Home
Ices IBT-1
Contents
1. VOL UP PUSH AND HOLD TO CHANGE VOLUME SHORT PRESS FOR NEXT PREV WHAT THE LIGHTS MEAN A blinking red and blue light means the IBT 1 is ready to pair A blinking blue light means the IBT 1 is paired and connected and playing A steady blue light means the IBT 1 is paired and connected but not playing Asteady red light means the IBT 1 is charging but turned off battery should not be disposed of as general household waste in Europe To ensure the correct waste treatment of the product and battery please dispose them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries In so doing you will help to conserve natural resources and improve standards of environmental protection in treatment and disposal of electrical waste Waste Electrical and Electronic Equipment Directive X This symbol indicates that the relevant electrical product or Products with the CE marking comply with the EMC Directive 2004 108 EC C 0 f 0 0 and the Low Voltage Directive 2006 95 EC issued by the Commission of the European Community 10
2. ICES Bluetooth speaker IBT 1 User manual Cc 0700 amp lt Website http icessupport zendesk com The IBT 1 Bluetooth speaker can operate in Three different modes Bluetooth mode overrides all other modes To switch to other modes when connected via Bluetooth you must pause or end playback from your device Mode 1 Bluetooth PAIRING INSTRUCTIONS Turn your IBT 1 speaker on You will hear a beep The light will blink alternately blue and red This indicates that the IBT 1 is ready to pair TO PAIR TO AN ANDROID PHONE TO PAIR TO AN I PHONE OR IPAD Open Settings 1 Open Settings Open Wireless and Network 2 Turn Bluetooth on if it is off Open Bluetooth Settings 3 Touch and hold IBT 1 found under Turn Bluetooth on if it is off Devices it will be labeled Touch Search for Devices Not Paired Touch and hold IBT 1 4 Touch The word IBT 1 it will say Touch Connect Connected STN Gu bo pa CHARGING YOUR IBT 1 Your IBT 1 comes partially charged To charge the IBT 1 connect the USB cable to the speaker Connect the USB plug on the other end of the cable to any USB port This can be the USB port ona computer wall adaptor or car charger Once connected the IBT 1 will automatically charge A full charge takes approximately 2 hrs Partial charging will not affect the life of the battery Do not store the IBT 1 with a dead battery CHARGING WHILE PLAYING You can charge the IBT 1 and play audio at the sa
3. ICES offers service and warranty in accordance to European law which means that in case of repair both during and after the warranty period you should contact your local dealer Please note It is not possible to send products directly to ICES for repair Important note If this unit will be opened or accessed in any way by a non official service center the warranty expires immediately WHAT THE BUTTONS DO On off button This button turns the IBT 1 on Do not leave the IBT 1 on if not in use Pause Play Pauses or plays audio in every mode but Bluetooth use your phone Ipod etc to pause or play audio when in Bluetooth mode Volume up down Push and hold to increase or lower volume in all modes Push once to change tracks CHARGING PORT LINE IN SD SLOT CHARGING PORT INSERT MICRO SD CARD HERE Hereby STL Group BV Ankerkade 20 NL 5928 PL Venlo declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC The declaration of conformity may be consulted at https icessupport zendesk com forums 22810983 CE Documents This product operates at 2400 2483 5 MHz and is designated only to be used inside a normal household environment This product is suited for this purpose within all EU counties VOL DOWN PUSH AND HOLD WHAT THE BUTTONS DO TO CHANGE VOLUME SHORT PRESS FOR NEXT PREV PAUSE PLAY AUDIO IN EVERY MODE
4. IBT 1 speaker The double end of the 2 in cable has a3 5 mm headphone plug it can be inserted into any device with a corresponding 3 5 mm jack The audio signal will travel through this connection This symbol indicates that the relevant electricalproduct or battery should not be disposed of as general household waste inEurope To ensure the correct waste treatment of theproduct and battery please dispose them in accordance to any applicable locallaws of requirement for disposal of electrical equipment or batteries In sodoing you will help to conserve natural resources and improve standards ofenvironmental protection in treatment and disposal of electricalwaste WasteElectrical and Electronic Equipment Directive When you see a crossed out wheeled wastecontainer on the product It means that the product falls under the EU directive 2002 96 EC 3 5MM LINE IN CABLE NOT INCLUDED INSERT CARD HERE MICRO SD CARD MICRO SD CARD NOT INCLUDED USB CABLE INCLU DED Service and support For information http www ices electronics com For support http icessupport zendesk com ICES helpdesk Germany 0900 1520530 Local charges The Netherlands 0900 23553626 Local charges Ict P min Belgium 02 6200115 Local charges France 0170480005 Local charges The helpdesk is accessible from Monday to Friday from 9 AM till 6 PM In case your device needs repair our helpdesk will redirect you to your local dealer
5. me time CARE OF YOUR IBT 1 Do not let the IBT 1 come in contact with water Do not leave it in direct sunlight or other hot place Do not store your IBT 1 with a dead battery Clean with soft cloth Do not use harsh chemicals to clean Do not drop or place heavy objects onthe IBT 1 Never try to repair or open your IBT 1 yourself 1 Battery capacity 500 mA H 2 Frequency response 60 Hz 18Khz 3 THD lt 0 5 4 SNR gt 80dB 5 Size D 60mm H 58cm 6 Play time is approximately 4 hours TECHNICAL SPECIFICATIONS 1 Operating voltage 3 7V 2 Charging Voltage 5V 3 Output power 3W Speaker spec 40mm 4Q 3W 6 TO PAIR TOA MAC OS COMPUTER 1 Open System Preferences 2 Open Bluetooth 3 Click the button to adda Bluetooth device 4 Select IBT 1 5 Click Continue the computer will Pair with the device If asked The pass code is 0000 TO PAIR TO A WINDOWS OS COMPUTER Open Devices and printers Click Add a device Select IBT 1 or Bluetooth headset Click Next Input Pass code 0000 if necessary AbhwWwne Mode 2 Micro SD card Use a computer or Android phone to transfer music files to a micro SD card Note MP3 files work best Insert the Micro SD card directly into the slot on the IBT 1 labeled SD or TF It will click into place Your music will begin to play automatically Mode 3 Connect directly with supplied cable to audio device Plug the single end of the 2 in 1 cable mini USB plug into the
Download Pdf Manuals
Related Search
Related Contents
Surveillance “Bébé” sans fil 2.4 GHz FRVS 9 Manuel d`utilisation Samsung DVD-HD860 manual de utilizador PNL-tec BC-15 computer case Scanned Document - What is the Apple IIGS? CPV + CCV Ag Teste GUIDA DELL`UTENTE yCN『口f00 Princess 332951 vacuum cleaner Copyright © All rights reserved.
Failed to retrieve file