Nokia BH-110
Contents
1. affected by for example device settings features being used battery condition and temperature If the battery has not been used for a long time to begin charging you may need to connect the charger then disconnect and reconnect it If the battery is completely discharged it may take several minutes before the charging indicator is displayed When your charger is not in use unplug it from the electrical plug and the device Do not leave a fully charged battery connected to a charger as overcharging may shorten the battery s lifetime If left unused a fully charged battery will lose its charge over time Always keep the battery between 15 C and 25 C 59 F and 77 F Extreme temperatures reduce the capacity and lifetime of the battery A device with a hot or cold battery may not work temporarily Do not dispose of batteries in a fire as they may explode Dispose of batteries according to local regulations Recycle when possible Do not dispose as household waste Use the charger for its intended purpose only Improper use or use of unapproved chargers may present a risk of fire explosion or other hazard and may invalidate any approval or warranty If you believe the charger is damaged take it to a service centre for inspection before continuing to use it Never use a damaged charger Only use the charger indoors Take care of your device Handle your device charger and accessories with care The following suggestions help y2. to both phones Handle calls from two phones If your headset is connected to two phones you can handle calls from both at the same time End an ongoing call and answer a call on another phone Press Put an ongoing call on hold and answer a call on another phone Press and hold for 2 seconds Switch between active and held calls Press and hold for 2 seconds End an ongoing call and activate a held call Press If you redial or use voice dialling the call is made on the phone you last had an active call on with the headset Clear device pairings 1 To switch the headset off press and hold for 5 seconds 2 Press and hold for 9 seconds The headset beeps twice and the red and green indicator lights alternate After the pairings are cleared the headset enters pairing mode Product and safety information Battery and charger information This device has an internal nonremovable rechargeable battery Do not attempt to remove the battery from the device as you may damage the device This device is intended for use when supplied with power from the following chargers AC 11 AC 3 AC 8 AC 15 DC 4 DC 9 The exact charger model number may vary depending on the type of plug The plug variant is identified by one of the following E X AR U A C K or B The battery can be charged and discharged hundreds of times but it will eventually wear out Talk and standby times are estimates only Actual times are
3. Nokia Bluetooth Headset BH 110 User Guide Issue 1 0 Introduction About vour headset With the Nokia Bluetooth BH 110 headset you can handle calls hands free even when you are using two phones at the same time The surface of this product is nickel free Warning This product may contain small parts Keep them out of the reach of small children Parts of the product are magnetic Metallic materials may be attracted to the product Do not place credit cards or other magnetic storage media near the product because information stored on them may be erased Read this user guide carefully before using the product Also read the user guide for the device that you connect to the product About Bluetooth connectivity You can use Bluetooth to make a wireless connection to other compatible devices such as mobile phones Devices do not need to be in direct line of sight but they must be within 10 metres 33 feet of each other The connection may be affected by obstructions such as walls or other electronic devices This device is compliant with Bluetooth Specification 2 1 EDR supporting the following profiles Headset Profile HSP 1 1 Handsfree Profile HFP 1 5 Check with the manufacturers of other devices to determine their compatibility with this device Get started Keys and parts MM O 1 Charger connector 2 Indicator light 3 Microphone 4 Multifunction key 5 Earpiece 6 Earloop C
4. accumulators must be taken to separate collection at the end of their working life This requirement applies in the European Union Do not dispose of these products as unsorted municipal waste For more environmental information see the product Eco profile at www nokia com ecoprofile 9 Copyright and other notices DECLARATION OF CONFORMITY Hereby NOKIA CORPORATION declares that this BH 110 product is in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC A copy of the Declaration of Conformity can be found at http www nokia com phones declaration of conformity O 2011 Nokia All rights reserved Nokia Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation The Bluetooth word mark and logos are owned by the Bluetooth SIG Inc and any use of such marks by Nokia is under license The availability of products may vary by region For more information contact your Nokia dealer This device may contain commodities technology or software subject to export laws and regulations from the US and other countries Diversion contrary to law is prohibited Issue 1 0 EN
