For service and warranty visit www ergotron com Apple iPad iPad Air iPad mini Retina iTunes Lightning and Macintosh are trademarks of Apple Inc registered in the U S and other countries Made for iPad means that an electronic accessory has been designed to connect specifically to iPad and has been certified by the developer to meet Apple performance standards Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards Please note that the use of this accessory with iPad may affect wireless Reduce Reuse Recycle 888 61 092 G 00 rev A 12 13 1 of 13
4. Hazard Symbols Review Symbol Signal Word Level of Hazard These symbols alert users of a safety condition that demands attention All users should be able to NOTE A NOTE indicates Important information that helps you make better use of this product recognize and understand the significance of the fol lowing Safety Hazards if encountered on the product or within the documentation Children who are not A CAUTION indicates either potential damage to CAUTION hardware or loss of data and tells you how to avoid the able to recognize and respond appropriately to Safety problem Alerts in not use this product without adult AWARNING indicates either potential for property dam supervision age personal injury or death An Electrical indicates an impending electrical hazard ELECTRICAL which if not avoided may result in personal injury fire and or death Safety WARNING Because surfaces vary widely and the ultimate mounting method is out CAUTION Make sure the wall mount bracket of Ergotron s control it is imperative that you consult with appropriate engineering is level flush and snug to the wall surface architectural or construction professional to ensure that your Ergotron mounting DO NOT OVERTIGHTEN THE BOLTS solution is mounted properly to handle applied loads 4 Components a EE RN M6 x 70mm M4 x 8mm M4x8 2x Om PENTA Stud Finder 10mm WOOD CONCRETE E75 3 16 5 mm RL J 3 8 10 mm
5. 5 x 26 4 x 7 0 92 6 x 67 0 x 17 7 cm Shipping weight 43 Ib 19 5 kg Power system Input 100 240V 2 0A 50 60 Hz Environmental Temperature range Operating 0 to 30 C 32 to 86 F Storage 40 to 60 C 40 to 140 F Relative humidity maximum Operating 1096 9096 non condensing Storage 596 9596 non condensing Altitude maximum 2000 m 6 562 ft Compatibility Model DM10 1006 X Made for iPad 3rd generation iPad 2 iPad Model DM10 1007 X Made for iPad Air iPad 4th generation iPad mini with Retina display iPad mini Service and Warranty For Service on the Ergotron Tablet Management Wall Mount Charging Station for iPad Visit www ergotron com y 9 NOTE When contacting customer E service reference the serial number www ergotron com MADE IN CN 12 345 678 LUTEA TET UY 1234567 1234 emen Americas Sales and Corporate Headquarters EMEA Sales St Paul MN USA O 2013 Ergotron Inc PIT gins reserved Amersfoort The Netherlands 888 61 092 G 00 rev A 12 13 While Ergotron Inc makes every effort to provide accurate and complete information on the installation and use of its products it will not be held liable for any editorial errors or omissions including those made in the process of translation from English to another language or for incidental special or consequential damages of any nature resulting from furnishing this in
6. Tunes or the Apple Configurator program available for the Macintosh computer Please reference www Apple com for more information NOTE The devices will not charge while syncing is in process To return to charge mode unplug the USB cable from the TM Wall Mount 10 USB port when syncing is complete un The iPad devices will mount as USB devices when the A to B USB cable not USB Type A included is connected to a host notebook via the USB port on the bottom of the TM Wall Mount 10 USB Type B If using iTunes please see separate iTunes setup instructions available on the Ergotron website Tablet Management Wall Mount 10 product page 888 61 092 G 00 rev A 12 13 11 of 13 7 Cleaning and Maintenance A A AN gt 12 of 13 Equipment Electric Safety There are specific risks associated with the use of equipment having power cables You must be aware of and avoid these risks when this product is located in close proximity to children WARNING Failure to observe the following Electrical Safety notices can result in fire or death by electric shock Electrical cables can be hazardous Misuse can result in fire or death by electrical shock Double Pole Neutral Fusing e Inspect power cables thoroughly before each use e Do not use cables that are damaged e Insert the plug completely into the outlet e Grasp the plug to remove from the outlet e Do not unplug by pulling on the cable e Do not us
7. e excessive force to make connections e Do not plug the cable into an extension cable e Do not remove bend or modify any metal prongs or pins of cabel Do not drive drag or place objects over the cable e Do not walk on the cable Avoid overheating Uncoil the cable and do not cover it with any material e Do not run cable through doorways holes in ceilings walls or floors Keep this product away from water e Do not use it when wet Do not place this product in close proximity to flammable liquids or gases This product is intended for use only with loading as indicated Use with loads greater than indicated may result in instability causing possible injury The power cord acts as the connect disconnect device switching power off and on The socket outlet shall be installed near the equipment and shall be easily accessible CAUTION Changes or Modifications not expressly approved by Ergotron could void the user s authority to operate the equipment Use Safety There are specific risks associated with the use of this product for charging or storage You must be aware of and avoid these risks when this product is located in close proximity to children WARNING Failure to observe the following Use Safety notices may result in serious personal injury or equipment damage Only Adults should use this product Do not allow anyone to climb or hang on this product Do not block the fans and vent openings To prevent overheating l
