Philips AJT600
Contents
1. Rotate the Second Knob to adjust the minute Press OK on the First Knob to confirm L gt The setting time is displayed un A WN Rotate the Third Knob to CLOCK after setting L gt The hour and minute digits stops blinking Turn on The clock radio turns on automatically once your plugged in 4 Play from Bluetooth device Note e The effective operation range between the Bluetooth speaker and the paired device is approximately 10 meters 30 feet e Keep this Bluetooth speaker away from other electronic devices that may cause interference e Make sure that the Third Knob switches to CLOCK before setting 1 Press SOURCE repeatedly to select on the dlplay panel flashes 2 Activate the Bluetooth function in your Bluetooth device see the device user manual 3 Select AJT600 displayed on your device for pairing Ly f connection is successful the Bluetooth speaker beeps wpe ardo steadily on 4 Start music play on your Bluetooth device L gt f Bluetooth disconnected the music will pause Press gt H on the Bluetooth device to start play again Bluetooth reset In Bluetooth mode press OK on the first knob for over 5 seconds to erase all pairing informations L gt BT RESET displayes on the panel e The Bluetooth speaker enters Bluetooth mode automatically after erase completed 5 Play audio from an external device Note e Make sure that t2. Ch devices through USB e Activate or deactivate alarm timer ble eae ded throug cable not included VOLUME AUDIO IN Agjust volume e Connect an external audio device wm EN 3 Get started Always follow the instructions in this chapter in sequence Connect power The unit can only be powered by supplied AC power Batteries are only used for time and alarm backup if not connected with AC power Option 1 AC power Warning e Risk of product damage Make sure that the power supply voltage corresponds to the voltage printed on the back or the underside of the unit e Risk of electric shock When you disconnect the AC power always pull the plug from the socket Never pull the cord Connect the AC power cord to the wall socket Tip e To save energy turn the unit off after use SS Option 2 Battery power K Caution e Batteries contain chemical substances so they should be disposed of properly e Batteries are not supplied with the accessories bAt shows on the display when the battery level is low 1 Open the battery compartment 2 Insert 2 batteries type 1 5V LR6 AA with correct polarity as indicated 3 Close the battery compartment EN 6 Set time d Rotate the Third Knob to SET TIME to activate clock setting mode L gt Hour and minute digits blinks Rotate the First Knob to adjust the hour
3. org Where the plug of the Direct Plug in Adapter is used as the disconnect device the disconnect device shall remain readily operable WN Warning Never remove the casing of this Bluetooth speaker Never place this Bluetooth speaker on other electrical equipment Keep this Bluetooth speaker away from direct sunlight naked flames or heat To reduce the risk of fire or electric shock do not expose this apparatus to rain or moisture Ensure that you always have easy access to the power cord plug or adapter to disconnect this Bluetooth speaker from the power 2 Your Bluetooth Speaker Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your product at www philips com welcome What s in the box Short User Manual EN 4 Overview of the main unit oe 7 a pe Se ee OS T SOURCE T First Knob HOUR Select a source Bluetooth AUDIO IN e Adjust hour Press repeatedly to switch to standby mode Second Knob MINUTE SLEEP e Adjust minute 9 Third Knob CLOCK SET TIME SET AL1 Set sleep timer SET AL2 3 SNOOZE BRIGHTNESS Set clock Snooze alarm Set alarm Agjust display Brightness BUZZ SOUND 1 SOUND 2 O Display panel e Select an alarm source for Alarm 1 and e Show current information Alarm 2 i ALA o
4. AL2 L gt The alarm repeats ringing for the next day Snooze the alarm When alarm sounds press SNOOZE L gt The alarm snoozes and repeats ringing nine minutes later Set sleep timer Note e Make sure that the Third Knob switched to CLOCK before setting This Bluetooth speaker can switch to standby mode automatically after a preset period e Press SLEEP repeatedly to select the sleep timer period in minutes Ly When the sleep timer is activated zZ appears To deactivate the sleep timer e Press SLEEP repeatedly until OFF off appears 15 gt 30 gt 60 gt 90 gt 120 _ oFF Adjust display brightness SNOOZE BRIGHTNESS 7 Product information Note e Product information is subject to change without prior notice Specifications Amplifier Rated Output Power 5W RMS Bluetooth Bluetooth specification V3 0 EDR Supported profiles BP WAS ADAP Wil SP v1 2 Range 10 m Free space General information Power supply AC Power Battery Model ASSA36A 0901 60 Input 100 240 V 50 60Hz 0 6A Output 9 0V 1600 mA 2 x AA batteries Operation Power lt 15W Consumption Standby Power lt 1W Consumption Dimensions Main Unit W x H x D 195 29 BS nnn Weight Main Unit 0 70 kg 8 Troubleshooting WN Warning e Never remove the c
5. Always there to help you Register your product and get support at www philips com welcome Question Contact Philips AJT600 37 User manual PHILIPS Contents 1 Important safety instruction 3 2 Your Bluetooth Speaker 4 What s in the box 4 Overview of the main unit 5 3 Get started 6 Connect power 6 Set time 7 Turn on 7 4 Play from Bluetooth device Bluetooth reset 7 5 Play audio from an external device 8 6 Other features 8 Set alarm timer 8 Set sleep timer 9 Adjust display brightness 9 7 Product information 10 Specifications 10 8 Troubleshooting 10 9 Notice 11 Disposal of your old product 11 EN 1 D Important safety instruction Read these instructions Keep these instructions Heed all warnings Follow all instructions Do not use this apparatus near water Clean only with dry cloth Do not block any ventilation openings Install in accordance with the manufacturer s instructions Do not install near any heat sources such as radiators heat registers stoves or other apparatus including amplifiers that produce heat Protect the power cord from being walked on or pinched particularly at plugs convenience receptacles and the point where they exit from the apparatus Only use attachments accessories specified by the manufacturer Use only with the cart stand tripod bracket or table specified by the manufac
