Scosche NN1642B car kit
Contents
1. panel into the bottom of the kit panel 6441 Snap the A C controls into the lower panel and screw it into the left and right mounting brackets using the original screws Pe Snap the pocket 6446 in place and screw it to the left and right mounting brackets using the screws supplied with the kit Plug in connectors align and mount the stereo to the left and right mounting brackets using the screws supplied with the stereo Snap the new kit panel assembly with stereo into the dash and secure using the original screws If you have a factory CD changer screw it into place and snap the CD changer in place Snap the vent panel into place above the stereo and the horizontal panel into place under the stereo Q 6445 we BRACKET BRACKET LOWER PANEL DOUBLE DIN ISO MOUNT 1 2 3 Snap the 6444 and 6445 left and right mounting brackets to the kit panel 6441 For digital A C controls slide the 6442 lower panel into the bottom of the kit panel 6441 For manual A C controls slide the 6443 lower panel into the bottom of the kit panel 6441 Snap the A C controls into the lower panel and screw it into the left and right mounting brackets using the original screws Plug in connectors align and mount the stereo to the left and right mounting brackets using the screws supplied with the stereo Snap the new kit panel assembly with stereo into the dash and secure using the original screws If you hav2. SCOSCHE NN1642B IN DASH INSTALLATION KIT FOR 2007 UP NISSAN ALTIMA 6445 MOUNTING BRACKET 6446 POCKET 6441 MOUNTING PANEL 6444 MOUNTING BRACKET 6442 LOWER MOUNTING PANEL 6443 LOWER DIGITAL A C MOUNTING PANEL MANUAL A C INTRODUCTION PRELIMINARY This premium installation kit is for 2007 Up Nissan Altima vehicles Included are all the parts you need to mount your car stereo cassette or CD player into your vehicle s dash Refer to the individual instruction in this manual to remove your vehicle s factory radio and assemble the kit CAUTION DISCONNECT YOUR VEHICLE S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP PREVENT ELECTRICAL DAMAGE WE RECOMMEND THE USE OF A VOLT OHM METER OVER A TEST LIGHT TO CHECK WIRING A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE VEHICLE S COMPUTER AND OR DIAGNOSTIC SYSTEMS AVOID ALL FACTORY AIR BAG WIRING AIR BAGS CAN ACCIDENTLY DEPLOY CAUSING SERIOUS INJURY OR DEATH NOTES e See your vehicle s instructions for any special tools your installation might require e Read all instructions accompanying your car stereo for proper wiring and mounting instructions FACTORY WIRING CODES For Factory Wiring Codes go to Www scosche cars com CAR STEREO CONNECTORS PROVIDE EASY CONNECTION OF YOUR CAR STEREO TO FACTORY WIRING HARNESS NNO4 NAA2 2007 Up Nissan 2007 Up Nissan LIABILITY DISCLAIMER This instruction booklet is based on
3. carefully documented data and research of automobile dash disassembly wire harness codes and information pertaining to installation of this NN1642B kit for 2007 Up Nissan Altima vehicles Scosche Industries Inc can not be held responsible for discrepancies inconsistencies that may occur due to the automobile manufacturing changes or options or damage that may occur in the automobile during the installation of components while using this booklet If you have any further questions call our toll free technical help line at 1 800 621 3695x3 2007 SCOSCHE INDUSTRIES INC SI 8 07 NN1642B 3000003 FACTORY STEREO REMOVAL D Qo on Using a panel removal tool pry off the vent panel above the stereo and the small horizontal panel directly under the stereo Remove the 4 Phillips head screws securing the stereo to the dash Save these screws They will be used to install the new kit panel Unplug the connectors and remove the factory stereo If you have a factory CD changer you will also need to pry off the CD changer panel then unscrew and remove the CD changer Unscrew and remove the side brackets from the factory stereo and remove the air conditioning controls STEREO INSTALLATION DIN ISO MOUNT ie Snap the 6444 and 6445 left and right mounting brackets to the kit panel 6441 For digital A C controls slide the 6442 lower panel into the bottom of the kit panel 6441 For manual A C controls slide the 6443 lower
4. e a factory CD changer 6445 e BRACKET gt lt oe g E PZ STEREO j at SSS Zo N Z KGG G lA S A Fafe J 2 GQ gt Y iF KZ ia gj QS Po S A a 3 OR S gt X Ly 2 amp mi R screw it into place and snap O the CD changer in place i Snap the vent panel into place above the stereo and the horizontal panel into place 6444 under the stereo BRACKET LOWER PANEL
Download Pdf Manuals
Related Search