Timex T156
Contents
1. 2 To turn off the alarm without setting it for the following day switch the Mode Switch to Alarm OFF The Alarm ON Indicator Icon will disappear To operate the snooze feature press the Snooze Light Button The alarm will shut off approx nine minutes before sounding again You may repeat this several times during the one hour snooze cycle Demo Operation The Alarm Clock feature funny sound effects that can be set as alarm wake sounds or played as a demo The alarm instructions are in the Operating the Alarm section 1 Set the Mode Switch to Demo then press the Snooze Light Button Depending the setting of Volume Switch if it sets at HI both special sound and shaking effects will activate if it sets at LO only sound effects will activate Back Light Operation 1 Set the Mode Switch to Alarm ON or Alarm OFF then press the Snooze Light Button then the display back light will turn on for approx 30 seconds Ww Maintenance e Protect your furniture when placing the clock on natural wood or a lacquered wood finish A cloth or other protective material should be placed between the unit and the furniture e Clean the casing with a soft cloth moistened only with mild soap and water Stronger cleaning agents may damage the surface of the case e If the clock is not to be used for a prolonged period remove the batteries to prevent possible corrosion Should the battery compartment become corroded or dirty clean it thoro2. de Switch to Alarm ON to turn on the alarm The Alarm ON Indicator Icon will appear on the display showing that the alarm is turning on 2 Set the Volume Switch to Hi for louder alarm sound and shaking effect during alarm sounding Set to Low for lower alarm sound and no shaking effect Turning Off the Alarm 1 After the alarm sounds press the Alarm Set Reset Button to turn it off and automatically reset it for the same time the following day
3. equential damages so these restrictions may not apply to you This warranty gives you specific legal rights you may also have other rights which vary from state to state For questions or comments regarding this or other products please call our toll free number 1 800 888 4491 TIMEX and TIMEX Kids are registered trademarks of Timex Corporation the United States and other countries 7T156 041119 0 Printed in China Model 1156 Shake N Wake Alarm Clock For additional information online registration and exclusive special offers visit our website www timexaudio com For questions or comments regarding this or other products please call our toll free number 1 800 888 4491 Para instruccionese en Espanol llame al 1 800 888 4491 Important Message to Parents Thank you for purchasing one of the TIMEX brand s many top quality products We would appreciate it if you would take a few moments to read through these instructions This will help you explain the safe and proper way to use this product and to help give it the long lasting life that TIMEX branded products have been designed for Please keep these instructions for future reference as they contain important information Installing the Batteries j The Alarm Clock operates on 3 AA R6 batteries which are included is for demo purpose only To replace or install the batteries follow these instructions Install The Battery 1 The batte
4. he FWD Button to rapidly advance the time forward or the REV Button to rapidly change the time backward Release button when the approximate correct time is displayed PM Indicator is on the lower right of the display Time Button REV Button Volume Switch Mode Switch Alarm Set Reset Button FWD Button Front of Clock Note While pressing either FWD or REV Button the minutes will begin at a moderate pace then get faster This will assist you in setting the time both fast and exact 3 Press either the FWD or REV Button repeatedly until the correct time is displayed Setting Alarm Time 1 Press and hold the Alarm Set Reset Button for several seconds until the display flashes If no alarm set buttons are pressed within approx ten seconds the display will Stop flashing and return to normal mode 2 Press and hold the FWD Button to rapidly advance the alarm time forward or the REV Button to rapidly change the alarm time backward Release button when the approximate alarm time is displayed PM Indicator is on the lower right of the display Again be sure to set the proper AM or PM wake time as shown by PM Indicator 3 Press either the FWD or REV Button repeatedly until the desired alarm time is displayed 4 When the alarm time has been set press the Alarm Set Reset Button again to return to the default clock display Operating the Alarm Turning On the Alarm 1 After setting the alarm time set the Mo
5. lems encountered If service is still required 1 Remove batteries if applicable and pack the unit in a well padded heavy corrugated box 2 Enclose a photocopy of your sales receipt credit card statement or other proof of the date of purchase 3 Enclose a check or money order payable to the order of Soundesign for the sum of 3 00 or 6 00 if after the warranty period or without proof of purchase 4 Send the unit prepaid to the Factory Service Center listed below Consumer Repair Department SDI Technologies Inc Timex Audio Products Division 1401 Pullman Drive Suite A El Paso TX 79936 7726 NOTE This warranty is valid only if the product is used for the purpose for which it was designed It does not cover i products which have been damaged by negligence misuse or accident or which have been modified or repaired by unauthorized persons ii cracked or broken cabinets or units damaged by excessive heat iii damage to tape cassettes or compact discs if applicable iv the cost of shipping this product to the Consumer Repair Department and its return to the owner This warranty is valid only in the United States of America and does not extend to owners of the product subsequent to the original purchaser Any applicable implied warranties are also limited to 90 days and SDI Technologies will not be liable for consequential damages Some states do not allow limitations on implied warranties or exclusion of cons
6. ry compartment is located on the back of the cabinet Open the battery compartment door by screw driver then take out the battery box 2 Install 3 AA R6 batteries making sure that the positive and negative polarities match up with the diagram inside the battery box 3 Put back the battery box into battery compartment gently and in correct direction 4 Close the battery compartment door by screw driver Do not over tighten For the Best Possible Performance e We recommend using alkaline batteries e Non rechargeable batteries are not to be recharged e Rechargeable batteries are to be removed from the clock before being charged if removable e Different types of batteries or new and used batteries are not to be mixed e Only batteries of the same or equivalent type as recommended are to be used e Remove exhausted batteries from the clock e The supply terminals are not to be short circuited e Rechargeable batteries are only to be recharged under adult supervision if removable e Batteries are to be inserted with correct polarity Setting Clock Time and Alarm All of the clock and alarm functions are controlled using the buttons in the front of cabinet See graphic Setting Clock Time 1 Press and hold the Time Button for several seconds until the display flashes If no time set buttons are pressed within approx ten seconds the display will stop flashing and return to normal mode 2 Press and hold t
7. ughly and replace the batteries Questions or Comments For questions or comments regarding this or other SDI products please call our toll free number 1 800 888 4491 Please also visit our website www timexaudio com 90 Day Limited Warranty Informal Timex Audio Products a division of SDI Technologies Inc hereafter referred to as SDI Technologies warrants this product to be free from defects in workmanship and materials under normal use and conditions for a period of 90 days from the date of original purchase Should this product fail to function in a satisfactory manner it is best to first return it to the store where it was originally purchased Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period SDI Technologies will repair or at its discretion replace this product without charge except fora 3 00 charge for handling packing return UPS postage and insurance This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center listed below The product must include proof of purchase including date of purchase The fee for service after the warranty period or without proof of purchase is 6 00 Before returning this product for service please first replace the batteries if applicable with fresh ones as exhausted or defective batteries are the most common cause of prob
Download Pdf Manuals
Related Search