Chief SLB296 mounting kit
Contents
1. INSTALLATION INSTRUCTIONS SSB 296 SSM 296 SLB 296 and SLM 296 Interface Brackets SSB 296 SSM 296 SLB 296 and SLM 296 Interface Brackets are designed for use with Chief Series Projector Mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 4 Screw Phillips Flat Head Machine M4 x 25mm 4 10 24 Thumb Nuts 4 Spacer 500 x 316 x 500 1 All Points Security Kit 1 5 32 Security Hex Key ba amp Towards front of projector DDN Towards front of projector SLB 296 SLM 296 Note SSM style interface bracket connections are circled Note SSB style interface bracket connections are circled Only used when installing SLB SSB interface brackets NOTE Specific to SSB style and SSM style interface bracket installation All appropriate screws come pre installed in the circled locations above DO NOT attempt to substitute and USE ONLY this pre installed hardware for SSB style and SSM style interface bracket installation Installation Instructions WARNING OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SE2. RIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT over tighten screws when installing interface brackets NOTE Step 1 is only required when installing an SLB SSB interface bracket If an SLM SSM bracket is being installed proceed to Step 2 1 Screw thumb screws onto 10 24 x 5 8 Phillips pan head screws DO NOT fully tighten thumb screws at this time 2 Turn projector upside down on a flat surface 3 Place the spacers over the threaded inserts on bottom of projector 4 Place the interface bracket onto the spacers aligning the spacers and mounting holes in the bracket with the threaded inserts in the bottom of the projector and ensuring that triangle in bracket points towards front of projector 5 Position M4 x 25mm mounting screws into the bracket mounting holes spacers and threaded inserts in projector Tighten all fasteners at this time securing the bracket to the projector NOTE Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the All Points Security Kit y A Chief is a registered trademark of Milestone AV Technologies All rights reserved ves hs lt CONSUMER Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions or variations nor d
3. oes it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document AN Chief Manufacturing a products division of Milestone AV Technologies 8800 002116 Rev00 iC ae l f 8401 Eagle Creek Parkway Savage MN 55378 2011 Milestone AV Technologies P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 a Duchossois Group Company Our Mounts Your Vision 08 11
Download Pdf Manuals
Related Search