EK Water Blocks EK-FC R9-290X Reinforcer
Contents
1. ekwbD Installation and mounting manual for EK FC R9 290X Reinforcer This product is intended for installation only by expert users Please consult with a qualified technician for installation Improper installation may result in damage to your equipment EK Water Blocks assumes no liability whatsoever expressed or implied for the use of these products nor their installation The following instructions are subject to change without notice Please visit our web site at www ekwb com for updates Before installation of this product please read important notice disclosure and warranty conditions printed on the back of the box p pam Innan ox E ARN E Oai k apent ei o ERRE W 9 SSIS A NDUI wni ew e EK FC R9 290X Reinforcer is very easy to install This step will show how to install the reinforcer without using the EK FC R9 290X Backplate 1 Install EK FC R9 290X series water block according to its installation manual in case you haven t done so yet 2 Install the Reinforcer over the water block align the three mounting holes and secure the Reinforcer to the graphics car I O bracket with enclosed M3x4 ISO7380 screws using enclosed Allen key 2mm 3 Finish the installation by using M3x6 DIN7985 screw plastic washer and a M3 nut to secure the back end of the Reinforcer to the graphics card circuit board Tighten the screw using Philip head screwdriver Alternatively it is possible to use both EK FC R9 2902. X Backplate and Reinforcer at the same time This step will show how to install the Reinforcer using the EK FC R9 290X Backplate 1 Install EK FC R9 290X series water block and EK FC R9 290X Backplate according to its installation manual in case you haven t done so yet 2 Install the Reinforcer over the water block align the three mounting holes and secure the Reinforcer to the graphics car I O bracket with enclosed M3x4 ISO7380 screws using enclosed Allen key 2mm as shown in STEP 2 3 Finish the installation by using M3x4 DIN7985 screw to secure the back end of the Reinforcer to the graphics card circuit board Tighten the screw using Philip head screwdriver REQUIRED TOOLS Philips head screwdriver All disclosures notices and warranty conditions are being written on the back on EKWB website Revision 1 0 Released on 17 of February 2014
Download Pdf Manuals
Related Search