Havis C-TSM-CHGR-P-1 car kit
Contents
1. Havis Inc 75 Jacksonville Road PO Box 2099 Warminster PA 18974 T 800 524 9900 F 215 957 0729 Productivity in motion www havis com INSTALL INSTRUCTIONS C TSM CHGR X 1 TRUNK SIDE MOUNT FOR 2011 2013 DODGE CHARGER X D DRIVERS SIDE OR P PASSENGER SIDE TOOLS REQUIRED Phillips Screwdriver Powered drill with 5 32 drill bit Jig Saw HARDWARE QTY DESCRIPTION PART 5 10 x 34 Sheet metal screws GSM33195 Always gt Read all instructions before installing any Havis Inc products gt Check for obstructions Wire brake lines fuel tank etc before drilling any holes gt Use hardware provided with install kit C TSM CHGR P 1 shown Trunk Side Mount Passenger Side NOTE This instruction shows the passenger side installation The Drivers side will install the same way or Fo a Fa E oa 7 Pe EET i oP E E Eh E g hiti rr 2 a7 a s E a a ae ae Ae a oe A Cae iM View of Peeve side trunk Remove side cargo hook Remove rear loop trim panel area prior to installation Mount screw to be reused later fastener Phillips screwdriver Remove fender liner Unclip and move wiring at side floor Place Trunk Side Mount frame area Make sure it is repositioned so assembly into position and attach to Run wiring as needed for it will not get damaged inner fender with previously emergency equipment removed Cargo hook screw into Replace fender liner original hole Make sure door has2. clearance at With Trunk Side Mount in Attach lower frame to floor with rear trunk trim panel position drill three 5 32 holes 10 x 3 4 sheet metal screws into floor C TSM CHGR X 1_INST_8 11 Drill 5 32 holes at upper bracket Mount and wire equipment on Finished Passenger Side Mount next to OEM screw and attach with inside door panel shown with full width trunk tray 10 x 3 4 Sheet metal screws a KA Finished C TSM CHGR P 1 Passenger Side Trunk Side Mount Shown with Full Size Spare Tire NOTE If your vehicle has the small donut spare tire the flip up trunk liner should just clear the Trunk Side Mount C TSM CHGR X 1_INST_8 11
Download Pdf Manuals
Related Search