Lenco CR-3301
Contents
1. Lenco DIGITAL ALARM CLOCK RADIO WITH TIME PROJECTOR CR 3301 INSTRUCTION MANUAL C 4 For information and support www lenco eu CR3301 LENCO FM ONLY ENG IM REVO1 1 3 10 2009 6 15 05 PM WARNINGS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION To reduce the risk of electric shock do not remove the cover There are no user serviceable parts inside the unit Refer all servicing to qualified personnel A The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of dangerous voltage inside the unit A The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product WARNING To reduce the risk of fire or electric shock do not expose this appliance to rain or moisture IMPORTANT DO NOT THROW BATTERIES IN FIRE THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING ENSURE A MINIMUM DISTANCE OF 5 CM AROUND THE APPARATUS FOR SUFFICIENT VENTILATION ENSURE THAT THE VENTILATION IS NOT IMPEDED BY COVERING THE VENTILATION OPENINGS WITH ITEMS SUCH AS NEWSPAPERS TABLE CLOTHS CURTAINS ETC DO NOT PLACE NAKED FLAME SOURCES SUCH AS LIGHTED CANDLES ON THE APPARATUS TAKE ATTENTION TO THE ENVIRONMENTAL ASPECTS OF BATTERY DISPOSAL USE THE APPARATUS ONLY IN MODERATE CLIMATES NOT IN TROPICAL CLIMATES DO NOT EXPOSE THE APPARATUS TO DRIPPING OR SPLASHING DO NOT PLACE O2. When the radio or buzzer sounds press the Snooze button to switch off the alarm Approximately 9 minutes later the alarm will switch on again This snooze cycle will be activated up to 5 times within an hour period To stop the snooze cycle slide the Function switch to OFF position or press Alarm set button SLEEP FUNCTION 1 To fall asleep while listening to music press the SNOOZE SLEEP button 2 To adjust the radio s sleep function to play from 90 60 30 to 15 minutes of music before shutting itself off automatically OFF sleep timer off 90 60 30 15 OFF Time projector This projector allows to project the clock time onto the ceiling or wall to view the clock time when a room is dark Turn on off the projector When the time projector is raised the projector will turn on automatically Raised down the projector will turn off automatically Adjust the visibility of the projector This time projector can be rotated forwards or backwards to project the time onto the ceiling or wall Once placed the projector in the desired position rotate the FOCUS dial to adjust the focus Note 1 The room must be dark 2 Although the time projector light intensity is low do not look at the lens of the time projector from where the time is projected ANTENNA The FM radio has a flexible wire antenna on the back side of the unit uncoil the wire and extend to its full length for best reception SPECIFICATIONS Power Source AC 2
3. 30V 50Hz DC 9V backup 1x006P Frequency range FM 87 5 108 MHz Power Consumption 4W Dimension 177 L x 119 D x 58 H mm Weight 0 57kg Due to continuing improvement the features and the design are subject to change without notice Where to place the item Today s furniture is coated with a wide variety of lacquers and synthetic coatings that are treated with an extensive range of cleaning products Therefore the possibility that some of these substances contain components that react adversely to the rubber feet of the item and soften them cannot be completely excluded The rubber feet of the appliance can cause discoloring to furniture surfaces If necessary place the appliance on a non slide surface should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority ys If at any time in the future you should need to dispose of this product please note that Waste electrical products or retailer for recycling advice Waste Electrical and Electronic Equipment Directive For information and support www lenco eu GB 3 CR3301 LENCO FM ONLY ENG IM REV04 4 3 10 2009 6 15 06 PM
4. BJECTS FILLED WITH LIQUIDS SUCH AS VASES ON THE APPARATUS BATTERY SHALL NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS SUNSHINE FIRE OR THE LIKE THE MARKING INFORMATION IS LOCATED AT THE BOTTOM OF APPARATUS The mains plug shall remain readily operable In case of malfunction due to electrostatic discharge the apparatus has to be reset by disconnecting it from mains supply GB 1 CR3301 LENCO FM ONLY ENG IM REV02 2 3 10 2009 6 15 05 PM Hy F 8 s peos oooo0oo0oo000 EEAS Po oooooo0oo0o000000 oooooo oO CMD o o o o 500 000 0 0 0 0 0 006 0 0 0 00 doo eow ooo oooocoo poooo ooo So Ses se oe ooooopooo LOCATIONS OF PARTS AND CONTROLS 000000000000000000000 08000000000000009000000 0 070 0 0 0 0 0 0 0 0 0 00 0 0 0 0 0 0 0 0 00 e000000000000000000000000 1 LED display 10 Hour button 2 Alarm Indicator 11 Minute button 3 Time Projector 12 Standby button 4 Time Projector Lens 13 Snooze Sleep button 5 Focus Control 14 Volume control 6 Dial scale 15 Tuning control 7 Battery compartment 16 Function switch 8 Alarm set button 17 Wire Antenna 9 Time set button 18 230V power supply cable POWER SUPPLY i opeanet This unit is designed to operate from AC230 50Hz household mains supply The 9V type 1x006p battery is used for clock back up only Note When inserted a back up battery the unit will conserve the settings during power out
5. age the disconnect device shall remain readily operable LISTEN TO THE RADIO 1 Press the Standby button 2 Adjust the Volume Control into the desired listening level and select your favourite station with the Tuning Control 3 To turn off the radio press the d Standby button again TO SET THE TIME 1 Press and hold the Time set button 2 Press the Hour button to set hours 3 Press the Minute button to set minutes 4 Release the Time set button The correct time is shown on the display TO SET THE ALARM 1 Press and hold the Alarm set button while repeating step 2 and 3 described under TO SET THE TIME to set the desired wake up time 2 To check the correct alarm time press the Alarm set button GB 2 CR3301 LENCO FM ONLY ENG IM REVO3 3 3 10 2009 6 15 06 PM USING THE RADIO BUZZER ALARM Set the alarm as shown in TO SET THE ALARM Follow the procedure in LISTEN TO THE RADIO to tune the desired station Set the Volume Control to your required listening level Slide the Function Switch to AUTO position The radio will turn on to wake you up at the preset time To wake to the buzzer instead of the radio set the alarm as shown in TO SET THE ALARM Slide the Function Switch to BUZZER position The buzzer will turn on to wake you up at the preset time 6 To turn off the radio or buzzer slide the Function Switch to OFF position or press the Alarm set button SNOOZE FUNCTION akoON gt gt
Download Pdf Manuals
Related Search