Panasonic Bag-CAM Clips
Contents
1. CAMBER JOHNSON Very Well Connected INSTALLATION INSTRUCTIONS Product Revision Form 7120 0587 Rev A INST 577 NOTEPAD V amp NOTEPAD V LT E CAM CLIP CONVERSION KIT F unung APEU Eoy This kit contains the components needed to convert the Gamber Johnson Notepad V 7160 0250 and Notepad V LT 7160 0402 so that they can be used with smaller notebook and tablet format computers without the bulk of the Rear Support Brace The kit provides a depth adjustment of 7 2 8 1 inch when the Cam Mount Clip is installed facing inward and 8 1 9 inch when the Cam Mount Clip is installed facing outward The width adjustment 10 62 16 50 inch for Notepad V and 8 2 11 8 inch for Notepad V LT remain unchanged As does the height adjustment of 0 1 5 inch A 9 64 inch Hex Allen wrench will be needed for installation and adjustment If attached remove existing Rear Support Braces from back edge of cradle When finished cradle should appear as shown in Fig 1 Fig 1 Product Mounting Disclaimer Gamber Johnson is not liable under any theory of contract or tort law for any loss damage personal injury special incidental or consequential damages for personal injury or other damage of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application In order to safely install and use Gamber Johnson products full consideration of vehicle occu2. em in their slots Place the computer tablet on the cradle Slide the computer tablet tight against the Front Clips Keeping computer tablet in contact with Front Clips slide it to make contact with Side Clips mounted on fixed side of cradle Push lock side of cradle towards the fixed side until the Side Clips make contact with the computer tablet Turn the latch to secure computer tablet in cradle Make sure tabs on Side Clips are above computer tablet Fig 5 Adjust Front Clips side to side When in desired position secure by tightening adjustment screw Adjust Side Clips side to side and up down When in desired position secure by tightening adjustment screw Do not position Clips over vents or desired ports Adjustment Screw 10 Places 3 4 Slide Clip Guides side to side When in desired position secure by tightening adjustment screw Rotate Cam Clip until making contact with computer tablet When making contact in desired location secure by tightening adjustment screw Fig 6 4 4
3. pants vehicle systems i e the location of fuel lines brakes lines electrical drive train or other systems air bags and other safety equipment is required Gamber Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications and recommendations Gamber Johnson product instruction sheets or workmanship standards as endorsed through the Gamber Johnson Certified Installer Program Copyright 2012 Gamber Johnson LLC If you need assistance or have questions call Gamber Johnson at 1 800 456 6868 1 4 ASSEMBLY Install components of conversion kit as shown in Fig 2 Position Cam Mount Clips facing inward shown or outward based on depth adjustment range see page 1 needed for computer tablet When completed cradle should appear as shown in Fig 3 All screws should be loosely tightened to allow side to side movement of Clip Guides and rotation of Cam Clips Cam Clip l 8 x 625 SHCS Qty 2 Qty 2 Washer Qty 2 Cam Mount Clip Qty 2 Clip Guide Qty 2 Qty 4 Fig 3 2 4 5 16 External Tooth Lock 8 Flat Washer ADJUSTMENT If latch on the cradle is locked use key provided to unlock Pull the lock side of the cradle away from the fixed side to width needed to place computer tablet on top of cradle Fig 4 Loosen adjustment screws securing Front and Side Clips enough to raise them and move th
Download Pdf Manuals
Related Search