8. eave at least 127 mm 4 inch clearance around fans and vents This product is designed to be used indoors only e Do not use this product to store equipment other than what has been noted in this guide Do not use this product to store liquids or cleaning supplies Do not place heavy objects on this product The maximum weight capacity is 24 Ibs 11 kg TABLET MANAGEMENT WALL MOUNT ERGOTRON 100 240 V 2 04 50 60 Hz This device complies with Part 15 of the FCC Rules Operation is subject to the following two C US 35MR conditions 1 This device may not cause harmful LISTED N13508 interference 2 This device must accept any interference received including interference that may cause undesired operation CAN ICES 3 A NMB 3 A COREL TIAA RRMA CT CORE CK ER CAT CBRE ESE CT CEP HV ET COMAIMMEAAP DS WREBITSLIBRKENSCEPHWETF VCCI A Product of China 888 61 092 G 00 rev A 12 13 Specifications Dimensions 23 2 W x 31 8 H x 4 0 D 59 x 80 9 x 10 2 cm Weight w o equipment 34 5 Ibs 15 7 kg Rated weight capacity 24 Ib 11 kg Maximum tablet size Individual tablet dimensions including cover up to 10 2 H x 7 9 W x 0 9 D 25 9 x 20 1 x 2 3 cm Individual tablet weight up to 2 4 Ib 1 1 kg LED status indicators ISI Lights indicate power status and syncing activity 10 LED lights Cooling ventilation One 12 volt DC continuous operation fan in each module Shipping dimensions 36
9. r cord I 4 iU Ll The power cord is used to turn the power on and off Charging occurs whenever the power cord is connected UNLESS a Macintosh or PC notebook USB cable is connected for syncing g W NOTE The power cord acts as the connect disconnect device switching power off and on The socket b outlet shall be installed near the equipment and shall be easily accessible LED Indicators 5 Power Indicator Communicates sync and charge status with the following signals Description No power to the module iPad devices are charging On slow blink Computer is plugged into USB port and iPad devices are ready to sync or are syncing On fast blink Fault Status Please make sure all cables are seated correctly and product is operating within specified operating temperature Can also indicate a failed 30 pin or lightning cable Contact Ergotron Customer Support if problem continues 1 10 Individual Status Indicators ISI Sequentially numbered LEDs 1 10 corresponding to each tablet slot in the unit Light Fully charged Amber 8 Charging in progress MY NOTE If module is syncing all ISIs will be green p 888 61 092 G 00 rev A 12 13 10 of 13 Tablet Syncing 7 NOTE Complete the Tablet Charging instructions before syncing iPad devices rA should be charged at least 50 before starting the syncing process c G U L Syncing can be done using i
10. s you should consult with a construction professional to confirm which method is best suited for your particular situation Options 2 5 are illustrated on the following page in no order of preference y Hole Option 1 RECOMMENDED Center Hole in Stud 888 61 092 G 00 rev A 12 13 4 of 13 STUD LOCATION OPTIONS 2 5 Hole Option 2 Hole Option 3 Hole Option 4 Extreme Left Hole in Stud Extreme Right Hole in Stud Middle Right Hole in Stud Hole Option 5 Middle Left Hole in Stud d 60 66 1524 1676 mm 888 61 092 G 00 rev A 12 13 c C U WOOD AND HOLLOW WALL e Drill the three holes in the top bracket that correspond with the hole option determined on previous page Then drill the two holes in the bottom bracket NOTE Use the 3 16 5 mm drill bit when drilling directly into the wood rA stud Use the 1 2 13 mm drill bit when drilling into the hollow wall for the anchors Use hollow wall anchors where ever a screw does not get inserted directly into the wood stud A e SS hy NOTE Bottom Bracket mounting holes will always line up vertically with the rA center mounting hole in the Top Bracket WOOD STUD I 4 iU LL 3 16 5 mm M6 x 70mm A HOLLOW WALL 1x qu ccm 1524 1676 mm 1 2 13 mm 5 32 G 1 4 20 x 2 f g Attach brackets to wall according to the hole option determined on previous page
11. struction and performance of equipment in connection with this instruction Ergotron Inc reserves the right to make changes in the product design and or product documentation without notification to its users For the most current product information or to know if this document is available in languages other than those herein please contact Ergotron No part of this publication may be reproduced stored in a retrieval system or transmitted in any form or by any means electronic mechanical photocopying recording or otherwise without the prior written consent of Ergotron Inc 1181 Trapp Road Eagan Minnesota 55121 USA Patents Pending and Patented U S amp Foreign Ergotron is a registered trademark of Ergotron Inc 800 888 8458 1 651 681 7600 www ergotron com sales ergotron com 31 33 45 45 600 www ergotron com info eu ergotron com APAC Sales Worldwide OEM Sales Tokyo Japan www ergotron com apaccustomerservice ergotron com www ergotron com info cem ergotron com 13 of 13 c G U L
Download Pdf Manuals
Related Search