Gamber-Johnson MAX3 Visor Camera
Contents
1. 5 Position the camera and monitor as desired 6 Insert two and tighten all 10 32 socket head set screws to lock the Max knuckles in place Refer to figure 2 Figure 1 Secure Visor Mount with passenger side visor retainer Product Mounting Disclaimer Gamber Johnson is not liable under any theory of contract or tort aw for any loss damage personal inury special incidental or consequential damages for personal injury or other damage of any nature arising directly or indirectly asa result of the improper installation or use of its products in vehicle or any other application In order to safely install and use Gamber Johnson products full consideration of vehicle occupants vehicle systems i e the location of fuel lines brakes lines electrical drive train or other systems air bags and other safety equipment is required Gamber Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications and recommendations Gamber Johnson product instruction sheets or workmanship standards as endorsed through the Gamber Johnson Certified Installer Program copyright 2011 Gamber Johnson LLC If you need assistance or have questions call Gamber Johnson at 1 800 456 6868 Sheet 1 of 2 10 32 socket head set screw 2 X 1 4 20 x 50 socket button head cap screw 2 X 1 4 in lock washer 10 32 socket head aie 4 X 1 4 in nylon f2. CAMBER a gt ary Well Connected INSTALLATION INSTRUCTIONS Product Revision Form 7160 031 0312 7160 0373 Rev D INST 513 VISOR MOUNT 2 UNIT SINGLE SIDE ATTACHMENT Printing Spec PS 001 The Visor Mount 2 Unit Single Side Attachment provides the user with the capability to secure a mobile camera and a monitor to the passenger side visor Each system includes two Max all axis knuckles that allow the user to orient the monitor and camera in several positions In addition the system is equipped with two rubber pads and several mounting holes to ensure the camera and monitor are held secure and firm Tools Needed Material Needed 5 64 in Hex wrench Allen wrench 10 Self drilling screw 3 16 in Hex wrench Allen wrench 8 x 1 00 sheet metal screw for 2010 Charger Installation 1 Remove the passenger side visor retainer clip near the center of the vehicle Refer to figure 1 Secure the Visor Mount to the headliner using the visor retainer and two additional self tapping fasteners a Self tapping fasteners are not supplied b Caution Self tapping fasteners that are too long may go through roof of vehicle 3 Secure the camera to the front camera bracket using 2 20 x 50 socket button head cap screw 2 in lock washer and 4 in nylon flat washers Refer to figure 2 4 Secure the monitor to the monitor bracket using hardware supplied by monitor manufacturer Refer to figure 3 for hole patterns available
3. lat washer 1 29 32 11 2 Figure 2 Assemble camera with 1 4 in fasteners 15 16 O aA 1 11 32 Figure 3 Monitor bracket hole patterns Figure 4 Installed Visor Mount Sheet 2 of 2
Download Pdf Manuals
Related Search