5. ed Switch off Press and hold for 5 seconds The headset beeps and a red indicator light flashes once All active calls are ended If not connected to a device within 30 minutes the headset switches off Pair and connect the headset to your phone Before using the headset you must pair and connect it to a compatible phone 1 To switch the headset off press and hold for 5 seconds 2 Switch on the phone to pair with 3 Ifyou have never paired the headset with a device or you have cleared the pairings switch the headset on If you have previously paired your headset with a device press and hold for 5 seconds Pairing mode is activated and a green indicator light starts to flash quickly 4 Within 3 minutes activate Bluetooth on the phone and set it to search for Bluetooth devices For details see the user guide of the phone 5 Select the headset from the list of found devices 6 If required enter the passcode 0000 You can pair your headset with 8 compatible phones but you can only connect it toa maximum of 2 phones at the same time With some phones you may need to make the connection separately after pairing Wear the headset If you want to use the headset with the earloop attach the earloop to the headset To detach the earloop gently pull it from the headset Slide the earloop behind your ear and gently push the earpiece against your ear Carefully bend the earloop around your ear for the bes
6. harge the battery Before using the headset you must charge the battery n Warning Use only chargers approved by Nokia for use with this particular model The use of any other types may invalidate any approval or warranty and may be dangerous Use of unapproved chargers may present a risk of fire explosion or other hazard 1 Connect the charger to a wall outlet 2 Connectthe charger cable to the charger connector on the headset The red indicator light turns green when the battery is fully charged 3 Disconnect the charger from the headset then from the wall outlet When you unplug a charger hold and pull the plug not the cord The fully charged battery has power for up to 6 hours of talk time or up to 120 hours of standby time When the battery charge is low the headset beeps every 5 minutes and the red indicator light flashes When the battery is charging the red indicator light is on Check the battery charge Make sure the headset is switched on and press A green light indicates a sufficient charge level If the light is yellow you may need to recharge the battery soon If the light is red recharge the battery Switch the headset on or off Switch on Press and hold for 2 seconds The headset beeps and a green indicator light flashes once The headset connects to the last connected device If you have never paired the headset with a device or you have cleared the pairings pairing mode is activat
7. ou protect your warranty coverage Keep the device dry Precipitation humidity and all types of liquids or moisture can contain minerals that corrode electronic circuits If your device gets wet allow the device to dry Do not use or store the device in dusty or dirty areas Moving parts and electronic components can be damaged Do not store the device in high temperatures High temperatures can shorten the life of the device damage the battery and warp or melt plastics Do not store the device in cold temperatures When the device warms to its normal temperature moisture can form inside the device and damage electronic circuits Do not attempt to open the device Unauthorised modifications may damage the device and violate regulations governing radio devices Do not drop knock or shake the device Rough handling can break internal circuit boards and mechanics Only use a soft clean dry cloth to clean the surface of the device Do not paint the device Paint can clog moving parts and prevent proper operation Recycle Always return your used electronic products batteries and packaging materials to dedicated collection points This way you help prevent uncontrolled waste disposal and promote the recycling of materials A Crossed out wheeled bin symbol The crossed out wheeled bin symbol on your product battery literature or packaging reminds you that all electrical and electronic products batteries and
8. t fit Point the headset towards your mouth Make and receive calls To make and receive calls using your headset you need to connect it to your phone Make a call Make a call in the normal way Answer a call Press End a call Press Reject a call Press twice Switch a call between your headset and phone Press and hold for 2 seconds You can redial the last called number or use voice dialling if your phone supports these features with the headset Redial the last called number When no call is in progress press twice Use voice dialling When no callis in progress press and hold for 2 seconds and follow the instructions in the user guide of your phone Change the volume Set the desired volume level on your connected phone The selected volume level is saved as the minimum volume level for the phone that is currently connected to the headset Pair and connect the headset to two phones When you use the headset for the first time it automatically connects to your phone You can also connect your headset to another phone and manage calls from for example both your personal and your work phone at the same time 1 To switch the headset off press and hold for 5 seconds 2 To activate pairing mode press and hold for 5 seconds and pair the headset with the second phone 3 Make sure Bluetooth is activated on both phones and switch the headset off and back on The headset connects
Download Pdf Manuals
Related Search