Kondator LC50
Contents
1. User Manual Before assembly please spend some time reading this and follow the procedures step by step Some panels are viewed differently from the detail drawing below This is for extra clarity Do not discard any of the packaging until you have checked all the parts and tools If you are missing any of the parts please contact your supplier Parts and Tools Check List amp 3 S x1 X1 X1 X1 X1 X1 x4 X1 X1 X1 X1 X1 Assembly Guide Step 1 Clamp Assembly Adhere the pad to the base of the clamp ao Fits desk thicknesses D ee 0 63 2 16 50 8mm then clamp the arm to the desk 2 36 50 8mm 63 1 4 16 36mm P o a eon Lower Attachment Position Upper Attachment Position Grommet assembly step 1 1 Use 4mm allen key to loosen the 3 screws then detach clamp mount from the arm Note Do not lose the screws as they will be used to attach the grommet mount o 1 4 36mm Grommet assembly step 1 2 rr Place the small metal grommet mount plate on the bottom of the arm then adhere the pad to protect the surface of the desk Attach the arm to the desk by positioning over the grommet hole The bolt should be visible und2. er the desk Secure the arm using the remaining parts as shown below Grommet hole diameter should be between 78 2 20130605 Step 2 Step 5 Remove the VESA plate by rs Slide the cable cover upward to allow pinching the grey plastic tab to room for cables to be placed inside release the lock then pull the plate upward to separate from the arm Route cables under arm then slide the cover back on Adjustment Place LCD monitor face down on a flat Use the Allen key provided to adjust the tension to surface Align the VESA plate holes with ss correspond to the weight of the monitor Twist the the holes on the back of the monitor Step 4 Allen key in a clockwise direction for heavier and attach using the screws provided Slide the monitor with VESA plate onto monitors counterclockwise for lighter monitors shown below the arm making sure it clicks securely into place Tension Adjustment Caution Support arm while adjusting tension Adjustment Use the Allen key provided to adjust the tension to correspond to the weight of the monitor Twist the Allen key in a clockwise direction for lighter monitors counterclockwise for heavier monitors Weight Capacity 6 6 17 6 Ibs 3 8kg eProducts loading capacities are based on monitor
3. s center of gravity less than 3cm from the end of the VESA interface eLoading capacity could be reduced if monitor size of greater than 26 inches or depth of greater than 5 5cm eAll products specifications in catalogues are subject to change without notice Use screwdriver to tighten the screw Fasten the screw to the bottom with 2 mm Allen key and then move backward one circle to have the limited 180 rotation if necessary
Download Pdf Manuals
Related Search