Gamber-Johnson Support Brace - Long
Contents
1. GAMBE R JOHNSON Very Well Connected INSTALLATION INSTRUCTIONS Product Revision Form 7160 0230 POLE BRACE SHORT Rev A INST 460 7160 0231 POLE BRACE LONG 7160 0230 Pole Brace Short is for installations where a brace length in a range from 10 25 up to 16 25 is needed 7160 0231 Pole Brace Long can accommodate installations requiring a brace from 10 25 up to 35 25 inches Lengths less than 29 25 require cutting Assemble the brace Thread the collet nut on to the outer tube Do not tighten at this time Slide the inner tube into the outer POLE tube CL AMP Slide the Pole Clamp over the pedestal base tube paying attention which side will be most suitable for attaching the brace Insert the bolt provided through the hole in the flat end of the inner tube Insert the bolt through the clearance hole in the pinch clamp and screw it into the pole clamp Attach the INNER other end of the brace to the vehicle using customer supplied TUBE hardware The flat ends of the brace may be bent to fit your installation When positioning the short brace do not exceed a length of 16 25 It 1s recommended that the short brace tubes have 1 of overlap and so you cannot exceed 16 25 with the short brace COLLET NUT When fitting a Long Brace it may be necessary to cut the inner tube to a length suitable for your installation It is recommended on installations requiring the long brace2. nson LLC If you need assistance or have questions call Gamber Johnson at 1 800 456 6868
3. that the inner tube have 2 minimum of insertion into the outer tube and may have a maximum of approximately 6 With vehicle end of the brace located tighten the pole clamp in the desired location Preload the brace by pushing the top of the pedestal tube in a direction to extend the brace slightly 1 16 1 8 inch then tighten the collet nut Tighten the collet nut 1 3 to 1 2 turn from the point positive contact is felt DS 52 SHOWN SOLD SEPARATELY OUTER TUBE Product Mounting Disclaimer Gamber Johnson is not liable under any theory of contract or tort law for any loss damage personal injury special incidental or consequential damages for personal injury or other damage of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application In order to safely install and use Gamber Johnson products full consideration of vehicle occupants vehicle systems i e the location of fuel lines brakes lines electrical drive train or other systems air bags and other safety equipment is required Gamber Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications and recommendations Gamber Johnson product instruction sheets or workmanship standards as endorsed through the Gamber Johnson Certified Installer Program copyright 2009 Gamber Joh
Download Pdf Manuals
Related Search