Pyle PSBT25
Contents
1. GATOR User Manual PSBT25 Waterproof Bluetooth Speaker amp Hands free Speakerphone www PyleAudio com 1 Introduction Thank you for purchasing the PSBT25 Waterproof Bluetooth Speaker a versatile piece of technology that extends the usefulness of many solid state music players and cell phones You now have the convenience of listening to your music or using your cell phone ina wet location Use it when showering taking a bath or relaxing in a sauna while keeping your Bluetooth device safe and dry Please be aware that although for use in wet locations it cannot be immersed in water The Waterproof Bluetooth Speaker features an integral hook for hanging the speaker froma standard shower head a front panel consisting of seven waterproof membrane switches and two water sealed speakers 2 Charging the Battery Before using this product charge the internal battery for 4 hours using the included USB charging cable To do so 1 On the back of the speaker you ll find a watertight seal which protects two electrical power ports Insert a fingernail at the bottom of the seal and lift upward see Power Panel image below LED Indicator Charging Power Out Voltage In Dc 5Vv Power Panel 2 Connect the USB charging cable into the power input receptacle labeled IN 5V located in the center of the Power Panel 3 An LED Indicator will be Red during charging and Green when the battery is fully2. enter 1234 5 Within a few seconds the connection will be complete and the LED Indicator will blink blue every 5 seconds 6 Short press Power Button to reset bluetooth pairing in any case if you need to pair another bluetooth device phone 7 After initial pairing PSBT25 will connect with the Bluetooth device automatically when you turn on speaker 5 Listening to Music Once the speaker has been successfully paired to your music device you can listen to music by using the Play Pause Volume Up Down and Forward Next Back Previous membrane buttons located on the Control Panel 6 Using as a Speakerphone Receive To receive an incoming call press and release the Call Key 2 www PyleAudio com Reject To reject an incoming call press and hold the Call Key J for 1 second Hold To place an active call on hold press and hold the Backward Button i for 1 second Repeat to resume call Transfer To transfer a call from the speaker to your phone press and hold the Forward Button gt for 1 second Redial To redial a number press and hold the Call Key J for 1 second Voice dialing If your phone has a voice dialing feature you can access voice dial from the speaker by pressing and releasing the Call Button to access voice dial 7 Features Waterproof Rated IPX6 Can withstand powerful water jets cannot be immersed in water Bluetooth V3 0 EDR support A2DP HSP HFP and AVRCP Supports wireless audio fo
3. charged 4 After charging remove the charging cable and reseal the protective cover 3 Powering On and Off 1 To turn on press and hold the Power Button See Control Panel image below for 3 seconds A tone will sound and both Red and Blue LEDs will turn on www PyleAudio com Call Key i Answer Reject Mero le Backward Forward Play Pause LED Indicator Low Battery Indicator Volume Up VOUE OWN Power Button Control Panel 2 To turn off press and hold the Power Button for 3 seconds A tone will sound and both LEDs will turn off 3 The speaker system will shut off automatically after being idle for 10 minutes without pairing 4 Please charge the speaker when the low battery indicator flashes in red 4 Pairing with a Bluetooth Enabled Device Please read the full instructions below carefully before pairing your device with the Speaker 1 Pressing and holding the Power Button for 3 seconds you will hear a beeping sound and the LED Indicator on the Control Panel will then flash blue and red It is now in pairing mode and ready to pair with your device 2 Make sure that the Bluetooth is turned ON on your music device phone Scan for a Bluetooth source on your music device phone 3 The speaker will appear on your music device phone by its name GATOR SOUND 4 Select the GATOR SOUND device in most cases it will now connect and pair automatically if you are prompted for a password
4. r use with all Bluetooth enabled devices Bluetooth A2DP wireless audio profile Use as a speakerphone for use with Bluetooth enabled cell phone Bluetooth hands free profile Wireless speakers let you enjoy music with Bluetooth enabled flash music players Echo cancellation and noise suppression Rechargeable battery powers your music players Run time up to 25 hours If the unit has not been used for more than 10 days please charge it before using it 8 Specifications Driver Unit 2 in X 2 in Audio Power Out 3W RMS X 2 Impedance 4 ohms Signal to Noise Ratio 87db Frequency Response 100Hz 17KHz www PyleAudio com
Download Pdf Manuals
Related Search