Vantec UGT-CR935 card reader
Contents
1. t ti G re Gu a de instalaci n Guide d installation Installationsanleitung ns a a IOn Ul e Guida all installazione RWUIFA7T F BHR ZRH 5 25 Drive Bay 3 5 Front Panel Device Installation Guide a aay Installation Screws 3 5 Drive Bay T 9 Locate an available 3 5 or 5 25 drive bay where you would like m 1 _ Verify the package contents m 2 Prepare your computer case for installation to install the device 3 5 Front Panel Installation Connect to System 4 Slide the front panel device into your case until the front panel T D Secure the 3 5 front panel device to your computer case with T 3 Proceed to connect the front panel device to your system s 1a LA 3A is flush with the front of your case the provided screws motherboard or expansion card 5 25 Front Panel Installation Connect to System 4 b Slide the front panel device into your case until the front panel T 2b Secure the 5 25 front panel device to your computer case with T 2b Proceed to connect the front panel device to your system s is flush with the front of your case the provided screws mis motherboard or expansion card Connecting Your Front Panel Device SATA and SATA Power Connector A i SATA Power SATA m 20 Pin USB 3 0 or 9 pin USB 2 0 T 5 Make sure all connection are connected well and place the co2. hnologies All Right Reserved All Registered Trademarks Belong To Their Respective Companies
3. ver T 6 Drivers will be automatically detected and installed Your device back on to your case will be ready for use 2x5 10 Pin Diagram shown is the USB 3 0 20 Pin or USB 2 0 10 Pin found on supported motherboards or expansion cards Please refer to your motherboard manufacturer s documentation for the location of these ports Please make sure that the connectors are oriented properly before connecting Incorrect orientation may cause severe damage to your device or electrical shock Molex Power 4 Pin Peripheral 4 Pin Peripheral Molex Converting Your 3 5 Front Panel Device to 5 25 Form Factor If you would like to mount your 3 5 device into your 5 25 drive bay you may do so by using Vantec s HDA 525P 3 5 to 5 25 bay converters Follow the steps below to convert your device form factor to 5 25 LL T 1 _ Prepare the 3 5 to 5 25 front panel converter kit T 2 Slide in the 3 5 front panel device into the front bay converter kit T 2 Secure with the screws provided by the 3 5 to 5 25 front panel until the front panel is flush converter bracket Information in this document is subject to change without notice v1 01 Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden t T Py Printed in China ad Printed on Recycled Paper Copyright 2012 Vantec Thermal Tec
Download Pdf Manuals
Related Search