Chief ERKD-16 rack accessory
Contents
1. Door Instruction Sheet for Elite Series Racks ERK 12 20 ERK 16 20 ERK 20 20 ECRR 12 20 ECRR 16 20 ECRR 20 20 Step 1 The rear door is a solid melamine door with a lock in it It is pre drilled for the 2 chrome hinges supplied The dish round portion of the hinge fits in the large round hole in the rear door and the 2 8 x 3 8 wood screws go into the appropriate pilot holes See Illustration 1 The other part of the hinge attaches to the inside of the rack at the rear Before you attach this section be sure to attach it to the correct side of the rack you can install it so that the door swings either way Locate the second hinge sections in the holes at the rear tap them into the holes lightly they can go in either direction then run the attached screws in You can put the door on later Next attach the lock catch the small L shaped bracket with 2 5 8 wood screws The front door is a smoked plexi glass door which mounts on either side again decide which direction works best for your location When you know which way you ll hinge the door mount the 2 brass door hinges on the inside of the front of the rack on the side you ve chosen Be sure to mount them so that the openings are facing each other so as to allow the door to fit between them Screw them in place with the same 10 x 5 8 wood screws that you used for the rack rail leaving the screw a bit loose until you get the door in place Slide the door betwee2. he gear in the rack orient the gear so that the spacing seems right then run all of the rack screws not supplied into the rails loosely at first then tighten after one more alignment check rear door Illustration 1 f front door 261 Buffalo Avenue Paterson N J 07503 Made with pride in the U S A
3. n the hinges then when it is all the way in lightly tighten the screws on the door with a straight screwdriver then tighten the hinge screws You should now stand the rack up and attach the rear door This is done by placing the hinge section from the door on top of the section in the rack and snapping the hinge together To remove the door simply pull on the release at the end of the hinge Next adjust the doors so that they swing and lock correctly The rear door has an adjustable hinge which allows for left and right alignment as well as in and out movement Just turn the adjustment screws to see which screw moves the door in the correct direction The front door should not require adjustment but you can tweek it a bit of needed You also may need to remove the front door until you get your gear in the rack To do this loosen the slotted screw on each hinge to release the door Step 2 The last thing to do is to carefully with carpet or something soft stand the rack upside down with the bottom facing up and screw on the casters You will see the 16 pilot holes they are merely guides as to where to place the casters and they only serve as a starting point for the wood screws to bite into the wood We suggest that the easiest method for installing the gear although it may not always be practical is to do this with the rack on its back with th rear door locked and the front door removed If you can carefully place t
Download Pdf Manuals
Related Search