Koolance RAM-30-V06
Contents
1. El AANZE RAM 30 Installation Guide v1 0 CAUTION Koolance Hydra Pak Coolers are puncture resistant AN but not puncture proof To avoid rupturing your Hydra Pak Cooler it is recommended to carefully cover any excessively sharp areas for example solder points on your hardware with small pieces of foam or electrical tape 3rd party liquid cooling products are not generally supported by hardware manufacturers Installing a Koolance liquid cooling product is ultimately done at the user s own risk The RAM 30 will cool one or two DIMM memory sticks When cooling two the sticks must be in adjacent slots because the cooler will not expand any wider The RAM 30 features width adjustment which allows adequate contact pressure for the memory modules once installed Before installation the cooler should be extended to its maximum size To do this loosen both thumb screws and slide apart the moveable outer plate By design the RAM 30 cooler is not symmetrical The top hoses lean toward one side which should face away from the opposite memory banks when installed This provides room for additional memory sticks or a second RAM 30 liquid cooler The RAM 30 s mounting direction should face away from the opposite memory banks Your computer memory may come with a heat spreader If these are rivoted do not attempt to remove them Most will still fit within the cooler However if the heat spreader uses clip2. s and can be removed without damaging the memory then you may do so Heat Spreader Rivot When the RAM 30 liquid cooler is installed each DIMM memory stick should rest between two sheets of the Hydra Pak not between the Hydra Pak and the outer plate The mounting brackets on both ends of the RAM 30 cooler fit below the hinged DIMM latches With the RAM 30 cooler properly placed over the memory gently squeeze together the outer plates Tighten both RAM 30 thumb screws to hold the cooler and outer plates to the memory banks
Download Pdf Manuals
Related Search