6. asing of this device To keep the warranty valid never try to repair he system yourself f you encounter problems when using this device check the following points before requesting service If the problem remains unsolved go to the Philips Web page www philips com support When you contact Philips make sure that the device is nearby and the model number and serial number are available No power e Ensure that the power cord is connected securely e Ensure that there is power at the power supply socket e Ensure that the batteries are installed correctly No response from the Bluetooth speaker Disconnect and reconnect the AC power plug then turn on the Bluetooth speaker again e Check if you have selected the correct audio source e Make sure that your Bluetooth device is within the effective operation range Alarm does not work Set the clock alarm correctly Clock alarm setting erased e Power has been interrupted or the power plug has been disconnected e Reset the clock alarm EN 10 9 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user s authority to operate the equipment Notice of compliance The device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions O This device may not cause harmful interference and Q This device
7. e local rules on the separate collection of electrical and electronic products and batteries The correct disposal of these products helps prevent potentially negative consequences on he environment and human health Your product contains batteries which cannot be disposed of with normal household waste Please inform yourself about the local rules on separate collection of batteries The correct disposal of batteries helps prevent potentially negative consequences on the environment and human health Please visit www recycle philips com for additional information on a recycling center in your area Environmental information All unnecessary packaging has been omitted We have tried to make the packaging easy to separate into three materials cardboard box polystyrene foam buffer and polyethylene bags protective foam sheet Your system consists of materials which can be recycled and reused if disassembled by a specialized company Please observe the local regulations regarding the disposal of packaging materials exhausted batteries and old equipment The making of unauthorized copies of copy protected material including computer programs files broadcasts and sound recordings may be an infringement of copyrights and constitute a criminal offence This equipment should not be used for such purposes Note e The type plate is located on the bottom of the apparatus PHILIPS Specifications are s
8. he Third Knob switched to CLOCK before setting The speaker can not pair with other Bluetooth devices in AUDIO IN mode You can listen to audio from an external device through this Bluetooth speaker 1 Connect an audio cable to e the AUDIO IN socket on the Bluetooth speaker e the headphone socket on an external device 2 Press SOURCE repeatedly to select the Audio in source L gt The 9 on the display panel lights up 3 Play audio on the external device refer to its user manual 6 Other features Set alarm timer You can set two alarms to ring at different time Note e Make sure that you have set the clock correctly d Rotate the Third Knob to SET AL1 or SET AL2 to activate alarm setting mode L gt The and time digits blink Rotate the First Knob to adjust the hour Rotate the Second Knob to adjust the minute Press OK on First Knob to confirm Rotate the Third Knob to CLOCK after setting VUA WN Select alarm source You can select buzzer sound 1 or sound 2 as your alarm sound rin Buzz M 2 EN 8 Activate deactivate alarm timer Note e Make sure that the Third Knob switched to CLOCK before setting Press AL1 AL2 to activate or deactivate the alarm timer L gt The appears if alarm timer is on and disappears if it is off To stop the ringing alarm press the corresponding AL1
9. must accept any interference received including interference that may cause undesired operation Notice for the USA This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged o try to correct the interference by one or more of the following measures e Relocate the receiving antenna e Increase the separation between equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help Disposal of your old product Your product is designed and manufactured with high quality materials and components which can be recycled and reused lever dispose of your product with other household waste Please inform yourself about th
10. turer or sold with the apparatus When a cart is used use caution when moving the cart apparatus combination to avoid injury from tip over IN A A Unplug this apparatus during lightning storms or when unused for long periods of time EN Refer all servicing to qualified service personnel Servicing is required when the apparatus has been damaged in any way such as power supply cord or plug is damaged liquid has been spilled or objects have fallen into the apparatus the apparatus has been exposed to rain or moisture does not operate normally or has been dropped Battery usage CAUTION To prevent battery leakage which may result in bodily injury property damage or damage to the unit e Install all batteries correctly and as marked on the unit Do not mix batteries old and new or carbon and alkaline etc e Remove batteries when the unit is not used for a long time e The battery battery or batteries installed shall not be exposed to excessive heat such as sunshine fire or he like Apparatus shall not be exposed to dripping or splashing Do not place any sources of danger on the apparatus e g liquid filled objects lighted candles This product may contain lead and mercury Disposal of these materials may be regulated due to environmental considerations For disposal or recycling information please contact your local authorities or the Electronic Industries Alliance www eiae
11. ubject to change without notice 2014 WOOX Innovations Limited All rights reserved This product was brought to the market by WOOX Innovations Limited or one of its affiliates further referred to in this document as WOOX Innovations and is the manufacturer of the product P amp F is the warrantor in relation to the product with which this booklet was packaged Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N V AJT600D_37_UM_V2 0
Download Pdf Manuals
Related Search